-
Anonymous users2024-02-12There are four commonly used heating methods: electric floor heating, water floor heating, radiators, and skirting heating. When choosing heating equipment, you can not only look at the initial installation cost of the surface, but also consider it comprehensively, especially the operating cost of the future use process.
-
Anonymous users2024-02-11When heating, the radiator is manually turned on, and when the heating is not needed, the radiator is manually turned off, and the principle of heating is hot, cold and not insulation, which is very suitable for radiator heating, and the energy consumption of radiator heating can be saved by the length of time.
-
Anonymous users2024-02-101. If the thermostat is liquid crystal, you can adjust the temperature according to your time at home, and the temperature can be adjusted according to the time period you are at home.
2. If the thermostat is mechanical, it can be set at 10 degrees when you are not at home, and about 20 degrees when you are at home.
Do a good job in the following seven aspects:
1. In the determination of the power of the electric floor heating system, it is necessary to pay attention to the power of the electric floor heating system to match the area of the house, and try to avoid "small horse-drawn carts".
Second, in the southern region such as Shanghai, Hangzhou, it is suitable to use the dry pavement method. This paving method will make the electric underfloor heating system heat up faster and consume less electricity.
Third, the thickness of the heat storage layer should be appropriate. Due to the different living habits of the north and the south, the electric floor heating system in the south requires instant heating, and the heat storage layer can be a little thinner, while the north requires a better insulation effect and a slightly thicker heat storage layer.
Fourth, the steel wire mesh that fixes the heating cable cannot be ignored, because it can increase the strength of the concrete, and some installation companies may remove the steel wire mesh in order to save costs. Obviously, this destroys the insulation and wastes energy.
Fifth, the floor insulation material must choose the national standard products. Although the national standard product is higher, the bottom layer is made of insulation material with a thickness of 4 cm, which is 2 cm more than ordinary products, and the insulation effect is good. At the same time, do not ignore the role of corner insulation.
Sixth, the decorative layer is best to use marble, ceramic tiles and other materials. If the bedroom has a solid wood floor and the living room is made of marble, then the electricity consumption of the bedroom is 20 watts per square meter 30 watts higher than that of the living room.
7. Do a good job of building insulation of the inner and outer layers of the wall. The external wall insulation effect is better, which is suitable for new buildings, and existing buildings can work hard in indoor thermal insulation.
-
Anonymous users2024-02-09Hello dear! We'll be happy to answer for you. The floor heating can be heated with an air source heat pump device.
The air-based lead Qingyuan heat pump uses one part of electricity to do work, and absorbs more than 2 parts of free energy from the external environment, which can generate more than 3 parts of heat, and has a high energy efficiency ratio. The main parts of an air source heat pump are an evaporator, a compressor, a condenser and an expansion valve. Through the compression of the "refrigerant", the thermal cycle process of evaporation and absorption of heat in the environment is continuously completed, compression, condensation, throttling and re-evaporation, and the heat in the surrounding environment is transferred to water.
Electric underfloor heating is better. I've been preparing to decorate for the past two days, and I'm also looking at floor heating. After looking at water floor heating and electric floor heating, I feel that electric floor heating is better. >>>More
The winter in the north is very cold, and some families will install underfloor heating in addition to heating, so as to avoid stepping on the floor and feeling the chilling cold. The floor with underfloor heating will be very warm, and you can fall asleep directly by lying on the ground in winter. After one year of floor heating, there will be dirt on the inner wall of its pipes, and the thicker the dirt, the more affected the heating effect of floor heating. >>>More
1.Poor water quality of central heating and equal sharing of operating costs; >>>More
Through a number of tests, the use of the third generation of ecological floor heating heating, the operating cost of 15 per square meter of the use of capillary network to create the third generation of ecological floor heating, because of its heat dissipation of up to 135W per square meter to make the use of "cold water heating" become a reality, 35 degrees of low inlet water temperature to improve the COP value of the heat pump unit, creating a new era of full use of low-grade energy, in line with the national policy of "energy saving, emission reduction and consumption reduction, improve building quality" advocated by the state. The unique parallel structure greatly reduces the resistance of the pipeline, so that the temperature attenuation is minimized (the indoor surface temperature difference is controlled within 1 degree), which completely solves the problem of excessive temperature difference between the beginning and end of the traditional ground coil pipe due to large water conservancy loss, and the indoor temperature is more uniform and the comfort is greatly improved. >>>More
In the general market, there are domestic, joint ventures, imports, and now floor heating is more common and the technology is more perfect, so the domestic ones are not bad, and the domestic ones are relatively cost-effective.