-
Anonymous users2024-02-06Nowadays, many people are accustomed to using wireless routers to surf the Internet, but some places are more pursuing network stability, so they will install wired routers.
Turn on the router and connect it to the computer, as shown in the figure below.
Then open the browser, enter the ** on the manual, the user's default password is admin, click to log in.
Once <> logged in, select "Setup Wizard" and then "Next" on the left. Select "Internet Access" and then select PPPoE (ADSL Virtual Dialing).
Then enter your password to log in and you're good to go.
-
Anonymous users2024-02-05Route settingsYou can set them up by following the steps below!
1. Connect the home network cable to the WAN port of the router.
2. Use another network cable to connect to your computer at one end, and connect to your routing LAN port at the other end, (LAN port is the interface marked on the route!) ）
3. Turn on the computer, open the browser, and enter the route login IP in the address bar.
4. Enter the route login and password in the pop-up dialog box, friendly reminder, if you don't know the route login IP, login and password, you can turn the route over and take a look, and write it on the back of the route!
5. After entering the routing setting interface, the quick setting interface will generally pop up, and you can select the broadband dialing method in this interface.
PPPoe, enter the Internet and password!
6. After the settings are completed, save the exit and restart the route!
Once the routing restart is complete, your routing hardware connection and setup are complete!
In addition, there is another point to remind that if your home is a ** line and there is a cat, it is recommended that you turn off the power of the cat when you set the route, and when the route is set up, turn on the power of the cat!
-
Anonymous users2024-02-04Install a wireless router:
1.Change the local connection to automatically obtain the IP address.
2.The network cable that comes out of the "modem" is connected to the "wan" port on the router, and the router's ports (1,2,3,4) are either connected to the network cable port behind the computer host.
3.Open the browser and enter the password and username of the router are admin4Go to the router settings screen, select the PPPoE (ADSL virtual dialing) method, enter your home account and password, and confirm.
5.Then set the SSID, encryption method, and password.
6.Save, restart. The router is set up!
Changed the IP address of the LAN port of your wireless router to 251-253. Then turn off the DHCP of the wireless router. Directly connect the network cable pulled from the line to the LAN port to access the Internet View the original post
Let's take a look at it step by step.
First of all, you said follow the steps to set it up. I don't know if you're really set it up. It is recommended to add a name to your wireless network and then set a password when setting it up. >>>More
How to set up a wireless router.
Yes, the LAN port of the wired router leads out of the network cable to connect to the WAN port of the tplank, and then configure the wireless router as follows: >>>More
The LAN port of the cat pulls a network cable to the WAN port of the wireless router, the specific method: >>>More