How to clean the charging cable if it is dirty, and what to do if the charger cable is dirty and yel

Updated on number 2024-07-15
5 answers
  1. Anonymous users2024-02-12

    <> phone headphones. There is also a mobile phone charging cable is very easy to get dirty, if it is too dirty, we dare not listen to the headphones, or do not want to charge the phone. So don't worry, Brother Miao Zhao will introduce a small trick to you today, you can let your mobile phone earphones or charger cable, easily remove the surface stains and buy the same as the new one, let's take a look with Brother Miao Zhao!

    Let's take a look at whether the charging cable of this mobile phone is dirty or not, it has been used for a long time, we can still clean it up as new, first of all, we use the toothpaste commonly used in brushing teeth at home.

    Then prepare a rag that is usually used to wipe the table, squeeze the toothpaste on the rag like this, just squeeze a section, and then we take the charger cable and wipe it back and forth. If you see that the toothpaste is gone, let's squeeze a little more toothpaste, and see if we wipe it very clean and tidy? At this point, we're not done yet, so let's prepare a little more alcohol that we commonly use at home.

    Prepare a paper towel, pour a little alcohol over the paper towel and <>

    Then we wipe the charger cord on the alcohol to detoxify the charger cord, let's take a look at the charger cord, wipe it is very bright and tidy, and the new is the same? And the charger cord has no yellow stains at all.

    What do you think of the tips shared by Brother Trick to quickly clean up the headphone cable and charger cable, is it simple and practical? If it feels simple and practical, please share it with your friends or family!

  2. Anonymous users2024-02-11

    The solution to the dirty and yellowed electrical wire of the charging and flushing is as follows:

    1. Laundry soap: cut off a small piece and melt it with warm water, then wipe the data cable with a small amount of solution dipped in a cotton cloth, and finally dry it with a dry towel.

    2. Toothpaste: Squeeze out a little toothpaste mixture with a small amount of water, then wipe a small amount with a cotton cloth, and finally dry it with a dry towel. (This is washed and a little fragrant, and the interface can't be cleaned).

    3. Alcohol: Drop alcohol with cotton, wipe along the data cable, and finally dry naturally.

    4. White vinegar: Use cotton to drip white vinegar and wipe along the data cable, the taste is a bit heavy, and finally the cotton cloth and water wipe the smell. (It's better not to wash the interface).

    5. Eraser: The effect is not bad. (This interface can't be erased) <>

  3. Anonymous users2024-02-10

    1. Dip a towel in some water, and then apply some dish soap to the place where the water is dipped again.

    Or soap, wipe the data cable, and then wash the towel, wipe the Liang Jing data cable clean, and you're good to go.

    2. You can also use the special spray for mobile phone stores.

    3. Use cotton to drip white vinegar, wipe along the data cable, and finally wipe the smell with cotton cloth and water (it is best not to wash the interface).

    4. For general dirt, you can use a clean white cloth to wet it a little and then dip it in some decontamination powder to wipe it, it is very clean. Dip a white cloth in 84 disinfectant.

    Wipe is also ok.

    5. Use cotton to drip white vinegar, wipe along the ear line and data cable, and finally wipe the smell with cotton cloth and water (it is best not to wash the interface).

    6. We can also take out the toothpaste rubber at home, and then squeeze it on the top of the rag, and then wrap the charging cable with a rag to rub back and forth. This is mainly due to the fact that toothpaste has a certain cleaning power.

  4. Anonymous users2024-02-09

    The cleaning method for the dirty charging cable is as follows:Tools needed: sponge, toothpaste.

    1. First of all, prepare to find a clean Yushen sponge, as shown in the figure below

    <>3. The data cable is placed on top of the toothpaste, as shown in the following grinding mold diagram

    4. Clamp tightly with a sponge, as shown in the figure below

    5. Then pull back and forth, as shown in the figure below

    6. In this way, the dirty things on the data line will come down, as shown in the figure below

    7. After the scrubbing is completed, the data cable will be the same as new, as shown in the figure below

  5. Anonymous users2024-02-08

    Question 1: What should I do if the mobile phone charging cable is dirty, how to clean it Dip the cotton ball in alcohol, wipe it one by one, and disinfect and sterilize.

    Question 2: How to clean the cable of the mobile phone charger when it is dirty? It's white. With alcohol, remember not to wash to the head and tail!

    Question 3: What is the most effective way to clean Apple's earphone cable and charging cable when it is dirty? The most effective way to clean Apple's earphone cable and charging cable when it is dirty is as follows:

    1,The eraser method is very simple,Take a good eraser,**Dirty wipe**,Don't stop the book This method is limited to a small area on the earphone。

    2. Warm boiled water method, plugs, earbuds and microphones are sealed, or be careful not to get wet, soak the part of the line in warm boiled water at 40 60 degrees for a few minutes, take it out and start wiping it with a soft cloth or napkin, and wipe it until it is clean.

    3. Wet wipes method, similar to the warm boiled water method, buy a piece of wet wipes, if there is too much water, first wring out the water in the wet wipes, and then wipe it directly.

    Question 4: How to clean Zifan when your data cable is dirty The outer skin of the data cable and earphone cable is very fragile, and the corrosiveness of the detergent is very strong, and the earphone cable is easy to reduce the life of the earphone cable in this acidic state, and the wire will crack and lose its elasticity! So the easiest way is to wipe the surface with hot water first, then apply toothpaste, after a few minutes, and then dry it with a wet paper towel, you will find that the data cable has a new look.

    Question 5: How to wash the mobile phone charging cable when it is dirty.

    Question 6: Why is the charging cable so dirty and how to clean it? 10 points It takes a long time to grind, and my previous white charging cable and earphone cable will be like this after a long time, and it can be slightly better if you wipe it with water, but it can't be restored to its original appearance.

    Question 7: How to clean the mobile phone data cable if it is dirty Hello!

    1. Laundry soap: cut off a small piece and melt it with warm water, then wipe the ear line and data cable with a small amount of solution dipped in a cotton cloth, and finally dry it with a dry towel. (Of course, dish soap, shower gel, etc. are fine, so I won't give examples one by one, and the interface can't be cleaned).

    2. Toothpaste: Squeeze out a little toothpaste and mix a small amount of water, then wipe a small amount with a cotton cloth, and finally dry it with a dry towel. (This is washed and a little fragrant, and the interface can't be cleaned).

    3. Liquor: Drop alcohol with cotton, wipe along the ear line and data cable, and finally dry naturally. (This can clean the interface, disadvantages: alcohol is easy to age the line, but it has little effect.) )

    4. White vinegar: Use cotton to drip white vinegar, wipe along the ear line and data cable, the taste is a bit heavy, and finally wipe the smell with cotton cloth and water. (It's better not to wash the interface).

    5. Eraser: I won't explain much about this, but the effect is not bad. (This interface can't be erased) <>

    Question 8: How to clean the cable of the mobile phone charger if it is dirty Wipe it with a wet towel dipped in laundry detergent, and finally clean it, of course, it is best not to get water into the jacks at both ends during the cleaning process.

    Question 9: How to clean up the inside of the mobile phone charging hole It is impossible to clean it, so it can only be replaced. The interface can be protected by means of a dust plug.

Related questions
25 answers2024-07-15

If you are using a vivo charger, it is recommended not to continue to use the charger after it is liquidized to avoid safety accidents caused by short circuits. >>>More

22 answers2024-07-15

Wireless charging technology is derived from wireless power transfer technology, which is based on the principle of transferring energy in a magnetic field between the charger and the electrical device. It can be divided into two types: low-power wireless charging and high-power wireless charging. Low-power wireless charging often uses electromagnetic induction; High-power wireless charging often uses a resonant type, and the power supply device transmits energy to the power device.

12 answers2024-07-15

The EV charger cord is not long enough, can you extend it yourself with a 15-meter cable? If the wire is not long enough, it can be lengthened, but there must be enough wire diameter to ensure the amount of current and prevent the heating of the wire from causing disasters due to overload.

8 answers2024-07-15

It can be calculated as follows:

1. The output voltage of the charger is multiplied by the output current, if the output of the ordinary mobile phone charger is 5V-2A, that is, 5X2=10W, the charger will be marked but the maximum output value of the charger end is not necessarily the power of the mobile phone charging, and the actual charging output will change due to the change of the power that the mobile phone can bear. Actual charging power. >>>More

4 answers2024-07-15

If only from the point of view of charging, the problem is not big, because the requirements for the data cable when charging are actually very low, only when it comes to the transmission of data, there will be high requirements, ordinary imitation wire, may be reduced in the transmission rate of data, but there is no impact on the service life of the mobile phone, the speed of the original Apple cable will be faster when transmitting data, and the ordinary imitation line may be a little slower.