Fishing bait skills, bait rubbing generally adjust a few fishing times

The first is the state of rubbing the bait, to make it into a peanut-sized bait ball, put it into the water for 2-5 minutes after atomization.

The second is the soft and hard procedure of rubbing the bait, touch the softest part of your earlobe at the bottom, and the hardness is about the same.

The third is to use rubbing bait and do not add brushing powder, many people add it, wrong, that will affect the atomization effect.

Fourth, you can add some snow powder to the bait, and the atomization effect will be better.

Fifth, don't make a big bait ball, but let it loose in the bait pot and rub it to the hook when you use it.

Sixth, put the good rubbing bait in the basin and do not knead, the more you knead, the more sticky it will become, and destroy its state.

Ordinary rubbing bait generally adjusts two fishing two, the specific fishing target should be based on the fish and water conditions to make specific considerations, but also consider the state and weight of the bait, generally the first empty hook to determine the tune, and then hang the bait, put a long water line, adjust the two fishing two.

When the adjustment is determined, it is carried out in the state of suspension of the plumb sinker and the empty hook, which is generally called the semi-water drifting, if the water is relatively shallow, the empty hook can be off the bottom, and I don't know the depth of the water to hang a heavier thing on the hook to find the bottom, and then move the float down about 20 centimeters to determine the tune, and the tune is generally determined to be about three eyes.

The method of drifting will also be affected by the size of the bait and the thickness of the drifting tail, for example, when adjusting 4 fishing 2, the bait may be larger, the drifting tail of the fish drift is relatively thin, the hook and bait may be in a vertical state, and the hook and bait will be in a completely floating state if the bait is relatively small.

The selection of the adjustment should be within the total number of floats, and if it is outside the range, the adjustment must be changed again. When the eye fishing is high, it is dull, the specific choice should be based on the actual situation, the general bite hook is slower than the fish to adjust the spirit of the eye, the more ferocious fish to adjust the pause.

If the fish signal is accurate, it will be accurate, and if the fish signal is not accurate, the rod will often disturb the fish and cause the phenomenon of running fish.

The shapes of rubbing bait are: droplet-shaped, poured droplet-shaped, round strip-shaped, oval-shaped, and spherical. Different fish are suitable for different shapes, and we need to choose according to the characteristics of the fish.

Let's talk about some tips in rubbing bait:

First, when we rub the bait, we can mix it according to the ratio of one to one, and we can add some snowflake powder to increase its atomization effect, and do not add brushed powder, which will affect its atomization effect. It can also be pinched into an irregular shape, and it can also increase the atomization effect.

Rub the bait. Second, in order to prevent the bait from falling off, you can put 1:0.9 water and 0.1 glue when blending.

Third, when opening the bait, be sure to use your fingers to draw in circles and rest for a while.

Fourth, keep the bottom of the hook parallel to the bait when rubbing the bait, so that when the fish eats the bait, the mouth will be deeper.

Only by mastering the correct skills in groping again and again can you better improve the hit rate.

Fish.

Wild fishing bait should be reasonably adjusted according to the specific gravity of the bait, the fish condition, and the silt at the bottom of the river. For carp and other large fish, it is recommended to raise the mesh and fish for high mesh, such as: 18 mesh floating drift 8-9 mesh fishing 4-5 mesh.

Fishing for small fish such as crucian carp, the bottom of the river is a hard bottom, you can adjust the middle mesh to fish the low mesh, such as: 18 mesh floating drift to adjust the 5-6 mesh to fish 2-3 mesh.

Generally, when using rubbing bait for fishing, the amount of bait is larger than the amount of bait pulled, but this process not only refers to the size of the bait group, sometimes because the bait is too large, resulting in the fish not easy to eat, it will also be relatively small.

In fact, in addition to the size of the bait group, the amount of bait refers to the precise range of the maximum amount of bait into the den by rubbing the bait. Because in most cases, in the process of pulling the bait, the bait begins to atomize and scatter when it enters the water, and falls off in the process of the bait drifting off, and the bait that actually reaches the den is incomplete, but it happens to be these particles or crystals, which are the key to attracting fish or big fish preferences, which is conducive to the characteristics of nesting.

In some specific fishing conditions, the fish is not very good, but it is not without a mouth, sometimes a rod down, the fish will take a long time to give, eat the mouth of the pause. But before that, any eating action is prone to empty rods, which is what we call palatability. In this case, we can send a small bait to fish, and it will be easy to catch the fish.

This shouting envy is Zheng Ming, who everyone initially used to rub bait, entry-level theory, in fact, there are several reasons for this problem.

Under normal circumstances, when we pull the bait into the water, the bait will expand and lose part of the bait when it falls to the fishing den, sometimes it is the bait itself, sometimes it is because, occasionally there are small fish to eat, but after arriving at the den, the bait will become smaller, at this time, the small individual fish, it is easier to eat the bait, so with the bait, it is easier to get on the big fish.

When we use the bait directly, although the size of the bait will be maintained, the same as the size of the bait, but the density and weight of the bait will significantly exceed the bait, at this time after the expansion of the water, even if there are small fish to share the food, it will not be too easy, this relatively large bait density of the bait, it will avoid the small fish to eat the mouth, and the big fish will be more interested.

1. Ordinary rubbing bait is generally adjusted to two fishing two, the specific fishing target should be based on the fish and water conditions to make specific considerations, but also to consider the state and weight of the bait, generally the first empty hook to determine the adjustment, and then hang the bait, put a long water line, adjust the two fishing two.

2, the adjustment of the eye in the determination of the time are carried out in the state of the suspension of the lead sinker and the empty hook, generally called the cheating to do half water drifting, the water is relatively shallow, the empty hook from the bottom can be, do not know the depth of the water to hang on the hook on the heavier things to find the hail open bottom, and then move the float down about 20 centimeters, determine the mesh, the mesh is generally determined in the three eyes or so.

3. The method of adjusting the drift will also be affected by the size of the bait and the thickness of the drifting tail, for example, when adjusting 4 fishing 2, the bait may be larger, the drifting tail of the fish drift is relatively thin, the hook and bait may be in a vertical state, and the hook and bait will be in a completely floating state if the bait is relatively small.

Practice makes perfect, there is no specialized skill.

How to open a rubbing bait:

Compared with pulling the bait, it is easier to open the bait, which may also be one of the biggest factors for the majority of anglers to like to rub the bait.

The general direction of the open bait and the pull bait are the same. The difference is that rubbing bait generally does not add or less brushing powder. (Of course, sometimes you can also use a good bait to rub) the proportion of bait water must be mastered, and the specific proportion is uncertain. It is flexible according to the water absorption of the bait, and it should not be too hard.

It should not be too soft, it should be elastic, and the softness should be similar to that of the earlobe. Be sure to make the bait absorb water sufficiently and evenly, and control the viscosity of the bait by the number of times you stir it.