Is it good to decorate the floor groove and walk the circuit, and it is better to groove or not to g

I think it's still very unsafe to decorate the floor groove and take the circuit, and it is difficult to repair it if it fails.

Hello dear, happy to answer your <>

Answer: The purpose of ground slotting should be slotted on the ground. Slotting, mainly for aesthetics, to avoid too messy wiring; In addition, the slotting is also to avoid workers stepping on the flat wire to burn the rent pipe during construction; At the same time, it is also conducive to later maintenance.

The ground has a decorative layer that can be slotted. Slotting is not to say that it can be opened, if the ground has a decorative file, you can slot, otherwise, it is not recommended to slot. I install floor heating without slotting.

If you want to use floor heating for home decoration, don't slot, so as not to affect the floor heating of the row section. Solid wood floors do not need to be slotted.

The case of ground grooving

Houses with a cement pouring layer thickness of more than 3 cm are required to be carried out, which means that the depth of cutting is 3 cm, and the steel bars and sand and gravel concrete of the floor slab cannot be seen. If the developer has installed underfloor heating when handing over the house, it does not have the conditions for slotting.

The advantage of slotting is that it can effectively protect the finished product of hydropower pipes, and it is not easy to be destroyed after sealing the groove, reducing the probability of hollowing the ground tiles, if the floor can save a little layer height, it is more conducive to keel laying for solid wood floors, and there is little difference between the floor tiles; It is more convenient to lay insulation boards for underfloor heating. Related topics: Everything about floor heating, you will understand after reading it.

The disadvantage is that the slotting requires cutting the floor slab, which is not conducive to the structural stability of the house, and there is an additional expense.

Is it okay if the ground is not grooved?

Of course, you can, especially if you are preparing to lay floor tiles, it basically has no effect on the floor height. But be aware of the following:

1.Pay attention to the protection of the finished hydropower products on site, add wooden planks on both sides of the conditional conditions, and supervise the site before the bricklayer enters the site if there is no condition, so as to avoid damage to the hydropower pipeline caused by heavy object stacking, cutting and processing.

2.Keep a 2cm spacing between the two parallel pipes, and fix every 50cm length with pipe clamps to reduce the probability of tile hollowing.

If you don't open it, you have to level it, and the leveling will increase. Of course, if you're all tiles, you can leave it unopened. Wooden floors must be opened.

Does the ground need to be grooved for hydropower construction? Is it necessary to spend more slotting fees? Listen to what the thick craftsman has to say.

1.The ground is covered with composite flooring (the floor mat treasure is not paved below or the floor mat treasure below 2 cm) The ground is slotted, and the groove after the pipe is lined up should be flattened with cement powder, which is convenient for the later floor laying.

2.The floor is covered with laminate flooring (paved with more than 3 cm of floor mats), and the floor can be slotted without slotting.

3.The floor is covered with solid wood floors or multi-layer boards (the ground is equipped with wooden keels), and the floor can be ungrooved.

4.The floor tiles can be laid without slots.

5.The wall surface of the latex paint wall must be slotted.

6.The wall is tiled, and the wall must be slotted.

7.There is a ceiling line pipe on the top surface, and there is no need to slot it in the roof directly.

8.There is no ceiling on the top surface, and the top surface can not be slotted, and the top surface cannot be PVC pipe. You can wrap the wire with adhesive tape or go directly to the top with a sheath wire.

If you are tile, you can leave it open.

There is no clear specification, but it is generally slotted.

You must pay attention to see what main materials you want as a consumer, and each main material connection point is different. In particular, it is not possible to read from the script. I have also written a lot of decoration knowledge manuals for the Chongqing market.

When laying pipes, it is best to fix them with line cards, which are more stable and less hollow when laying the floor. After the line card fixes the pipeline, it can sink under the pipe when backfilling the yellow sand cement, and the pipe is more stable and not loose. It is conducive to the later laying of floors.

<> this one is walking on the ground without a suspended ceiling. If you lay floor tiles at home, we can directly lay line pipes on the floor floor, the maximum line pipe at home is 20 pipes, and there is no problem at all in laying in the protective layer of floor tiles, only need to deal with the cross position, and there is no problem with water pipes; However, like the company, I can also prescribe a lot of reasons that you can't argue with to let you groove the ground or go to the top of the line pipe, but I will definitely not ask for less money, and I will not be rewarded for why I should pay extra money. It's a pity that the county seat is not big, and I don't see you when I look up, and there are many acquaintances who <>

Many people think that it is dispensable, but it is not. First, the ground slotting will not affect the load-bearing structure of the house; Second, in addition to the beauty, the ground slotting can protect the hydropower lines well. Increases its service life and avoids accidents caused by floor damage to water and electricity pipes.

If you want to change the water and electricity to groove on the floor, I have also seen that decoration companies generally do this, especially in some large places. If there is a leveling layer, you can slot, if the house does not have a leveling layer, then it can not be slotted, because the thickness of the floor without a leveling layer is generally not more than ten centimeters, if you slot, it will affect the floor structure, causing potential safety hazards!

If you don't need to change the door hole or other things at home, you can start to do water and electricity decoration! So, when doing water and electricity wiping, can the ground not be slotted! Deviate the pipeline from its original route.

Therefore, all ungrooved pipes will not go exactly in the predetermined direction after the renovation is completed, and will deviate somewhat - if the cement is not marked correctly, it will even cause damage to the pipes during the pouring process.

No, because the slotting protects the water and electricity lines and does not affect the load-bearing.

It is also possible to connect the hydropower equipment without slots, and you can choose to use holes to connect the hydropower equipment into it.

OK. It is also possible to dig in the wall, this method is still possible.