The steering machine is broken and there is a gurgling sound, how to solve it?

The friction between the plastic parts of the steering wheel is composed of a variety of plastic parts, and if the gap is too small when turning, there will always be abnormal sounds, especially for new cars, which will occur after a period of running-in. If there is an abnormal sound after the run-in, you can try to reinstall the steering wheel. The friction between the steering column and the foot pad is sometimes too large after installation, and the foot pad is in direct contact with the steering column, so friction will occur when the steering column rotates, which is still very common, and the foot pad can be adjusted or replaced.

If the airbag hairspring in the steering wheel fails, friends who remove the steering wheel should pay more attention, it may be that the airbag hairspring is broken or the airbag hairspring plug is not plugged in, and the airbag hairspring can be replaced or the plug can be fixed.

<> The head of the steering rod is aging and loose. Replace the steering lever head, but remember to do a four-wheel alignment after replacement. The characteristics of the steering machine are not good, and it makes a banging sound during driving, especially when turning the steering wheel, there is an obvious abnormal sound, this symptom is likely to indicate that your steering machine is broken.

There are many problems that cause abnormal noise of the steering machine, which are generally related to the failure of less steering power oil, universal joints, plane bearings, etc., and abnormal noise is a relatively obvious feature, so once found, it should be immediately sent to the 4S shop for maintenance.

In the lower part of the steering column, it may be an abnormal sound caused by loose bolts or lack of lubricating oil. The chassis part of the body, mainly the suspension part, has too large axle head clearance or loose bolts, which need to be checked. Different cars have different structural characteristics, which need to be divided into models, and it is best to find professionals to check.

Of course not, because the vehicle will not be able to steer properly after the steering machine is damaged. If you continue to drive at this time, there is a high chance of fatal traffic accidents. Before driving a vehicle, the owner must determine the better condition of the vehicle.

If the current condition of the vehicle is not good, then the owner must not drive a broken car and a sick car on the road.

Do a detailed interpretation of the problem, I hope it will help you, if you have any questions, you can leave me a message in the comment area, you can comment with me more, if there is something wrong, you can also interact with me more, if you like the author, you can also follow me, your like is the biggest help to me, thank you.

It may be that there is a lack of booster oil, you can add booster oil, or check the installation of the steering wheel to see if there is any jamming, whether the steering wheel is faulty, and if it is really not possible, you can drive the car to the maintenance office for maintenance.

You can reinstall the steering machine, you can go to a professional car repair shop for repair, or replace the steering machine, put butter on the steering machine, or you can change the dustproof on the steering machine.

Go to the local 4S shop or maintenance shop in time for four-wheel alignment, prevent dust and oil leakage for the steering machine, do a good job of lubrication facilities, replace the steering machine regularly, reinstall the steering machine or adjust the position of the foot pad.

It may be that the screws are loose or lack of lubricating oil, and you need to go to the 4S shop to find professionals to repair them, and you should also beat the steering wheel to death when you turn around to avoid side sliding.

Suspect it's a problem with the gimbal under the steering wheel.,I was like this before Tiger 5.,After 4S inspection, it was said that there was something wrong?

Steering tie rod ball joint aging:If the steering tie rod ball joint is aging, then it will cause the steering wheel to shake and make a sound, which is usually replaced by the steering tie rod ball joint and the four wheel alignment after replacement.

The plane bearing of the shock absorber makes a squeak and a strange soundAs long as you open the head cover and listen to whether the sound comes from the position of the top seat of the shock absorber, so that you can know whether it is the sound of the plane bearing of the shock absorber, the plane bearing of the shock absorber sounds, you can apply some butter on the plane bearing, if it still rings after coating, it can only be replaced.

Precautions for the use of the steering machine.

Due to the use of grease will gradually become dirty and deteriorate, so that the lubrication capacity will be reduced; At the same time, the material under wear will gradually increase, and the abrasive wear phenomenon will become heavier and heavier, which will aggravate the wear of the steering machine. Every 100,000 kilometers or so, the steering machine should be fully maintained, cleaned and refilled.

The clearance of the steering machine will gradually increase in use, if the left and right empty travel of the steering wheel exceeds 15 degrees, the steering machine must be checked, such as the abnormal wear of the rack and pinion, the steering machine assembly must be replaced; If there is no abnormal wear, but the gap is too large, it can be adjusted. When adjusting, it is necessary to go to the service station to be carried out by trained professionals, and after adjustment, it is necessary to ensure that the steering wheel can hit the left and right to the limit position, and the force is uniform and the rotation is flexible.

Normal, because it is power steering, when the direction is killed, the vehicle steering power pump is still pressurizing, in fact, the steering gear has come to an end, so make a sound, it is recommended not to kill the direction, especially the direction for a long time!

Pay attention to two aspects, 1 if it is not enough to replenish to the standard scale, if the booster oil is discolored, it should be completely replaced. In addition, you should pay attention not to hit the direction to the limit (left or right) at ordinary times, as hitting the limit booster itself will make an abnormal sound, which is not good for the booster and is easy to cause damage.

2. As for whether the front wheel cage bearing is damaged, it can be judged in this way: in the process of driving, the direction of turning, especially the smaller the turning radius, the easier it is to judge, whether left or right, if there is a "click, click, click" rhythmic abnormal sound, it means that the ball cage bearing is broken.

It's my joy to clear your doubts!

This is the sound of the steering machine stuck, just go back to the direction a little.

1.The steering tie rod ball joint is aging and has an open space: replace the steering tie rod ball joint, and do four-wheel positioning.

2.Oil leakage of the dust-proof sleeve of the steering machine: replace the dust-proof sleeve or re-butter.

3.Steering machine failure: It may be caused by the gear clearance of the steering machine is too large, and the steering machine needs to be replaced.

4. Improper tightness or aging of the power booster rolling belt: check the power steering oil capacity, and adjust the tightness of the belt or replace the belt.

The characteristic performance of the steering machine is also the rattling sound during driving, especially when turning the steering wheel, there is an obvious abnormal sound, and the appearance of this symptom indicates that it is very likely that your steering machine is broken. There are many problems that cause abnormal noise of the steering machine, which are generally related to the failure of less steering power oil, universal joints, plane bearings, etc., and abnormal noise is a more obvious feature, so once found, it should be immediately sent to the 4S store for maintenance.

There are a lot of gurgling sounds on the steering wheel, and the first thing to distinguish is the part:

1. The lower part of the steering wheel may be caused by loose bolts or abnormal sound caused by lack of lubricating oil.

2. The chassis part of the body, mainly the suspension parts with too large axle head clearance or loose bolts, need to be checked.

3. Different car series have different structural characteristics, and it is best to find professionals to check them according to the model of the model.

The right way to get the steering wheel:

1. Avoid turning the steering wheel on the spot, try to play the direction after the vehicle moves, and the direction on the spot can only be used occasionally when the car is lowered in a special environment.

2. When the vehicle is stopped, the steering wheel should be returned to the center position to avoid the suspension system and tires from bearing the load.

3. When you need to turn around, try to avoid the steering wheel hitting the dead center.

Photo by Chen Fang1) @2019