-
1. Cut the paper into long strips of paper about 2 cm wide, then knot the strips of paper at one end, and pull them tightly to form the model above.
2. Put it horizontally.
3. Fold this long strip of paper in half along the model.
4. After folding in half, stuff the paper at the end into the paper strip and fix it.
5. Finally, use a bank card or ** card to squeeze the midpoint of each side into it, so that it becomes a three-dimensional shape, so that it is folded.
Handicraft can brighten up life, and it makes our obscure life more interesting. Every day, we provide a lot of DIY step tutorials for those who love handmade meat, and warmly welcome those who love handmade to share your good experience! The following is a special sharing for everyone who has a life, the folding method of three-dimensional paper stars, and small stars.
Folded charts and other ** tutorials, creative experts take a look together! If you like paper stars, you might as well come and learn the happiness that beautiful ideas bring to everyone.
-
There are many ways to fold long paper stars, due to space limitations, here are two common folding methods listed as follows:
Fold method 1: Prepare two strips of paper, the width should not be greater than two centimeters, and not too narrow.
Both are folded in half.
Fold out a corner.
Fold the two ends of the two into it.
It's that long. Fold back.
Flip back. Flip a few more.
Flip to the fifth.
Flip it like this, and keep flipping it.
When there's still a little bit left to flip, fold inward.
Keep folding inward.
Cute five-pointed star origami finish. In the process of origami, it is necessary to figure out whether the top is the first to turn or the bottom first.
Fold method 2: Step 2, fold the small triangle.
Step 3: Continue to fold.
Step 4: Or a triangle.
Step 5: Cut it out.
Step 6: Embed a corner. Pay attention to the effect after embedding.
Step 7: Make a mark.
Step 8: Cut it out. At this point, the star paper origami heart shape is completed.
It will be better to put the star paper origami heart shape into the wishing bottle.
-
The 100 folds of long paper stars are as follows:
1.Tie a knot at one end of the slip of paper (one end is bent and folded over first).
2.The strip of paper below is threaded through the middle of the hole, then tightened, and a model of a star comes out.
3.The extra end of the less slip of paper folds in the direction of the star.
The stars are introduced as follows:
Stars refer to celestial bodies in the universe that are visible to the naked eye. The activity of the energy inside the star makes the star irregularly shaped. Stars can be broadly divided into planets, stars, comets, white dwarfs, etc.
The brightness of a star is often expressed in terms of magnitude. The brighter the star, the smaller the magnitude. The brightest planet is Venus, the fastest star orbiting at more than 240 kilometers per hour, and h1504+65 is the hottest white dwarf.
Comets, like Halley's Comet, the light we see is caused by the tail of the comet whose material is melted away as it passes through the solar system, so the closed comet we see tends to drag a long tail. Most of the stars that can be seen at night are stars, and there are a few planets in our solar system, such as Venus, Mercury, and Mars.
Stars emit light on a similar principle to our sun.
Most of it is the process of hydrogen fusion into a helium nucleus that releases energy, and some of it is the energy released by helium fusion. It's just because they're so far away from us that they look like gentle little stars, but in fact they're much bigger than the sun. The planets look bright because they reflect the light of the sun, but they are stained with the light that is close to us, and they look as if they are brighter than the stars.
The Sun, which looks as big as the Moon in the sky, has a diameter of 10,000 kilometers and a volume about 1.3 million times that of the Earth. Coincidentally, the diameter of the sun is about 400 times that of the moon, but it is also about 400 times farther from the earth than the moon, so it looks about the same size.
As a satellite, the Moon is the largest of the 66 moons that have been discovered in the solar system. There are only four or five moons larger than the moon, among which Ganyliste, the largest in diameter, has a diameter of more than 5,200 kilometers. Most of the others are only a few tens to hundreds of kilometers away.
-
Here are 100 folds of long paper stars:1First, fold the long strips of paper in half, then, fold them in line and finally fold them into a diamond shape.
2.Fold the top and bottom sides of the rhombus in opposite directions, then fold them outward, fold the corners inward, and finally fold the middle sides of the rhombus outward. 3.
Fold the diamond into a square, fold the top and bottom sides of the square outward, then fold the square in half along the centerline, and fold the sides of the square outward. 4.Fold the square into a triangle, fold the top and bottom sides of the triangle outward, then fold the triangle in half along the center line, and fold the sides of the triangle outward.
5.Fold the triangle into two rectangles, fold the top and bottom sides of the rectangle outward, then fold the rectangle in half along the centerline, and fold the sides of the rectangle outward. 6.
Fold the rectangle into a diamond, fold the top and bottom sides of the diamond outward, then fold the diamond in half along the centerline, and fold the sides of the diamond outward. 7.Fold the diamond into a square, fold the top and bottom sides of the square outward, then fold the square in half along the centerline, and fold the sides of the square outward.
8.Fold the square into a triangle, fold the top and bottom sides of the triangle outward, then fold the triangle in half along the center line, and fold the two sides of the triangle outward with your hands. And so on, all the way to the 100th finger dust folding method.
-
Origami is a fun craft activity that can be made into a wide variety of shapes through different folding methods. Here are some common origami star folding:
1.Pentagram folding: Using a long strip of paper, fold the strip of paper in half once, and then fold both sides in half to align with the middle fold line to form a triangle.
Then from the bottom, the strips of paper are folded in half until all the creases are folded according to the pattern, and finally fixed to form the shape of a five-pointed star.
2.Hexagram folding: Using long strips of paper, fold the strips of paper into a ring, then fold the strips of paper on both sides of the ring in half, and then fold the six triangles along the creases to form the shape of a six-pointed star.
3.Octagram folding: Using a long strip of paper, fold the strip of paper in half once, and then align the two sides of the fold line to form a triangle. Then fold the strips of paper in half from the bottom until all the creases are folded according to the pattern, and finally fix them to form the shape of an eight-pointed star.
4.Ten-pointed star folding: Using long strips of paper, fold the strips of paper in half to form a small rectangle, and then align the ends of the folded line to form a triangle.
Then the strips of paper are folded in half from the bottom until all the creases are folded according to the pattern, and finally fixed to form the shape of a ten-pointed star.
These are just a few examples of how to fold and you can actually design more different shapes of paper stars according to your creativity and imagination. Of course, it takes patience and care to fold beautiful paper stars, and it is recommended to search for tutorials on the Internet for more detailed folding steps and diagrams. Have fun!
-
The 100 folds of star paper are as follows:First, the folding method of folding stars.
1. Prepare the star paper.
2. Pick up a knot at the end, and the method seems to tie a scarf.
3. Organize the beginning.
4. Pick up the paper strip and fold it in half along the prototype.
5. Fold it until there is not much left of the note.
6. At the end of the part, insert the remaining part into the gap and pinch the horns of the stars with your thumb and index finger.
Second, the method of breaking the heart.
1. Put the lower three shapes into the seam of the lower corner.
2. Fold the triangle to the right first.
3. Fold the triangle down.
4. Fold the triangle to the left.
5. Fold the triangle down.
6. Repeat the previous steps all the time.
7. After folding down, cut off the excess part.
8. Insert the bottom triangle into the west seam between the bottom triangles.
9. Round the left and right corners.
10. Finally, press down the middle, and push the left and right sides to the middle to form a heart shape.
3. How to fold roses.
1. Fold the corner behind the star paper to the front of the acorn spike.
2. Turn the corner beam of the star paper around and let the star paper wrap around the sharpest corner.
3. Fold the remaining star paper backwards, paying attention to make sure that there is a flat place at the sharpest corner, and the length of the slope of the triangle is about.
4. Continue to repeat the third step, and then continue to fold according to the third step.
5. Cut out the excess of the star paper and leave only the triangle.
6. Start from the beginning, roll up the paper little by little, pay attention to the thickness at the top and thin at the bottom.
7. Roll up all the remaining star paper.
8. Fix it with adhesive strips, press down the center of the rose flower with your fingers, and adjust the rose petals.
-
Teach you 3 common ways to fold star paper, they are fish-shaped star paper, cute stars, and beautiful birds.
Fish-shaped star paper.
Fold out the basic shape of the star.
Take four identical pieces of star paper and place two of them on top of each other, pressing the third on top of the second and the fourth on top of the third.
Fold out the edges of the stars.
Then fold the second one down along the edge line, fold the first one down the same side line, then fold the third one down along the edge line, and then fold the fourth cigarette side downward, and so on, adjust the neatness of the edge.
Tidy up the excess and draw the eyes.
Then turn it over and cut off the excess with scissors, and finally draw the eyes, so that a fish-shaped star paper is ready to be called.
Lovely stars.
Fold out the basic shape of the star.
Take a square piece of colored paper and fold it diagonally, and the other end is also folded in half to form an impression, and then fold the right angle to the intersection point, and the acute angle to the intersection point to align and fold in half.
Fold out the details of the stars.
The other end takes the intersection of the long side as the reference point, folds it in half to the intersection point on the other side of the mountain, and then completes the other acute angle.
Organize the excess.
Fold it along the middle line, cut off the excess with scissors, and at the end, lightly, there is a lovely star.
Nice birds. Fold out the basic shape of the bird.
Take two long star paper and four short star paper, glue one end of the long star paper with double-sided tape, tear off the adhesive film, paste a short piece of star paper on the part just glued, and then paste a short piece of star paper on the top of the star paper just now, and dip the bottom with double-sided tape.
Fold out the basic details of the bird.
Then bend the star paper, glue it to it, then paste the double-sided tape, then bend the second piece of star paper and paste it on it, paste the double-sided tape again, bend and paste the longest star paper on it, cut off the excess with scissors, the other three sheets, and repeat the operation for the first time. Then take a rectangular piece of colored paper and fold it diagonally in half, fold the crease, and fold the adjacent edge in half along the middle line.
Tidy up the bird's tail.
The other end is also folded in half to the middle line, forming a diamond shape, one of the corners is folded upward, folded inward along the middle line, the longer corner is folded upward, and then folded down to form the appearance of the bird's head, and finally the tail of the bird is stained with double-sided tape, and the star paper that has just been made is pasted on the tail of the bird, and a beautiful bird is completed.
-
The fold of the paper star is as follows:Tools: A4 color paper, scissors.
1. First of all, you should cut the A4 color printing paper into long strips, and divide a piece of A4 paper into 16 sheets.
5. After tightening, flatten and adjust, and then press the midpoint of the five sides of the five-pointed star inside, pay attention to press gently, and after pressing all the five sides, it will become a three-dimensional five-pointed star. As shown in Fig.
-
The fold of the paper stars is as follows: Pai1. Fold the square paper in half along the 2 center lines and open it, fold the right side to the left, and the vertices at the green frame are about centimeters larger than the center line.
2. Fold the left side to the right side and open it, then fold the upper edge of the left side by centimeters.
3. Fold the left side back to the right side, and then fold back the top two-thirds of the sharp corner, and then turn back to one-third of the three buckets of rubber.
4. The left side is also folded to the right side and then part of it back.
5. Fold the right side to the left and then fold back to a part of the empty envy, press the corners of the fold against each other, and then turn over the origami, and the stars will be folded.
I make the bottom type tension state. (The tensile performance of paper is better). The compressed part is made of paper rod structure. >>>More
You can refer to 58.com recruitment,
If this happens, it is likely that there is a problem with the printer's paper transmission structure, or it may be that the paper is not properly placed. Normally, there is a photoelectric sensor at the printer paper slot, the photoelectric sensor can keenly "capture" whether the paper is correctly placed in the paper feed slot, if there is printing paper in the paper feed slot, the photoelectric sensor can identify the paper, and generate an identification signal to transmit to the printer, notify the printer to do the printing preparation, even if the paper is not put in the paper feed slot, the photoelectric sensor will also have a control signal transmitted to the printer, tell the printer that there is no printing task temporarily. According to the above feeding principle, it is not difficult for you to know why there is printing paper in the paper feed slot, but the printer prompts that there is no paper; If the photoelectric sensor is covered with dust, it will reduce its ability to recognize the paper, so that even if the paper has been inserted into the paper slot, the photoelectric sensor will not recognize it correctly, so the above strange phenomenon occurs. >>>More
The wear of the dryer shaft can be repaired according to the situation of the shaft, and the process is not the same, which can be roughly divided into two kinds: one is the tooling repair process, and the other is the standard model ruler process. >>>More
Vegetables with leaves: spinach, leeks, cauliflower, broccoli, cabbage, cabbage, celery, greens, peppers, celery, fungus, leeks, garlic moss, rape, lettuce, garlic sprouts, cress, chrysanthemum, mustard greens, rape, bean sprouts, baby greens, purple cabbage, baby cabbage, baby cabbage, water spinach,Sweet potato leaves, dragon's mustache. >>>More