Why press F1 when you turn it on, why press F when you turn it on

There could be several reasons, try the following workarounds:

1. It may be that the motherboard has no battery.

2. There may not be a floppy drive installed, but there is an icon for the floppy drive.

Solution: 1. Change the battery.

2. You find drivea[.]"], press page down until [none] appears, and then press f10 to save.

In this way, you don't need to press F1 when you turn on the computer in the future.

Three possible causes of this:

1。Your computer is with a floppy drive, if the first boot is set to a floppy drive, it will cause this result, and the time will be set to the initial state after booting It is very inconvenient, turn off the floppy drive, (the following will say how to turn it off) because there is a USB flash drive now, the floppy drive is basically not used.

2。You unplug the console after shutting it down, so that's how it goes. Just don't pull it out next time.

It's okay not to pull it out.3 The BIOS coin cell battery on the motherboard is dead No way, only to change the battery The floppy drive is turned off: restart, press del to enter the BIOS, use the arrow keys to select "Standard CMOS setup", press enter, and enter the "Standard CMOS setup" interface.

In the "Standard CMOS Setup" interface, select "Drive A" with the arrow keys, and use PGUP or PGDN to turn the page"", change to "none", press esc, press f10, press y, save to exit.

Relatively simple and practical method) You can try to solve the problem soon.

To press f1 to start: There are several reasons:

1. The CMOS parameter settings are incorrect

Floppy drive: If the floppy drive is not detected, please check whether the data cable is connected, and then see if the settings in the BIOS are correct: check the settings of the boot sequence; In addition, if there is no floppy drive, it is directly shielded.

Keyboard: Some CMOS settings in the keyboard problem will also appear press F1 to boot the situation, the landlord to check it himself.

Memory: Disable Memory Verification.

2. Prompt for insufficient BIOS battery power - replace the battery 3. Jumper setting problem - refer to the manual to set.

press f1 to resume

In addition, it may be a non-fatal hardware error that can be replaced with a check.

The motherboard's battery is dead, causing the BIOS information to return to its initial value.

One of the things is to detect floppy drives, and because you don't have them, they stop there.

To press F1 to skip the detection to enter the system You also need to remember to change the time after entering the system.

The solution is to change the coin cell battery of the motherboard.

How is it prompted?

Can't you enter the system without pressing f1?

The motherboard battery is dead, and the F1 prompts to detect the floppy drive. Replace the battery and reset the BIOS, turn off the floppy drive, and everything is OK

General brands have such a problem 2 points.

1 The host battery is dead.

2 Your memory is not in the first place.

Go into the BIOS and change the boot item, and just prohibit the boot item of the floppy drive.