How to clean stainless steel screens, how to clean rust on screens

There is rust on the screen window, let's take the diamond net anti-theft screen as an example to make a detailed explanation.

The rust removal methods of diamond mesh anti-theft windows mainly include the following: mechanical methods: sandblasting cleaning, shot blasting with glass or ceramic particles, sensitization, brushing and polishing.

It is possible to wipe off the contamination caused by previously removed materials, polished materials or obliterated materials by mechanical methods, and the surface of mechanical cleaning should be properly cleaned under dry conditions, and it is recommended to re-polish with polishing equipment and seal with polishing wax after mechanical cleaning.

Chemical method: Pickling paste or spray is used to assist in the re-passivation of the corroded part to form chromium oxide.

The film regains its resistance to corrosion, and after pickling, it is important to rinse properly with clean water in order to remove all contaminants and acid residues. After all treatments, re-polish with polishing equipment and close with polishing wax to prevent the diamond screen from rusting again.

Diamond mesh screens.

If rust is caused by oxidation, you can use a knife to gently scrape off the aluminum rust, then wash it with soapy water, wipe it dry with a dry cloth, and then polish it with a dry cloth after applying wax oil, which will be smoother as new.

In the use of diamond mesh screens, the action should be light, and the push and pull should be natural; If you find that there is difficulty, do not deadlift and push, and the fault should be eliminated first. Dust accumulation and deformation are the main reasons for the difficulty of pushing and pulling diamond mesh doors and windows, and it is necessary to keep the door frame clean, especially the cleanliness of the sliding groove. A vacuum cleaner can be used to suck up the dirt in the trough and the door seal.

1. First of all, you can wash it with vinegar, but it is best to use a high concentration of vinegar, the effect will be better, the effect of rice vinegar is not good, and you can also use other low-concentration acids. Acidic disinfectants are also available. 2. In addition, you can also squeeze the juice with fresh lemon, apply it to the rust spots, repeat it several times until the rust spots disappear, and finally clean it with soapy water.

Wipe and clean the anti-theft screen while dragging: Everyone starts to clean the anti-theft window screen, they remove the window screen, and then clean it with a brush, in fact, there is a good way, you might as well try it. The screen window is not completely lowered, but pulled out a little bit and wiped a little.

In this way, the rag is always at the root of the screen, and the dust can be easily wiped out with force.

1. Take two sponges, dip them in some soapy water or laundry detergent solution, hold one piece in one hand, clamp the same part of the screen window on both sides, and wipe it at the same time, first from bottom to top, and then from left to right, so that the dust and dirt on the screen window will not be cleaned. Middle button.

2. Add a small amount of milk to the laundry detergent solution when brushing the screen window to make the screen look brand new.

3. Soak the cigarette butt in the laundry detergent solution, and then use this solution to scrub the screen window, the effect is obvious.

4. The screen window between the stove is easy to be stained with oil, after cleaning the screen, spray some liquor or vinegar, and the stain will be easy to remove.

5. We first take off the screen window, and then wipe it vigorously with a rag with dish soap, or put it flat on the floor of the bathroom and scrub it with a brush, and then wipe the screen window one by one.

6. We can take off the window screen, light a waste newspaper, and use the flame of the newspaper to burn the window screen evenly back and forth on the stained with greasy dirt, at this time, we can see that the greasy dirt that stubbornly sticks to the window screen is quickly melted by heat, or drips to the ground, or is burned off;Then, we gently shake off the soot from the window screen and wipe it clean with a damp rag.

Cleaning method of stainless steel screens:

1. The small holes of the screen window are generally outdoor dust, and if we brush them at will, it is easy to deform the screen window and give mosquitoes a chance. We can use table salt to clean the screens.

2. Salt has the effect of adsorbing dust, and the particles are fine, which can clean crevices, cavities, etc.

3. Dip the rag in some dry salt, carefully wipe off the dirt in the corner of the screen, or use the screen as a "sieve", let the salt be sieved from the hole, and the effect of cleaning the screen can be achieved.