How long to stick the bathroom wall tiles

It can last for three to five years;

Its practical adhesive tiles are faster than cement tiles, and firmer than cement tiles;

The bathroom has a waterproof layer, and direct use of glue for a long time may damage the waterproof layer;

After pasting with glue, and then tapping the tile surface with your fingers, the sound of each piece is the sound of hollowing tiles; So I don't know if the piece is firm or not, in case someone showers in the bathroom and the bricks fall off, the consequences can be imagined;

With adhesive paste, it is difficult to remove the tiles for the later secondary decoration.

The ground area is divided by the area of each floor tile, 600 * 600 is squared, 800 * 800 is square, the number of kicking angles is the perimeter divided by the length of the bricks (600 bricks with 600 long boards, 800 bricks with 800 long boards) plus 4 or 5, wall tiles are the perimeter multiplied by (floor height - ceiling height) general meters, and then subtract the area of the door, the window does not need to be reduced, because there is loss. Divide the wall area by the wall tile area, 300*450 is the square.

The amount of floor tile accessories area * paving height * cement (bag).

Area * paving height * amount of sand (square).

The amount of auxiliary materials for wall tiles Area * paving height * cement (bag).

Area * paving height * amount of sand (square).

Floor tiles are paved dry, wall tiles are wet paved, and the bathroom door stone must be wet paved (waterproof) The cement of the floor tiles is better, and the cement of the wall tiles is inferior (because the good solidification is too fast and easy to crack the wall tiles).

The bathroom is a very important existence, so what should I do if I encounter a bad patch of bathroom tiles during decoration? Let's take a look at the bathroom safety tips: do you want to use tile glue for bathroom tiles"Tile adhesive" is widely used as an indispensable decoration material in home decoration, and its cement-based binder composed of polymers and other special formulas can be used in almost all kinds of existing tiles.

The use of tile adhesive makes the decoration of kitchen and bathroom have the following advantages:

Good water retention, not easy to produce hollow drum; The bonded orange cherry has high strength and does not fall off; Reduce the load-bearing capacity of the building, from the amount of cement required by traditional paving from 11 18kg per square meter to 4 5kg of tile adhesive, so as to reduce the occurrence of building settlement and cracking;

How to choose bathroom tiles is also what we have to consider, the purchase of bathroom space tiles on the quality of the tile itself is more stringent. When buying ceramic tiles, you can observe from the side whether the brick surface is flat and whether there are pinholes of uneven thickness. At the same time, you can tap the tile to listen to whether the sound is crisp, the more brittle the sound, the higher the texture density of the tile, the better the hardness.

After the bathroom is tiled, it is better to use it for a long time.

If the bathroom is ventilated, it can be used for two days.

If you don't ventilate, it's best to wait a few more days. If you don't, it's a blank post.

The floor tiles are made of a mixture of cement and yellow sand, mainly yellow sand, with only a small amount of cement, and it is basically relatively dry, and it does not need to wait for a long time to solidify.

When laying the floor tiles, after being hammered hard by a rubber hammer, it has been mixed with the yellow sand below, and it does not move its position very much. Protect the tile when paving, do not scratch the brick surface and pollute the brick surface.

Walking around on the brick surface that does not dry and solid, painting the wall, and painting the floor without using protective film are often occurring in the process of construction, which will cause damage to the tiles.

Look at the local climate, normally after a week.