General steps of toilet tank installation, toilet tank water pipe installation method

Step 1. Before the toilet is installed, the sewage pipe should be fully inspected to see if there is any mud, sand, waste paper and other debris in the pipe.

At the same time, it should also be checked whether the ground of the toilet installation position is horizontal, and if the ground is found to be uneven, the ground should be leveled.

Step two. Flip the toilet bowl over and center it on the toilet drain.

At the same time, draw a cross centerline, which should extend to the bottom of the toilet bowl around the feet.

Step 3. Install the toilet bowl horizontally by aligning the reticle on the toilet bowl with the ground drain outlet.

At the same time, press the sealing ring tightly and install the anchor screws and decorative caps.

Step 4. Install a special sealing ring on the toilet drain.

Step five. Drain the water for 3-5 minutes to rinse the pipes to ensure the cleanliness of the water pipes.

Then install the angle valve and connecting hose.

Then connect the hose with the installed tank fitting inlet valve and press the water source.

Step 6. Check whether the water inlet valve is properly inlet and sealed.

Check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and whether there is leakage to install the filter device of the inlet valve.

The installation of toilet tank pipes is an important problem when renovating or replacing toilets at home. Proper installation of the toilet tank plumbing is very important for both the use and cleaning of the toilet. Here's how to install the toilet tank pipe:

1.Choose the appropriate size of water pipe.

When installing a toilet tank plumbing, you need to choose the right hose according to the specifications of the hose and the size of the toilet. There are generally two different sizes of water pipes: 1 2 inches and 3 8 inches, and the difference between these two types of water pipes is only the diameter of the pipe.

The length of the water pipe should be chosen according to the distance between the toilet bowl and the tank.

2.Prepare the necessary old acres installation tools.

When installing the toilet tank plumbing, you need to prepare the necessary installation tools. A wrench and a pair of flat-nose pliers are usually required to install the water pipes, but other tools can be prepared.

3.Install the toilet tank plumbing.

First of all, you need to find the water pipe hole that fits the water tank under the water tank, insert the water pipe into the hole, and then screw the socket tightly. Be careful not to over-tighten so as not to damage the plastic tank.

Secondly, inserting the hose at the other end into the lower part of the toilet bowl also needs to be screwed down to ensure a seal. Finally, confirm whether the water pipe connection is tight and there is no water leakage, adjust the appropriate water level height, and test whether the water flow is normal.

4.Precautions.

When installing a toilet tank plumbing, you need to pay attention to the following points:

1) Before installing the water pipe, make sure that all the sealing gaskets and rubber gaskets have been installed.

2) When installing the water pipe, it is necessary to ensure that the water pipe is in a vertical state, so as not to produce bubbles and affect the water flow.

3) When tightening the interface, you need to pay attention to the strength, excessive tightening is easy to damage the water tank and gasket.

In short, the correct installation of the toilet tank water service Naisen pipe can effectively prevent water leakage and abnormal water level of the water tank, and can also make the toilet more safe and hygienic in daily use. The above is the installation method of the toilet tank water pipe, I hope to help you install the toilet tank water pipe correctly.