The clutch smells burnt when the car starts, can the car still drive?

Updated on Car 2024-07-02
18 answers
  1. Anonymous users2024-02-12

    It's best not to keep driving and change as soon as possible. Clutch.

    The free travel is gone, and when the vehicle is driving, it will cause the clutch to slip and heat up.

    The power decreases, and there will be a peculiar smell.

    The burnt smell can come from the clutch, if there is no problem with driving habits, such as feet on the clutch while driving, often half-clutched.

    When driving, consider the problem of incomplete clutch disengagement. In addition, check the method of hanging into the 3rd or 4th gear, the floor oil.

    If the speed rises, the speed rises, then there is no problem with the clutch, if the speed rises and the speed rises slowly, the clutch has slippage and needs to be serviced.

    The clutch assembly consists of three sets of clutch plates, clutch pressure plates and release bearings, and the life of the three sets is basically the same. Unless the clutch plate is replaced in a short period of time due to quality problems at the factory, under normal circumstances, when the clutch plate is worn, the life of the pressure plate and release bearing is basically over. In addition, if the clutch plate is simply replaced, the wear degree of the pressure plate and the release bearing and the plate is inconsistent, and it needs to be re-run-in, which is very easy to cause the aging of the new clutch plate to be very accelerated, which greatly shortens the service life of the clutch plate.

  2. Anonymous users2024-02-11

    It is recommended to replace the clutch plate, if there is a burning smell, it means that the clutch plate has slipped and heated.

    The service life of the clutch plate has a lot to do with the driver's driving habits

    1. When stepping on the clutch, often put your feet on the clutch pedal, so that the clutch plate is in a semi-linkage state, which accelerates the wear of the clutch plate.

    2. When shifting gears, after pressing the clutch pedal, press the accelerator throttle, the engine speed increases, the speed of the car is low, and the clutch plate will be touched violently, which will cause strong friction and damage the clutch plate.

    When the clutch plates are damaged, the shift will be unsmooth, causing problems with the shift.

    Please replace the clutch plate in time to correct the poor shift method.

    Hope it helps,!

  3. Anonymous users2024-02-10

    After the burnt smell, the car can still continue to drive, because only a little bit of the surface of the clutch plate is burned, and as the vehicle continues to be used, the burnt place on the surface can be ground off, so as to return to normal. Because the starting time is short, only a few seconds, it will not cause too much wear and tear on the clutch plates, and the clutch plates will not be scrapped at one time, so you can use the car with confidence. But it can not appear often, if the number of occurrences is too much, the life of the clutch plate will be greatly reduced, others can use more than 100,000 kilometers normally, and novices may only use 350,000 kilometers.

    Therefore, when driving a manual transmission car, the starting technique is more important and the most basic, and it is necessary to practice more.

  4. Anonymous users2024-02-09

    It is best not to open it again to avoid aggravating the degree of wear. When the car starts in low gear, after relaxing the clutch pedal, the car cannot start or has difficulty starting; When accelerating, the speed of the vehicle does not increase with the increase of engine speed, and the driving is weak, and in severe cases, it produces a burning smell or smoke. These are common symptoms of clutch slippage, which means that the internal wear of the clutch is more serious, and it needs to be overhauled in a 4S shop and replaced according to the situation. Hope!

  5. Anonymous users2024-02-08

    If you are an old driver, you can feel the power of the engine when driving, when the clutch burnt smell when starting, it means that the engine power output through the clutch is greatly reduced, to solve this problem you need to replace the clutch pressure plate, clutch friction plate, and release the bearing.

    When this happens, don't step on the accelerator, it will be fuel-intensive and powerless.

  6. Anonymous users2024-02-07

    It is recommended that you go and replace the clutch plates, which may burn out.

  7. Anonymous users2024-02-06

    No.

    The clutch plate has a burning smell, which is a symptom of excessive wear, and the clutch plate has been broken, so you can only replace the clutch plate with a new one. Because there is no clutch plate, the clutch cannot transmit power normally, and the car cannot drive normally. It is best to call the tow truck to tow the car to the repair shop for replacement, if you want to drive it yourself, then you can only start the vehicle in gear and drive slowly to the repair shop.

    It should be noted that if the clutch plate is not replaced in time, it may wear out along with the flywheel. At this time, it is not only a simple replacement of the clutch plate can be solved, it needs to be replaced together with the flywheel, which will greatly increase the cost of maintenance and replacement.

    Severe symptoms of clutch disc wear.

    1. It smells burnt. The fact that the car can smell burnt during normal driving can prove that the clutch plates are badly worn.

    2. There is a sound of metal rubbing. If you can hear the sound of metal grinding every time you press the clutch pedal, you should check the clutch plates immediately, as this is generally only possible if you wear too much.

    3. The acceleration of the car is weak. When stepping on the accelerator, the engine speed went up, but the speed did not go up, indicating that the clutch plate had a pattern slippage, resulting in a way that the power could not be transmitted to the gearbox well.

    4. The clutch pedal is raised. If the clutch plate is worn severely, when the clutch is loosened, the clutch pedal will be raised very high, which can be used to judge that the clutch plate is overworn.

  8. Anonymous users2024-02-05

    The accessories are very cheap, and the main labor hours are more. Let's go about 1000 together.

  9. Anonymous users2024-02-04

    It's okay, the main thing to look at is what car, generally only fifty dollars of clutch plates, if you step on the clutch gear after the car power is obviously not able to keep up, then it needs to be replaced, usually not, there is a taste because you often use it, the next maintenance with the master to mention a clutch plate on the line.

  10. Anonymous users2024-02-03

    If you can shift gears normally, there is no problem, but the service life of the clutch is a little shorter, and what kind of repair cost is what kind of car at any price.

  11. Anonymous users2024-02-02

    Hello: Are you sure you burned? Is it the mushy smell of forgetting to release the handbrake while driving?

  12. Anonymous users2024-02-01

    The clutch plate has a burning smell because the clutch plate is not tightly bonded and the clutch plate is slipping, if the clutch plate has been slipping, it will rub against the pressure plate, which will cause a burnt smell.

    There are many reasons for the clutch plate to slip, it may be that the clutch plate is seriously worn and needs to be replaced, it may be that the diaphragm spring on the pressure plate is faulty, or it may be that the free stroke of the clutch pedal is not enough.

    If the clutch plate slips, it should be checked and repaired immediately.

    If the clutch plate slips, the full power of the engine cannot be transmitted to the gearbox, which will lead to insufficient power and increased fuel consumption.

    The clutch plate is a wearing part, this part needs to be replaced regularly, and as the mileage of the car increases, the clutch plate will also wear out.

    If the clutch plates are excessively worn, the clutch plates will slip.

    If you can maintain the correct driving habits when using the car, it can extend the service life of the clutch plates.

    When driving a manual transmission car, do not leave the clutch in a semi-linked state for a long time, which can reduce the wear rate of the clutch plates.

    Do not put your left foot on the clutch pedal when you are not using the clutch.

  13. Anonymous users2024-01-31

    If the clutch has a burning smell, it is recommended to go to the auto repair shop immediately for inspection and repair, because the clutch is a very important part of the car, so if it is burned, there must be an abnormal failure.

  14. Anonymous users2024-01-30

    If the clutch has a burning smell, stop and check it quickly, otherwise it will be more serious, and there will be some dangerous conditions, so hurry up to find out what the cause is.

  15. Anonymous users2024-01-29

    Step on the clutch can not be excessive semi-linkage, the first gear into the second gear should be fast, the clutch either step to the end, or let go of the whole way, except for the advance gear and retreat foot can not always be placed on the clutch pedal,

  16. Anonymous users2024-01-28

    The problem is for car vehicles. It is not uncommon for the clutch to have a burnt taste. There is such a smell and hurry to deal with it. Go fix it.

  17. Anonymous users2024-01-27

    The clutch returned to normal after the burnt smell. The smell of burnt clutch plates can generally be dissipated in less than half a month after replacement, which is also related to the use habits of the owner.

    It doesn't matter if it's an automatic transmission.

    Or a manual transmission, a car clutch.

    If the sheet is burned, it should be replaced in time. There are usually several reasons for clutch plate burnout, the core of which is because of the high temperature generated after abnormal friction, resulting in damage to the clutch plate. In this case, the driver should pay attention to his own driving habits, such as semi-linkage.

    Improper clutch operation causes the clutch plate and the pressure plate flywheel to be in a state of friction all the time, resulting in high temperature and burning out the clutch plate.

    In another case, when the driver lifts and releases the clutch pedal during operation, the inner clutch plate and sub-disc will suddenly combine, which is more likely to cause the clutch plate to decompose and wear out the surface of the pressure plate. In addition, when replacing, it is also necessary to pay attention to whether the material of the clutch plate itself is qualified.

    Clutch plates may burn out due to:

    1. Improper operation by the driver will cause friction between the clutch plate and the pressure plate flywheel, resulting in high temperature and burning out the clutch plate.

    2. When the driver operates the clutch pedal, the clutch plate and the sub-disc will suddenly combine, which can easily cause the clutch plate to decompose and the surface of the pressure plate to grind.

    3. The clutch plate is used for too long or too many kilometers, and the clutch plate is naturally aged and worn.

  18. Anonymous users2024-01-26

    Summary. The clutch has a burnt smell. As long as this clutch does not slip, it can be opened normally without much impact.

    In other words, after the vehicle runs, the acceleration is the same as before, and the speed is the same as before, and after running, it is the same as before, so this does not matter. This is mainly due to the slight slippage of the clutch plate, there will be this smell if there is friction, as long as the clutch plate does not slip, the vehicle can run, then it can continue to drive down without much impact.

    The clutch has a burnt smell. As long as this clutch does not slip, it can be opened normally without much impact. In other words, after the vehicle runs, the acceleration is the same as before, and the speed is the same as before, and after running, it is the same as before, so this does not matter.

    This is mainly due to the slight slippage of the clutch plate, there will be this smell if there is friction, as long as the clutch plate does not slip, the vehicle can run, then it can continue to drive down without much impact.

    Now the car doesn't move forward after releasing the clutch.

    This one is that the clutch has slight wear. As long as the speed can run, this doesn't matter much, you can drive normally.

    Is there any way to see if the car is skidding?

    The engine starts, then hits the brakes and engages into first gear. Then don't let go of the brakes. Then lift the clutch to see if the engine can be suffocated. If the engine is suffocated. That means that the clutch plate is not slipping and can be used normally.

Related questions
22 answers2024-07-02

The clutch smells burnt, indicating that the car has been in a semi-clutch state for a long time, and the clutch plate is seriously worn, and the car will shake very badly, so you should stop the car immediately and wait for rescue to replace the clutch plate.

7 answers2024-07-02

1.Find the right fulcrum of the left foot: It is not correct for some people to fix the fulcrum of their heel as soon as they get in the car and then move their toes or forefoot to find the control point. >>>More

11 answers2024-07-02

On the issue of abnormal noise of automobiles, it is difficult for ordinary car owners to distinguish which ones are abnormal noises and which ones are reasonable abnormal noises. Only nearly 20% of the vehicles that went to the repair shop to detect abnormal noises really had problems. In the case of a turbocharged engine, there is a must be a difference between the sound and the sound of a naturally aspirated engine; Models with engine guards may also make noises due to friction; After some car owners come into contact with different cars, it is likely that because of their own lack of understanding of mechanical knowledge, they should be cautious about the sound of the car to avoid wasting time and energy. >>>More

9 answers2024-07-02

The clutch should be in linkage or semi-linkage.

First of all, it is necessary to judge whether it is really necessary to wade and drive according to the situation at the scene, and if you can make a detour, it is recommended to take a detour; If things are not urgent, it is recommended to go back and wait for the water to be small. You have to know that once you fail to wade through the water, the trouble and loss caused to you is huge. Once you fail to wade through the water, you have to organize a tow truck, contact a repair shop, find a friend for help, and a series of troubles, plus the cost of repairing the car is more expensive than if you were on a plane. >>>More

11 answers2024-07-02

Theoretically: it can't be driven, if the car is going to be a distance, you can also drive, first find a place with fewer cars, first hang up a gear, and then ignite the car directly without stepping on the clutch, and the car will suddenly move forward. Then increase the gas pedal, and suddenly release the throttle after getting up to speed, and try to hang up 2nd gear. >>>More