Is it better to heat the house, floor heating, skirting warmth, or wall mounted radiators?

Such a symptom is also very common, mainly due to inconsistent blood circulation, so it is recommended that you should pay attention to it, do not worry too much, at this time the body's thermoregulatory center may be disordered caused by the phenomenon, it is recommended that you must pay attention.

If you have a fever above these, you can take some ibuprofen or acetylphenol fever medications to reduce the fever**.

In addition, if the body temperature is below or less, you can use the physical cooling method. In addition, you can take some antipyretic drugs orally to carry out **, and at the same time, you can also take a warm towel to wipe it on the soles of the feet, palms, armpits, and groin, which can have the effect of cooling and dissipating heat. At the same time, we should also pay attention to drinking water properly and replenishing water in time to avoid electrolyte imbalances caused by dehydration.

Hello, now the general heating is a little more used in this kind of floor heating.

Comparatively speaking, if you use home heating, it has always been better to use it, and it is better to use it from the floor heating

Home heating floor heating is better than floor heating, because the reason for convection with you is warmer.

It depends on which side you are. Is it in the north or in the south? Which province or city in China? It depends on what exactly is needed. If it's not too cold like us in the south, it would be nice to have a little air conditioning.

Which is better to use, this is not easy to say, the heating effect is almost the same, the radiator can be used as a decoration, and the floor heating is more space-saving. Because I am in the north, our home is installed with Rubens steel radiators, I remember that it should be similar to floor heating**, in my opinion, radiators are more practical, the other two have not been used is not very clear, but the public heating method is also floor heating and radiators

The heating effect of floor heating is better and more beautiful for home heating, but the relative cost will be higher.

Home heating, floor heating, skirting warming, or rose-like sunbathing, I think floor heating is better.

Is it better to heat the house, floor heating, skirting warmth, or wall-mounted radiators? You can just as long as the water temperature avenue.

Radiators, floor heating and skirting warmers, which is better for home installation? Skirting board heating, as the name suggests, is a type of pipe that is installed on a baseboard under a wall. Beautiful, space-saving, no floor height.

The heating effect is similar to that of a radiator, but there is no underfloor heating, so it is not suitable for homes in particularly cold regions. As a way of heating, baseboards are warm and beautiful, which will affect the decorative effect of the whole house. But the most important thing is to see its heating effect.

Only by doing our homework well can we make sure that our money is not lost!

1. The installation of floor heating is not cheap. At present, the level of baseboard heating technology on the market is uneven. If you can find a reliable HVAC company and use good heating materials, it will cost about 1-20,000 yuan.

Self-heating homes also need to buy a good brand of gas wall-hung boiler. If you add up the bits and pieces, it will cost about 2-30,000 yuan to install a set of baseboard heating.

2. It is not recommended to install baseboards in particularly cold areas. As a northerner, heating is an important indicator of happiness. On days when the temperature drops before heating, everyone is gnashing their teeth.

If the heating isn't warm, what's the difference between us and the southerners? While floor heating works well, it can't be compared to floor heating. Its biggest advantage is that it is space-saving, aesthetically pleasing and does not take up floor height.

Friends who live in Northeast China and Xinjiang still recommend that you install underfloor heating for better heating and a more comfortable life.

3. For houses with poor thermal insulation performance, it is not recommended to install baseboards. Living in an old house for a long time, the heating equipment is outdated, and the thermal insulation performance is poor. In such a house, baseboard heating can only be used as auxiliary heating.

After all, the warmth of the house is poor. With the heat of kicking**, the heat is depleted before the house gets warmer. Unless you spend the renovation money on home repairs.

Otherwise, it's best to honestly install underfloor heating or radiators to make them warmer and more economical.

I prefer underfloor heating, which is warmer and more comfortable, so you can choose according to your needs.

The underfloor heating was exceptional. Life will also feel particularly warm, and the home will become particularly beautiful, not dirty and messy.

I think it's better to have floor heating, first of all, floor heating looks more beautiful, more environmentally friendly, and saves space.

Take skirting heating as an example, in fact, skirting heating is also known as skirting heater, that is, the heating pipe at home is installed in the position of the baseboard, and then the heating pipe is hidden with the baseboard, and you can't see anything from the appearance. What are the advantages and disadvantages of skirting heating compared with floor heating? Winter is here, and it's time for all kinds of heating equipment to come into vogue.

Compared with air conditioning in summer, heating equipment in winter is diverse. But there are two major types, radiant heating and convection heating. Then there is the problem of pipes, the heating company is artificially added to the water of some rust removers and dyes, in order to clean up the pipe oxide and prevent you from stealing water, there must be a corrosive effect, as well as its installation method, the radiator in the north will blacken the white wall, the baseboard heat dissipation outside the board will definitely not be integrated, and the interface will smoke black marks.

If the heat source, the structure and insulation of the house are the same and the orientation is the same, compared with the radiator, floor heating and skirting heater (baseboard radiant radiator), there is no doubt that the skirting heating is the most energy-saving, more than 60% more energy-saving than floor heating, and more than 20% energy-saving than radiators.

Many families will install heating equipment in their homes, and there are many heating devices commonly used in families, such as:Floor heating, radiators, fast heating stoves (European-style fast heating stoves), electric heating oil tins, electric heating films, heaters (small and medium-sized, tower, large), small sun, air conditioningWait a minute.

The opening and closing of the radiator and the temperature adjustment are convenient and accurate. There is no street underground, there is no hidden danger of water leakage, the hydraulic balance is very good with a water collector, each branch can be controlled twice separately, convenient, energy-saving and efficient, and the radiator valve can be automatically adjusted and manually adjusted.

The installation of the joint joint is easy to leak, the after-installation system still needs to be punched, and the thickness of the baseboard will affect the usable area. It is unwise to denigrate other similar products and mislead unfamiliar consumers only to promote so-called foreign inventions.

It is better to have a radiator, because the radiator is a way of heating, and the heating effect is very good, and it can also help warm some things in ordinary times.

Of course, the heating method of the radiator is better, so that it is more economical for the space and can ensure the heat of the room.

Radiator. Because radiators have a lot of heat and are cheap, try to choose radiators.

<> radiators are better than baseboards. First of all, the heating effect of the radiator is stronger than that of the baseboard heating, the radiator can generate heat faster, and the temperature of the whole space can be raised very quickly, while the baseboard heating is very slow because it is installed around the entire space. Secondly, the installation of baseboard heating is more laborious and time-consuming, and the radiator is very quick and convenient.

In addition, in the event of damage, the radiator can be repaired and put into use more quickly.

Under the standard of intermittent heating, the ambient temperature of the bottled water distribution of the heating company is higher, generally above 50, and the floor heating is more comfortable。Cast iron radiator secondly, because cast iron radiator heats slowly, it also cools slowly. After the supply is cut off, the indoor temperature will drop rapidly, and the indoor temperature will change greatly and be uncomfortable.

The worst thing is the coil fan, which can't withstand the heat when it is heated, and the cold can't bear it after the supply is cut off, and there is also noise.

Kicking warm, because people must heat the most is the lower body, the calories above the top of the head are all done blindly, kicking warmth just meets this standard, and compared with the coil fan, it is not noisy, the comfort is higher, at the appearance level, the skirting warmer fuses the baseboard and radiator together, it can be said that it does not occupy the height of the room and does not occupy the total area of the room, if you subtract the money for assembling the baseboard, the assembly price of the baseboard is the least. Again, the copper and aluminum conform to the ambiguous sheet, because in self-heating, the lower the temperature of the heating water, the smaller the relative thermal damage.

Floor heating, although floor heating can also be ultra-low temperature heating, but floor heating is double heat exhaust (to make unilateral heat discharge, its initial installation cost will be doubled), so the heat loss of floor heating is also the highest carbon fiber electric floor heating in the tail end of various heating rooms, including heating cable floor heating and electric heating film floor heating, because these two kinds of floor heating use electricity as power energy, energy consumption is very high, generally only need to be paved in a small total area of indoor space application, such as only paving 1-2 rooms, not suitable for large-scale applications, Therefore, it is not a popular heating method in the market.

At this stage, home heating is dominated by plumbing installation and heating, before only the air sheet and electric floor heating, and now there is a stronger new plumbing installation heating method, which is skirting heating. Let's first introduce what is called skirting heating, and then compare several types of plumbing installation and heating methods, so as to help everyone compare which heating method is more suitable for themselves. The general name of the baseboard is equivalent to dismantling the traditional column-type airpiece piece by piece and assembling it around the baseboard of the houseThe surface layer looks like a high-end baseboard, but the control panel of the baseboard has a waterway and a plate-fin type, and the control panel, plate-fin type and waterway are extruded and processed by the aluminum alloy profile, and the boiling water flows from the waterway during heating, and the heat is transmitted to the control panel according to the plate-fin type, and the heat is discharged to the radiation source in the house, and then the indoor space design is heated.

Underfloor heating is the best, the temperature coverage is very even, can make the soles of the feet feel warm, and the cost is not high.

The floor heating method is the best, the hidden one will not affect the beauty of the home, and the heat dissipation will be even.

I think the underfloor heating method is the best, it is very clean and hygienic, and the temperature is relatively comfortable.

Skirting board heating, known as "baseboard heating", is also known as baseboard heating, baseboard heating, baseboard heating, corner heating, invisible heating, baseboard heating radiators. Skirting board plumbing is the equivalent of taking apart a traditional cylindrical radiator and installing it along the baseboard around the room. The installation length is several times that of the radiator, and the heat dissipation configuration is also several times that of the radiator, so the heating effect is better.

The baseboard looks like the one on the outside of the water heater, but there is a heating channel behind the panel, which is integrated with the panel. During the heating process, hot water flows through the waterways, and the heat radiates from around the room to the room through the panels, which heats the indoor air. "Baseboard plumbing" is a heating method that combines heating and baseboard decoration functions.

Human foot heating meets the physiological needs of the human body and has high comfort. It is a new heating method that has been developed in recent years.

The function of baseboard plumbing: it integrates heating and decoration. It looks like a high-grade solid wood baseboard, but it also has a heating function, which organically combines the heating and the decorative function of the baseboard.

The application place of skirting water heating: homes, office buildings, kindergartens, schools and other places that need heating, especially places that need intermittent heating, is a very ideal heating method. The working principle of baseboard plumbing, "baseboard plumbing" belongs to plumbing.

Like radiators and water floor heating, it continuously delivers hot water to the waterway after the baseboard heating and continuously radiates heat to the room through the baseboard plumbing panels, thus heating the interior space. Heat is mainly conducted by convection rather than radiation.

The significance of the invention of this thing, since the German Yinwu HVAC International and Hefei Heng HVAC Equipment jointly invented the floor heating, the world's heating industry has undergone earth-shaking changes. From the original polar world of radiators and floor heating, to the tripartite situation of radiators, floor heating and baseboard heating, it has turned tradition upside down and ushered in a new era of heating!

The skirting is very beautiful to warm up, on the contrary, the radiator will be ugly. Secondly, the skirting saves space and does not affect the placement of furniture, while the radiator wastes space. The heat dissipation speed of the skirting heating is uniform compared to the radiator, and the heating effect is better.

The heating range of the baseboard floor heating is wider, warmer, and more convenient, which will make the temperature in the house more suitable, and the radiator is heated unevenly, which will only make the temperature of that side higher, and it will smoke the wall, which is not conducive to cleaning.

Floor heating dissipates heat faster, which can make the home hotter, less costly, more beautiful and more convenient.

The "kick warmer", which is claimed to replace floor heating and radiators, is so magical. "Skirting warming" is the general name of "baseboard type plumbing radiator", the appearance looks like a solid wood baseboard, but the selection of aluminum alloy profile manufacturing, the rear hidden waterway, plate fin type, and the front plate integrated extrusion processing, and floor heating is the same as plumbing installation, heating boiling water according to the waterway fluidity after the receiving, the heat is sent to the control panel using the plate fin type, and then to the radiation source from all around the house to the middle, from the body and feet to heat, high comfort.

Compared with water floor heating, it does not raise the road surface, it can be assembled with wood pangolin pure solid wood floor, the temperature is fast, it can be void heating, it is more environmentally friendly and energy-saving than floor heating by 60%, it is not easy to cause respiratory diseases, it is heated from all around the house, it is not heated from under the wooden floor to the top, it is not easy to speed up the release of indoor carcinogens such as formaldehyde stupid in the wooden floor, which has many benefits for physical and mental health, and is easy to assemble and easy to overhaul, and there is no need to clean and maintain long-term applications.

The baseboard plumbing is installed along the foot of the wall around each room, and the heat is discharged from the middle radiant source from all sides, which not only raises the temperature of the house quickly, but also makes everyone feel warm quickly. The thickness of the baseboard plumbing installation is only 3cm, and the relative height is in the middle of 12cm, and the surface layer of the baseboard plumbing installation adopts the fashionable baseboard style, and at the same time a variety of colors, it also takes into account the color and style of the board or door frame, and from the appearance it is a kind of high-grade baseboard that is in harmony with the wooden floor or door frame.

For the house that has been decorated with interior decoration and has not assembled heating, only need to disassemble the original baseboard and replace it with the baseboard plumbing installation, the heating system pipeline is laid out from the rear of the baseboard plumbing installation, and the pipeline can not be seen on the wall.