What should I do if the refrigerator is old and stagnant? Why is there always water in the refrigera

The first thing to see is whether the drainage hole of the refrigerator is blocked, the refrigerator will have a little bit of water under normal conditions, which will go out through the drainage hole, but there is not much water in these areas, if it is blocked, it should be cleaned up in time, in addition, the following problems may also cause excessive water accumulation, and you need to pay more attention to it in daily life.

1.Under normal circumstances, the temperature of the refrigerator is set between 0 and 10 degrees, and because the food carries a lot of water vapor and heat, or the door is opened and closed frequently, it will liquefy into water when it is cold in the sealed box.

2.The door seal of the refrigerator is aging, causing the heat from the outside to escape into the refrigerator and turn into water droplets when it is cold. This is an important factor in making the fridge have water droplets. Hot air can be blown on the door seal with a hair dryer to soften the door glue and increase the elasticity.

When using the refrigerator, you should try to minimize the number of times the refrigerator is opened, so that the cold air in the refrigerator refrigerator is not easy to volatile, and sufficient air conditioning can fully convert the moisture of the food into ice, especially in summer, the refrigerator has a lot of water, as long as you check it before closing the refrigerator, you can effectively avoid water in the refrigerator refrigerator.

When using the refrigerator, if there is cooked hot food that needs to be frozen, be sure to wait for the food to cool before putting it in the refrigerator, so that the hot air does not condense into ice, which indirectly melts into water and remains in the freezer. If the drain pipe is blocked, the drain hole in the refrigerator compartment should be dredged with a thin wire to drain the water. If all the above methods have been used, and there is still stagnant water, you should find a special master to repair it.

When we clean the refrigerator, it is best to unplug the power supply, after cleaning the refrigerator, we need to dredge the drainage holes for cleaning, and use the tools, you can use a thicker wire to stretch into it and turn a few times to drain the water. There is also the reason for the food in the refrigerator, it must be packed in a storage box, do not put it in casually, and the vegetables and fruits that are put in it for a long time will also produce water droplets. It would be much better to put it in a box.

And there is no smell channeling, and there is no odor in the refrigerator.

The food in the refrigerator should be kept separately so that it will not spoil faster, the refrigerator will be much cleaner, and the food will be stored for a longer time. Put the contents of the crisper in a box and drain it to avoid smelling and soup flowing. It preserves the purest taste of food.

If you want to have a clean storage environment, you have to clean the refrigerator first and use a sterilization and deodorizing spray, which has a particularly good effect.

When using the refrigerator, vegetables can be stored in a fresh-keeping bag, and it is customary to put the cereals in the refrigerator, or you can use a professional storage box to store the cereals, whether you put it in the cabinet or the refrigerator, it is practical. If you have learned the above tricks, At this time, you need to use a plastic bottle to fill some water, test it, if the water leaks down, it works, if it doesn't leak down, then you need to carry out the method taught to you above. Quoted from Sohu.

Causes of water accumulation in the refrigerator: Food with a lot of moisture or opening the door too often.

When the food is stored, the temperature is too high and it is not cooled directly into the refrigerator, the hot air has a large water content, and cooling in the refrigerator will cause a large amount of condensation, and the generation of condensate will be greater than the speed of discharge, which will cause water accumulation.

If the door is opened too often, a large amount of hot air will enter the refrigerator, and the hot air will produce condensate in the condensation, and the condensate will be generated more than the speed of discharge, which will cause water accumulation.

Power Saving Tips:

The refrigerator should be placed in a position that is free from direct sunlight, conducive to ventilation, and at the same time keep a distance from the wall so that the heat generated during the operation of the refrigerator can be dissipated.

Always check the tightness of the refrigerator seal, if the seal is deformed, it will affect the degree of closure of the seam, causing the air conditioner to leak out, thereby increasing power consumption. If the deformation is serious, it should be repaired and replaced in time.

After the refrigerator is used for a period of time, some frost will be produced, if it cannot be frosted regularly, it will affect the cooling effect, and the power consumption will also increase, and even easily damage the compressor. Therefore, whenever you see that the thickness of the frost is more than 7cm, you should defrost it.

The refrigerator at home often accumulates water, not the fault of the refrigerator, the master teaches you to use this method, and the refrigerator will no longer accumulate water.

First of all, you look at the drainage hole under the refrigerator, whether it is blocked, if it is blocked, poke it with a long wire, wrap the wire head with tape to prevent the pipe from being damaged, and when you usually put something, do not release heat, and moisture things, do not open the door frequently.

There is a drainage hole in the back wall of the refrigerator room, and the melted water can be discharged during normal shutdown, but it is blocked by a small amount of debris (slightly) after a long time, resulting in poor water outlet, and the fresh-keeping layer will accumulate water or freeze. There is a curved pipe under the small hole, which cannot be solved by poking something, you can open the small lid behind the refrigerator, you can see the drain pipe head, and blow hard against the pipe to blow out the debris! Then pour some water from the drain hole in the refrigerator (add a small amount of washing) and rinse it a few times!

Very effective!

The refrigeration effect deteriorated, and when the temperature rises, the ice melts and the cold air in the refrigerator condenses into water.

The old water in the refrigerator means that the refrigeration function of your refrigerator is not very good, you can't freeze the ice, the temperature is not low, you should replace the refrigerator with a new refrigerator or repair it, if the refrigerator is not expensive now, the maintenance fee is not as good as buying another refrigerator.

Improper storage of food may be the high temperature of the food stored in the refrigerator, or the accumulation of water in the refrigerator due to improper storage methods. Because the refrigerator is a closed space every day, when the food temperature is too high or contains steam, put it in the refrigerator, and the steam will condense into a large amount of condensation when it encounters cold air. When condensate forms faster than the refrigerator drains water, the refrigerator is prone to water accumulation.

To do this, we need to purchase reasonably, don't hoard too many dishes, and ensure air circulation in the refrigerator. In addition, for vegetables and fruits with a lot of moisture, be careful not to store them too close to the inner wall of the refrigerator. It's good practice to wrap it in a crisper bag.

It is recommended to place them in the middle of the cold tour mountain storage room. Do not leave hot food in the refrigerator or cover it with plastic wrap. 2.

The drain is clogged.

1.Turn off the power to the refrigerator and unplug it to prevent electric shock.

2.Take the food and drinks out of the fridge and store them somewhere else temporarily.

3.Remove all drawers and shelves from the fridge, wash them and dry them.

4.Use a vacuum cleaner or rag to blot or wipe off the stagnant water inside the refrigerator.

5.Check that the drain hole of the refrigerator is not clogged and if it is blocked, it needs to be cleaned up.

6.Wipe all surfaces of the mold part of the refrigerator to make sure that no moisture remains.

7.Put the drawers and shelves back in the fridge and put the food and drinks back in.

8.Plug in the power plug, open the power supply of the refrigerator and wait for the refrigerator to return to normal temperature.

9.Regularly inspect the drain holes in your refrigerator to avoid water accumulation.

1.Clean the inside of the refrigerator: First you need to take out the food and drinks inside the refrigerator, and then pour out the water inside the refrigerator. If there is dirt or odor on the inside of the refrigerator, you can wipe it clean with a mild cleaning agent and a damp cloth.

2.Check the drain holes: The cause of water accumulation in the refrigerator may be that the drain holes are blocked, and you need to check whether the drain holes are unobstructed. If the drain hole is blocked, it can be gently cleaned with a slender needle or toothpick.

3.Adjust the temperature: If the refrigerator temperature is too low, it may cause the inside of the refrigerator to freeze, which in turn can lead to water accumulation. You can turn the temperature of the refrigerator up a bit to avoid freezing.

4.Replace the seal: If the refrigerator seal is aged or broken, it may cause the temperature inside the refrigerator to be unstable, which in turn can lead to water accumulation. Replace the seal may be considered.

5.Seek professional help: If the above methods do not solve the problem, it is recommended to seek professional help to avoid damage to the refrigerator.