-
Cleaning steps for the filter of the air conditioner:
1. If the air conditioner filter is dirty, the dust on the filter screen may gather on the surface of the evaporator along the gap, and then flow into the water tray with the condensate.
2. If the air conditioner filter is dirty but not cleaned in time, the dust on the filter screen may enter the back of the evaporator with the fan, causing the evaporator to be blocked, resulting in water leakage of the indoor unit.
3. If the air conditioner filter is dirty but not cleaned in time, the owner turns on the air conditioner, the fan motor will start running, and the dust may slowly gather on the fan motor blades, which will make the spacing of the blades smaller, the blowing volume will be smaller, and it will make a loud noise.
4. If the air conditioner filter is dirty but not cleaned in time, if the air conditioning refrigeration function is turned on, the air temperature blown out of the indoor unit will be very low, but it will not blow far, which will lead to the phenomenon that the temperature near the air conditioner is low and the temperature of the whole room is very high.
How often should the air conditioner filter be cleaned?
1. For household air conditioners, if they are not in areas with more oil smoke or large sandstorms, it is best to clean the filter once after 300 hours of use. If it is in an area with a lot of oil smoke or sand, the air conditioner should be cleaned once after 100 hours of use.
2. When cleaning the air conditioner filter, first open the front cover of the air conditioner, then pick both sides of the panel, and pull it open hard to see the filter, the filter screen is without screws, so it is easy to take it off.
3. The filter screen can be cleaned with clean water or a hair dryer, pay attention to the small intensity when cleaning, otherwise it is easy to damage the filter. After washing, let it dry in the shade.
-
The cover is removed and the filter can be taken out for cleaning.
-
Here's how to clean the air conditioner filter:1. Find the air inlet grille on both sides of the air conditioner and pull out the filter screen with a little force, and rinse it with water below 40 degrees.
2. If it is dirty, you can use a soft brush to gently scrub it, wash the filter screen, shake the water dry first, and then put it in a ventilated and cool place to dry naturally.
3. During the drying process of the filter screen, you can wipe the air conditioner with a rag, which is conducive to the use of the cleaned filter screen in a clean environment, and finally the cleaned filter screen can be installed.
-
The filter inside the air conditioner needs to be cleaned regularly to avoid affecting the cooling effect. How do you clean the filter of an air conditioner? PChouse will take you to find out.
First, open the front cover of the air conditioner and remove the filter; Then clean the filter with a vacuum cleaner or clean water, if there is oil on it, you can also use a soft brush dipped in detergent to scrub it; Then dry the washed filter and put it back. Liang Yewu, however, should pay attention to the fact that the strength should not be too large, nor should it be cleaned with too hot water, so as to avoid causing the filter to deform and fade. After cleaning, it is installed back on the air conditioner, and after cleaning, the air ridge is mainly dirty, and it should be cleaned every summer before it is opened.
Generally, it is said that you don't have to clean it yourself. Because of the need for professional cleaning and maintenance, and because the current air conditioner is a heat pump unit, the indoor evaporator and the outdoor condenser are replaced in summer and winter, especially in the defrosting process, the evaporator self-cleaning can be achieved to a certain extent.
-
For the air conditioner at home, after a few years of use, if you stop using Tanwu for a period of time and then turn on the air conditioner, the wind blowing out at this time basically has a smell. This means that our air conditioner is polluted and needs to be cleaned. If you want to clean the filter of the air conditioner, the first thing to do is to take out the filter of the air conditioner, and if you want to take it out, you can follow the instructions on the manual, but remember to disconnect the power supply.
We can soak the filter of the air conditioner in detergent and wash it for about 20 minutes. The main function of the air conditioning filter is to protect the evaporator. Once the evaporator's fins are dirty, it is very difficult to clean – if the filter is not cleaned for a long time, it will contaminate the evaporator.
<> general evaporator cleaning, the air conditioner has been used for a long time or the filter has not been cleaned for a long time, and the air conditioner will be cleaned for a short time if the environment is very dirty or there are pollution sources. Enclosure cleaning. First of all, use a wet towel to clean the shell part of the wall-mounted machine, then open the outer cover of the wall-mounted air conditioner, and clean the inside of the outer cover.
The outdoor unit is also relatively simple to clean, you can use a brush to brush off the dust, if you want to further clean, you can use water to rinse, the water flow can be large, but the water pressure should not be too strong, to prevent the deformation of the aluminum heat dissipation substrate, affect the ventilation, affect the heat dissipation effect.
Spray air conditioner cleaning agent on the air conditioner fins, this kind of thing is also sold online, and it is not expensive. After spraying the cleaning agent evenly on the fins, it is enough to wipe it off. When cleaning the heat sink, we need to use a special cleaning agent to spray the heat sink up and down several times, let it stand for about 5 minutes, let the cleaning agent and the heat sink fully contact and kill the bacteria attached to it.
If you inhale the air blown by the dirty air conditioner for a long time, not only will the above symptoms occur, but also cause a series of respiratory diseases such as asthma, pneumonia, pharyngitis, and bronchitis. Before cleaning the air conditioner every time, it is necessary to unplug the power supply first to avoid danger. Everyone must pay attention to safety when cleaning the air conditioner by themselves.
-
1.First of all, turn off the air conditioner, unplug the power plug, remove the dust filter according to the manual, and pay attention not to touch the metal part of the indoor unit when disassembling to prevent it from being scratched.
2.After removing the air filter, gently pat or use an electric vacuum cleaner to remove the dust. If the dust filter accumulates too much dust, it can be rinsed with water or dipped in neutral detergent with a soft brush, but the water temperature should not exceed 50 or more during cleaning, and washing powder, dish soap, gasoline, banana water, etc. cannot be used to avoid the deformation of the dust filter.
Also, do not clean with a sponge, as this will damage the surface of the dust filter.
3.After rinsing with clean water, wipe dry with a soft cloth or put it in a cool place to dry, never expose it to the sun or dry it in an open flame such as a stove, so as to avoid the deformation of the dust filter.
4.To clean the panel, gently wipe with a soft cloth dampened with warm water or mild detergent, then dry with a dry, soft cloth.
-
Hello, thank you to the company to know the question.
Before disassembling the air conditioner filter, carefully open the air conditioner shell, generally the air conditioner shell is stuck with two small card slots, and gently pull the outer cover outward.
After opening the outer cover of the air conditioner, there are often two buckles inside, and it is necessary to gently pick open the outer cover to fully open. Then it is to take the filter, the filter is relatively easy to take, but it is stuck by a few card slots, first push the filter up, and then gently drag the filter down after the card slot.
After removing the filter, some air conditioners have black particles that strengthen the filtration, which should be removed separately to be cleaned and dried.
Then carefully rinse the filter with clean water and wash the blind ears several times, you can use a soft brush to scrub it several times, and finally dry it in a ventilated place until it is dry. Be sure not to bend the filter when cleaning, although it is elastic, but the plastic one can not withstand bending.
You are welcome to ask the company questions again.
We wish you a happy work life
Cut off the power supply, unplug the power supply, and turn off the air conditioner. How to clean the filter of Haier vertical air conditioner and remove the front panel of the air conditioner. Unscrew the screws with a screwdriver to remove the front panel of the air conditioner. >>>More
How to remove the Midea air conditioner filter? 1.Before disassembling the cabin air filter, carefully open the cabin air conditioner case. >>>More
The steps of Gree cylindrical air conditioner cleaning filter are as follows: >>>More
1. Before cleaning, you need to disconnect the power supply of the air conditioner, and then separate the wind deflector from the whole, this step needs to be operated from both sides of the air conditioner. >>>More
Before disassembling the cabin air filter, carefully open the cabin air conditioner case. Generally, there are two small slots in the air conditioner shell, and the outer cover can be gently pulled outward. After opening the cover of the air conditioner, there are often two buttons inside, which need to be gently opened to make the cover fully open. >>>More