The car is ignited with electricity. Does the other party s car need to be turned off?

No, you can, as long as the battery of the other party's vehicle is sufficient.

Delayed flameout: 1. First of all, the car should be turned off and should pay attention to the delayed flameout, which is good for the engine, just like people need to walk slowly after running fast to fully recover, so after reaching the goal, when the engine is turned off, you should pay attention not to turn off the key immediately, you can tidy up the items in the car, close the windows, and the delay shutdown time is best about 30 seconds.

2. Vortex pressurization.

After stopping, the engine and turbine have enough time to cool and lubricate before turning off, which can protect the engine and help the engine and water temperature to cool down; In colder weather, you can start the car first and let him warm it up.

No need to turn off the heat. An engine is a machine that can convert other forms of energy into mechanical energy, such as internal combustion engines (reciprocating piston engines), external combustion engines (Stirling engines, steam engines, etc.), jet engines, electric motors, etc.

The main advantage: the external combustion engine, that is, its fuel in the external combustion engine of the engine. The engine converts the heat energy generated by this combustion into kinetic energy, and Watt's modified steam engine is a typical external combustion engine, when a large amount of coal combustion produces heat energy to heat water into a large amount of water vapor, high pressure is generated.

It is best not to turn off the engine, because if you don't turn off the engine, it is the electricity of the other party's vehicle generator, and after the engine is turned off, it is the electricity of the other party's vehicle battery, which is not good for the battery, so it is best not to turn off the engine.

No, you can, as long as the battery of the other party's vehicle is sufficient, hopefully.

1. Confirm that the battery that is out of power has the same voltage as the battery responsible for rescue. Car batteries are usually 12 volts. Trucks or tractors may operate on a 24-volt system, or sometimes two 12-volt batteries combined to form a 24-volt system.

Never connect a 12-volt battery to a 24-volt battery.

2. Arrange the vehicle so that the two car batteries are close enough to facilitate the connection of jumper cables to each other. Make sure that the two cars are not touching.

3. Turn off the engines of both vehicles. Open the hood of each vehicle.

4. Turn off the headlights, wipers, radios and all accessories of both cars. Unplug anything plugged into the cigarette lighter to charge. They waste electricity and can be destroyed by surging power surges.

5. Untie the jumper cable. The cable clamp is designed to hold the soft metal part of the battery clamp, which is connected to the battery binding post. Never connect the negative electrode to the positive electrode, so do not connect the cables in series. This may damage the electronic device.

6. Visually inspect the two batteries for cracks, leakage and damage. If you have any of the above issues, stop the jumper. Contact the trailer and never attempt to jump over the car, or even connect cables.

7. Connect the red clip to the positive (+) binding post of the dead battery. Then connect the other end of the red clip to the positive (+) terminal post of the battery in good condition

8. Connect the black clip to the negative (-) binding post of the battery in good condition.

9. Connect the only remaining clip (the black clip of a dead battery) to a sturdy grounded metal (preferably clean and unpainted) on a dead car. Avoid connecting this clip to the negative terminal post of a dead battery, and only do so if you have no way to do so.

10. Start the vehicle well so that it can charge its own battery and a dead battery at the same time.

11. Hold idling for about 5 minutes before starting another car (no power). Never empty your motivation quickly. Try starting a vehicle that is out of power.

12. Unplug the jumper cable on the vehicle in the reverse order of the connecting cable (first unplug the negative pole (the clip connecting the grounding metal), and then go to the positive pole).

13. Let the engine of the car that ran out of power just now run at a speed slightly higher than the idle speed for at least 20 minutes to charge the battery, and that's it.

Of course, don't fire first, just borrow the battery to use it, the positive pole of your own battery with the positive and negative poles of other cars can take the iron of the car, () It is said that smart cars can not directly take the negative pole of the battery, I don't know whether it is true or false) and then your own car can be ignited.

Connect the wire and then ignite, first connect the positive electrode.

1. Take the wire: This is a necessary item for the car to take the electricity, do not take two wires to make do, because the instantaneous current of the vehicle at the start can reach 200-600A, and the diesel car even reaches 1000A, if it is calculated, 10 square copper wires can ensure the smooth and safe start, so the car battery connection line must buy the right brand, the quality is the best, do not try to be cheap. This is one of the must-have items in the car, once the battery is out of power, you can take it out and use it, and you can also help others when you don't use it.

2. Emergency power supply: This is a new type of power bank like a thing, there are two kinds of lead-acid and polymer lithium battery, which can help the vehicle with a loss of power to start, and can also have lighting, charging mobile phones and multi-functional supplies used with an inflatable pump to inflate the car. And it is generally portable, very lightweight, if you have it, you don't have to ask others for help.

Be sure to charge it in time after use and keep it full of power to deal with emergencies.

3. Positive, first connect the positive: first turn off all the electrical equipment on the car, make the key in the OFF position, open the cabin cover to find the battery, there are positive and negative poles written on the battery, generally the red "+" sign is the positive pole, and there are generally two wires, at this time, take out the red one, open the battery cover, pinch the clamp on the head to clamp firmly the positive pole of the battery of the electric car, and the clamp at the other end to clamp the positive pole of the battery of the rescue vehicle. Be sure to connect the positive electrode first, then the negative electrode, do not reverse the order, and do not use the battery clamp to touch anywhere except the battery pile head.

4. Negative connection, negative connection: After the red positive electrode is connected, take out another wire, first clamp the negative pole of the tram battery, the negative electrode is generally black "—" number, and then pinch the other end of the clip, from beginning to end the clip do not touch other places, to clamp the negative pole of the rescue vehicle battery, when the connection will pop out of the electric spark, please don't be afraid, this also shows that you are right. The reason why the negative electrode is not connected first is because the whole vehicle is basically a negative electrode (that is, commonly known as "tie iron"), if the negative electrode is connected first, when connecting the positive electrode, the clip will cause a short circuit and burn the parts on the car when it touches any conductive place in the body.

5. After starting the vehicle, first remove the negative, and then dismantle the positive: after the battery is connected, the rescue vehicle will first ignite and charge the battery, and then the no tram enters the vehicle to open the key, at this time the instrument light will be lit smoothly, and then try to ignite (not more than 5 seconds), if it fails to start smoothly, step on the accelerator of the rescue vehicle, and the speed is kept at about 2500 rpm, and then the tram is ignited again, if the starter is no problem, the car has oil in the case of general can be started smoothly, after the non-electric vehicle starts, Remove the negative clamp first, then remove the positive clamp, for the same reason as why the negative pole is followed by the fourth one.

The positive and negative poles of the battery must not be reversed, and the order of assembly and disassembly should be strictly in accordance with the order of first connecting the positive and then the negative, and the first dismantling and then the positive.

Summary. Dear, hello, the reason why the car turns off after starting is that the time of the battery is too short, in the case of serious battery loss, when the battery is powered, it is necessary to wait for about 10 minutes, because the battery has no power at all, and the current of the generator in a short time can not maintain the power supply system of the whole car, so do not unplug the external power supply in a hurry, you can charge it for a while.

The reason why the car starts and turns off Sun Chan is: the time of the battery is too short, in the case of serious battery loss, when the battery is powered, it is necessary to wait for about 10 minutes, because at this time the battery has no power at all, and the current of the generator in a short time can not maintain the slow rotten power supply system of the whole car, so do not unplug the external power supply in a hurry, you can charge it for a while.

Other reasons for the car to start and turn off after the power are caused by the fact that the generator does not generate electricity, under normal circumstances, the car is not maintained by the power of the battery when the car is normally held and transported, but after the power is out, the car will still turn off through the external power supply, that is, there is a problem with the generator, and the new generator needs to be replaced due to the use of the battery for a long spine balance time, and there is no regular maintenance, which will also cause the battery to age, resulting in the situation of flameout. If the battery is properly maintained, it can generally be used for about 5 years, so it is necessary to pay more attention to the rules of use of the battery in ordinary times and try to make its service life longer.

5-10 minutes. Pay attention when taking the battery: the battery power loss is too serious, and there is no power in the battery, which will lead to still not being able to play. At this time, you only need to add the throttle to the electric car, charge the electric car for a while, about 5 minutes, and then start it.

If it is confirmed that it is a vehicle battery.

If the power is lost, you need to find other vehicles or batteries to rescue you. The front of the rescue vehicle should be as close to the front of the rescued vehicle as possible, so as not to be too far away and the length of the wire is not enough.

Master Feng, a maintenance master with many years of experience, said that it is best to turn off the power of the rescue vehicle first during the rescue, so as not to cause a short circuit in the vehicle circuit and damage to the vehicle's electronic equipment due to negligence by connecting the positive and negative poles of the battery.

I have heard that some car owners did not turn off the power of the vehicle when taking the power, and connected the positive and negative poles in the opposite direction, which finally caused the vehicle's audio system to fail. Therefore, it is best to wait for the cable to be confirmed to be connected correctly before turning on the power to start the vehicle.

The car can be turned off at least 1 hour after the car is out of power, and all electrical equipment must be turned off before the ignition. If the car battery is not used for a long time, it will slowly discharge itself until it is scrapped, so the car should be started every certain time to charge the battery.

It is recommended that after the vehicle starts, the car can be kept running to give the battery more power for a while.

This can generally be turned off after 15 minutes.

Dear customers, yes, battery connection method: 1. Connect one end of the hitchhiking line with the positive pole of the faulty vehicle battery, and the other end of the hitchhiking line is connected with the positive pole of the rescue vehicle battery. 2. Connect the negative pole hitchhiker wire with the engine block itself or the metal parts on the cylinder block of the faulty car, and connect the other end with the rescue vehicle cylinder block or the tie iron part.

Do not connect the cable to the negative terminal of the battery (it will cause a spark to ignite the explosive gas escaping from the battery).

There will be no effect on the battery.

The car battery is out of power, and even the battery of someone else's car is on fire, and then the car generator is used to charge the battery.

When the car starts, you need to rely on the battery to ignite the gasoline engine, and even after the other batteries are on fire, you can disconnect the other batteries and let the car idle for a period of time, in fact, let the generator charge the battery, in case the car turns off and can't hit the car.

Summary. Hello, the vehicle battery is discharged, in the case of the normal battery of the generator is not damaged, you can turn off the engine after 20 minutes of starting in situ, 20 minutes of charging time can meet the power requirements of the next start, it takes 2 3 hours to fully charge, there is no need to rush for such a long time, after 20 minutes of charging, as long as you can drive 20 30 minutes a day, you can slowly fully charge the battery. There is a time limit for the first reply, if you have any questions, you can reply and answer them in detail.

How long does it take to turn off the car after the car is discharged?

Hello, don't click to end, I'm textual to give you the full answer, 2-3 minutes.

Hello, the vehicle battery is discharged, in the case of the normal battery of the power generation rental pickpocket machine is not damaged, the tansun can be turned off after 20 minutes of starting in situ, the charging time of 20 minutes can meet the electricity requirements of the next start, it takes 2 3 hours to fully charge, there is no need to rush for such a long time, after 20 minutes of charging, as long as it is guaranteed that it can drive for 20 30 minutes a day, the battery can be slowly fully charged. There is a time limit for the first reply, if you have any questions, you can reply and answer them in detail.

Open for 20 minutes, and you can play tomorrow!

As long as there is no problem with the battery, the generator is normal, and the idle speed for 20 minutes is enough to start the Ling tremor tomorrow.

Summary. Hello, yes.

To power other cars, you need to turn off the engine, and the method of taking the electricity is:

Take out the red positive pole and take the wire, connect one section to the positive pole of the battery of the rescued car, and connect the other end to the positive pole of the ambulance;

The negative wire is also connected in this way, pay attention to the metal part of the wire in the process do not touch other metal parts of the body;

Try to start the vehicle quickly after wiring, because the battery is charging after it is connected, and it cannot be charged after the two batteries are balanced.

The car is ignited with electricity. Does the other party's car need to be turned off?

Hello, if you want to power other cars, you need to turn off the power, the method of taking the power is: take out the red positive pole and take the wire, connect one section to the positive pole of the battery of the rescued car, and connect the other end to the positive pole of the ambulance; The negative wire is also connected in this way, pay attention to the metal part of the wire in the process, do not touch the rough draft and touch the other metal parts of the body bench; After wiring, try to start the vehicle, because the battery is being charged after it is connected, and the two batteries cannot be charged in Qiaoxiao after they reach balance.