-
The construction of the waterproof layer of the gutter and the eaves should first do a good job of additional reinforcement layer If asphalt-based waterproofing membrane is used, an additional membrane should be paved; If polymer modified asphalt waterproofing membrane or synthetic polymer waterproofing membrane is used, it is advisable to use a waterproof coating reinforcement layer with the same material properties.
-
In the process of pouring the floor slab of the rural self-built house, after the floor is poured, the gutter waterproofing is installed with a square strip or formwork, and a waterproof edge with a height of about 10 cm is poured with concrete.
-
The waterproofing of the gutter is very important, and when doing the waterproofing of the gutter, it is necessary to pay attention to the waterproof coating on both sides of the gutter and lay the waterproof membrane. Finally, the water leakage treatment is carried out.
-
The roof is a sloping roof with a gutter around it, which collects the water flowing down from the roof tiles into the gutter, and then flows through the gutter to the drainage outlet, and finally discharges to the storm water pipe.
-
First do the first waterproofing layer:
Laying a flexible waterproof layer, you can choose paint or membrane. Its construction conditions require that the moisture content of the base surface is not more than 9%, so it is suitable for construction in the summer after the hot weather and 5 consecutive sunny days. After completion, a water storage experiment should be carried out.
For example, to do paint waterproofing, take one cloth and two coatings as an example: after cleaning the base layer, brush the paint again, dry the film, lay a layer of glass fiber cloth carcass reinforcement material, and brush a layer of paint on the flattened surface to fix, and carry out the next coating construction after drying. The total thickness of the waterproof coating film should be more than 3 mm.
For example, after the construction of the waterproof membrane, after cleaning the base layer, brush the adhesive on the reverse side of the membrane and the base layer, paste and roll according to the elastic baseline from far and near, and finally check the seam end.
-
For people who live on the top floor or bungalow, they are no strangers to roof gutter waterproofing, once the gutter waterproofing is not done, it will bring great inconvenience to life, especially on rainy days, Zhihu long-term water leakage will form a "water curtain hole". Then the following is a brief introduction to some practices of gutter waterproofing.
1. The big reason for the roof leakage is that there is a problem with the original waterproof layer, so the original waterproof layer must be removed first. The second is to replace it regularly, so as to avoid the appearance of water leakage.
2. Clean up the grassroots level. When cleaning the base layer, it is necessary to clean all the foreign bodies, dust and debris on the surface of the base layer, especially in the shaded corners, which need to be carefully cleaned. After cleaning the base layer, it can be better coated with a new waterproof layer.
Although it may seem like a simple clean-up, it is actually a very important step.
3. Brush the waterproof layer. When coating the waterproof layer, it should be uniform, there can be no omission, and it is necessary to pay attention to the fact that the undried coating layer can not be polluted during the application process, so that the waterproof layer can be used for a longer time.
4. Apply the waterproof layer for the second time. Apply in the same way as the layer. It is also important to note that the waterproof material must not be irrigated until it has dried.
5. Check and accept, wait until the waterproof layer is completely dry, rinse the waterproof layer with water to see if there will be rain leakage.
After these five steps, the gutter waterproofing is complete. These seemingly inconsequential little acquaintances are still very important when they encounter difficulties!
When washing clothes, put it in a basin first, pour laundry detergent and soak it for a few minutes, and then rub it to quickly wash off some stains, and then put some dish soap or something strong to wash it off for some oil stains.
The practice of waterproofing the bathroom is:
1. Brush the waterproof paint for the first time. Before construction, ensure that the construction site is clean and dry, and the waterproof coating should be coated with no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off. >>>More
Especially at the upper and lower plumbing power supply, whether it is smoothing cement mortar, or making waterproof coatings, and pasting tiles behind, the construction is difficult and time-consuming. The base layer should be clean, the adhesion of the cement mortar base will be good, and if you knock off the original floor, the base layer will be uneven, and it is not recommended to choose polyurethane waterproofing, although the waterproof performance is very good, but for the later residence, the tile is prone to hollowing and falling off. >>>More
Generally depends on what kind of physique you are suitable for, some soups are delicious but not necessarily suitable for you, some soups are very appealing on the surface but the most important thing is to be realistic. Autumn is generally suitable for the tonic season, suitable for some warm diet, and don't make up too much, if it is a hot and dry physique, it will become dry mouth and stomach fire. Generally, you can choose beef, mutton, and black chicken, and the accessories depend on your own taste. >>>More
Carrots, which enjoy the reputation of "little ginseng", not only have high nutritional value, but also have many health benefits. There are many ways to eat carrots, but how to eat them the most nutritious? The most important nutrient in carrots is carotene, which is an indispensable nutrient for maintaining human health, protecting eyesight, moisturizing**, improving immunity, etc. >>>More