How to clean the cracks of the wooden floor, how to clean the gaps of the wooden floor

1. Vacuum cleaner.

To clean wooden floors, it is essential to vacuum and dust them first! We can equip the vacuum cleaner with a small nozzle or crevice nozzle so that the crevice dust can be cleaned better.

Second, cotton dragging.

After vacuuming, wipe it with a rubber wool mop. When mopping the floor, in order to better achieve the cleaning effect, try to use a professional wood floor cleaner mixed with water for cleaning, instead of using water directly.

3. Hair dryer.

The right amount of wind blows against the gaps in the floor, and debris and dust will be blown out. Then, wipe it clean with a rag.

Fourth, the electric iron.

Alternatively, an electric iron can be used to allow the bacteria to evaporate. Prepare a wet towel, try to wring it until you can't wring out the water, turn the iron on the electric heat, and then iron the floor with the highest steam setting through the towel. Because the high temperature of the steam kills bacteria instantly, the dirt is wiped off after ironing.

5. Floor wax.

Once you've removed the dirt from the crevices of the wooden floor, don't forget to wax the floor. Before waxing, wipe the wooden floor with a wringed out rag, especially in the crevices, and do not leave detergent. In addition, to avoid whitening, it is necessary to wait until the floor is completely dry before starting waxing.

The floor wax should be stirred evenly first, fully soaked in a clean rag, and finally waxed the wooden floor with a thin and uniform thickness.

Over time, the gaps in the wooden floor will become more and more obvious, and these gaps tend to accumulate dust and dirt, which can affect the beauty and hygiene of the floor. Here are some effective ways to clean the crevices of your wooden floor to keep your floor in good condition.

1.Use a vacuum cleaner.

A vacuum cleaner is one of the easiest ways to clean the cracks of a wooden floor. Most vacuum cleaners are equipped with a small nozzle that can suck out dust and dirt from the crevices. Using a vacuum cleaner can help clean the crevices of the wooden floor regularly to avoid the accumulation of dust and dirt.

2.Use a soft brush.

In addition to vacuuming, you can also use a soft brush to clean the crevices of wooden floors. Choose a soft, gentle brush and use warm water and an appropriate amount of soap to clean the crevices of the floor. Under low water pressure, gently scrub the crevices with a brush and dry them with a clean towel.

3.Use a mop.

For stains that are more difficult to clean or stubborn dirt, you can use a mop to clean the crevices of the wooden floor. Use warm water and an appropriate amount of soap to wash the floor crevices and gently wipe them with a mop. Make sure to reduce moisture to avoid moisture on your wooden floor.

4.Use a professional cleansing pre-dermatom.

For some stubborn stains, deep cleaning, or maintenance of wooden floors, consider using a professional wood floor crevice cleaner. These products are specially designed to clean crevices in the floor, which can achieve better cleaning results and have no damage to the wooden floor.

In conclusion, in order to maintain the hygiene and beauty of wooden floors, it is necessary to clean the crevices. Using the above methods can help reduce the accumulation of dirt and extend the life of your wooden floor. However, it is important to note that cleaners and tools need to be tested before cleaning to ensure that they do not cause damage to the wooden floor.

<> cleanup method:

1. According to the material of the floor, choose the appropriate floor cleaner, before use, according to the degree of dirt, pour the appropriate amount of floor cleaner into the bucket to dilute, and then mop the mop from the room to the direction of the door. Note that the mop should not drip and must be wrung out to avoid causing the wooden floor to absorb water and deform and expand.

2. If it is a corner or floor crack and other places that are not easy to clean, you can use an old toothbrush to directly dip the floor cleaner to scrub the hard-to-wash stubborn dirt, or you can directly pour the floor cleaner on the rag, wipe it, and then wipe it with a semi-dry rag.

3. However, some floor cleaners have a high concentration of surfactants, and after mopping the floor, the semi-wet floor is more likely to be contaminated with dust, and the result is more and more dirty, so special attention should be paid to choosing products with good reputation.

Cleaning Tips:

1.Use a rag dipped in rice water to wipe directly on the floor, or spray rice water evenly on the wooden floor (not too much), wipe with a dry rag for 5 minutes, and you will achieve quite satisfactory cleaning results;

2.Cleaning of special stains:

1) Types of stains: juice, milk stains, wine, etc.

Removal method: Dip a soft rag in a small amount of warm water and wipe gently.

2) Smudge type: lipstick, charcoal, shoe polish, nail polish, smoke stains, etc.

Removal method: Dip a soft rag with a little alcohol and wipe it gently.

3) Smudge type: wax and chewing gum.

Removal method: After hardening, gently shave with a blunt scraper.

During the use of wooden flooring, there are often cracks, gaps and other problems. This not only affects the aesthetics of the wooden floor, but also worries about dust and other debris getting into the crevices, making it more difficult to clean. Therefore, it is very necessary to deal with the gaps in the wooden floor.

Generally speaking, the treatment of gaps in wooden flooring is as follows:

1.Caulking: Use a special caulk for wood floors to fill in the gaps. Caulk can ensure a smooth surface after caulking, and it is also resistant to UV rays, abrasion, water and mildew.

2.Digging a gap: Dig a layer of the gap and refill it with a wooden board. This method can not only fill the gaps, but also ensure that the color of the original wooden floor is consistent with the color and base material of the original wood floor after filling, and will not affect the aesthetics.

3.Waxing: Waxing the wooden floor can lubricate the surface of the floor, reduce the breakage and cracks of the gaps, and effectively prevent dust from entering the crevices.

4.Replace the panels: If the gap is large or the floor is badly damaged, you can consider replacing the panels again.

It should be noted that before dealing with the gaps in the wooden floor, it is necessary to do a sufficient cleaning job to clean the gaps and the surrounding ground so that the gaps can be better caulked and repaired. At the same time, in daily use, it is also necessary to pay attention to the regular maintenance and cleaning of the wooden floor to avoid problems such as cracks and cracks.

Now many families like to lay wooden floors when decorating, because the decoration grade is higher, and wooden floors also have many advantages, but there is a shortcoming that can not be ignored, after a long time, it is easy to drill dirt into the cracks of the wooden floor, and it will become more and more dirty. So what should I do if the gaps in the wooden floor are dirty? Is there anything I can do to prevent stains from burrowing into the crevices?

1. How to clean the cracks of the wooden floor when it is dark.

1. The first step is to get out the dirt in the gaps, you can use a vacuum cleaner, replace it with a small nozzle, or have a professional crevice suction nozzle, which can go deep into the crevices to clean up the dust.

2. The next step is to prepare a rag, at the same time prepare baking soda and white vinegar, mix the two evenly, wet the rag, and then carefully clean the gaps with the rag.

3. Step 3, after it is dry, we wipe it again with a dry rag, and we will find that the original black gap has turned white. Mainly because baking soda has a very strong stain removal ability, it can quickly dissolve stains, and the cleaning ability is very good.

Second, how to prevent the tile gaps from becoming dirty.

1. The gap between the tiles is the easiest to hide dirt and dirt, and it is difficult to remove these stains after a long time, which seriously affects the aesthetics of the room and breeds bacteria. If there are children in the family who like to crawl underground, it will directly bring bacteria into the mouth, affecting the health of the family. In order to prevent the growth of dirt in the crevices of the floor, we can make beautiful seams in the crevices.

2. Now the tile seam is more popular, the specific method is to clean the gap of the tile first, and at the same time to groove, generally speaking, the width should reach about 4 mm.

3. The next step is to paste the masking paper, and the width of the masking paper generally cannot be less than 2 mm.

4. Then we squeeze the sewing agent into the glue gun, pour it along the gap, and finally clean it up to complete the sewing work.

Summary: If you find that the gaps in the wooden floor at home are dirty, don't worry, we can easily remove the stains through the above methods, of course, you can also do a beautiful seam when laying the wooden floor, which can save you a lot of time to disturb in the future.