Does it matter if the air conditioner indoor unit is flooded, does it matter if the air conditioner

Completely disconnect the power of the air conditioner, open the electric control cover to check the status of the internal electronic control components and the fan motor, or report to the air conditioner manufacturer for after-sales repair. The indoor unit of the air conditioner is designed for waterproof structure according to the electrical appliances used indoors, and the waterproof performance of the indoor unit itself is very poor, and if there is external water, it is easy to cause water damage to the electronic control parts of the indoor unit of the air conditioner, the fan motor and other key components. When the indoor unit of the air conditioner is not properly flooded, the treatment method:

2. After wiping the moisture on the outside of the indoor unit of the air conditioner, open the panel of the indoor unit of the air conditioner, disassemble the cover plate of the electronic control parts with a screwdriver, and check whether the electronic control parts have traces of water immersion. 3. Keep the indoor ventilation smooth, keep the indoor electrical control cover open, and ventilate and dry for more than 24 hours; 5. Power on the air conditioner under the condition that everything is normal, and run in the air supply mode for more than 4 hours; Run the cooling mode and heating mode separately to see if the air conditioner has any abnormal conditions. Is it due to the water ingress caused by cleaning, if it is true, there should not be any problems, the circuit of the indoor unit is basically not easy to enter the water, and the indoor unit itself is to collect condensate and discharge it outdoor, we often use detergent jet evaporator, and at the same time rinse with clean water, it is normal, there is no need to worry, as long as it can operate normally, there is no problem. For example, in the case of a fan coil unit, the bottom inlet and the top outlet, the lower nozzle is connected to the water inlet pipe, and the upper nozzle is connected to the water outlet pipe.

Second, for the chiller connected to it, it is just the opposite, and the inlet pipe of the fan coil unit is the outlet pipe of the chiller.

Is it due to the water ingress caused by cleaning, if it is true, there should not be any problems, the circuit of the indoor unit is basically not easy to enter the water, and the indoor unit itself is to collect condensate and discharge it outdoor, we often use detergent jet evaporator, and at the same time rinse with clean water, it is normal, there is no need to worry, as long as it can operate normally, there is no problem.

Don't turn on easily, if the water seeps into the remote control board will be short-circuited, it is best to find the manufacturer's maintenance station to disassemble the shell to check it, the door-to-door fee is 30 yuan, confirm that there is no problem and then turn on, so that the insurance.

If it flows to the circuit board or electronic components, it will break; The circuit of the air conditioner is in the upper right part of the unit, as long as this side is dry, the other parts have no circuit, open the emergency panel and you can see it, even if it is wet, take the hair dryer to blow. It's best to disassemble and check it, and then power it on.

If there is no water ingress into the circuit board part, the problem is not very important, if it is just some shells, it will not have much impact, as long as it can operate normally, there is no problem. The circuit of the indoor unit is basically not easy to enter the water, and the indoor unit itself collects condensate.

After the discharge outdoor.

Please unplug the power as soon as possible, open the lid, the fan blows, it is best to let him cool down for 2-3 days, and then turn on the air supply mode after the circuit board and motor are dry, and then turn on the refrigeration.

1. Water leakage on the pipeline: When the insulation material on the pipeline is not of good quality or is not wrapped, it will cause the refrigerator in the pipe to condense when it passes through the pipeline. Therefore, it is important to choose qualified pipes for the installation of indoor units, and the installation process should be in place.

2. Mainly including the front and rear water guide troughs, drainage pipes, pipe wrapping, drainage pump failure, etc., when the air conditioner is used for a long time, the water guide groove and drainage pipe may be blocked by dirt and leakage, the water guide tank and other cracks due to injection molding, the connection pipe joint is not good, and the drainage pipe is flattened during installation will cause water leakage.

3. Dripping water at the fan blade of the indoor unit: the reason for the water leakage here is mostly the high humidity of the air, when the cold wind blows out from the wind day, the cold wind hits the fan blade directly, and the hot air condenses rapidly, due to the high humidity of the air, it will accumulate more and more to form the illusion of dripping. This phenomenon mostly occurs during the rainy season, and it is not the failure of the air conditioner itself.

Don't turn it on easily, if the water seeps into the remote control board, it will short-circuit, it is best to find a repair to disassemble the case and check it.

It is not that the indoor unit of the air conditioner has water ingress, but that the drainage (discharge condensate) pipe of the indoor unit is blocked, causing the condensate to not be discharged smoothly and leaking out at the indoor unit. The solution is to check the condensate pipe and clear the blockage or replace it with a new one.

Is it due to the water ingress caused by cleaning, if it is true, there should not be any problems, the circuit of the indoor unit is basically not easy to enter the water, and the indoor unit itself is to collect condensate and discharge it outdoor, we often use detergent jet evaporator, and at the same time rinse with clean water, it is normal, there is no need to worry, as long as it can operate normally, there is no problem.

If there is no water ingress into the circuit board, the problem is not very important, it is best to disassemble and check it, and then power it on.

Water entering the indoor unit of the air conditioner can be discharged to the outside through the drain pipe.

If it flows to the circuit board or electronic components, it will break; If it's just a few shells, it doesn't have much impact.

The waterproof rating of the air conditioner is IPX4, which can be exposed to rain, but it cannot be placed in water entirely. As long as the water does not enter the electrical part in the upper right corner, there is no problem, and there is no problem to confirm that the wire is without water.

An air conditioner is an air conditioner. It refers to the equipment that uses artificial means to regulate and control the temperature, humidity, flow rate and other parameters of the ambient air in the building or structure.

Generally, it includes cold source heat source equipment, cold and hot medium transmission and distribution system, terminal device and other major parts and other auxiliary equipment. It mainly includes refrigeration hosts, pumps, fans and piping systems. The terminal device is responsible for using the cold and heat from the transmission and distribution to specifically treat the air state and make the air parameters of the target environment meet certain requirements.

There is no problem, rest assured, the water also plays a cleaning role.

If the heat sink of the outdoor unit is too dirty, you can use the tap water pipe to flush it directly, but be careful not to flush it directly into the machine to avoid water flowing into the fan motor bearing and causing poor lubrication.

It's okay, if you have something, you will put it outside, so it will not be called an air conditioner.

How to deal with water ingress in the air conditioner is <>

1. If it flows to the circuit board or electronic components, it will be broken; The circuit of the air conditioner is in the upper right part of the machine, as long as this side is dry, the other parts are chaotic and there is no circuit, open the emergency panel to see, even if it is wet and blow with a hair dryer. It is best to disassemble and check the subordinates, and then power on to use it. 2. If there is no water in the circuit board, the problem is not very important, if it is only some shell Hongfeng, it has little impact, as long as it can operate normally, there is no problem.

The circuit of the indoor unit is basically not easy to enter the water, and the indoor unit itself collects condensate and discharges it outside. 3. Please unplug the power supply as soon as possible, open the cover, the fan blows, it is best to let him cool down for 2-3 days, completely ensure that the circuit board and motor are dry, and then turn on the air supply mode for a while, and then turn on the refrigeration.