The back cover of the Casio watch can t be installed after prying it open, do you have any tricks to

Casio Watches.

There are five ways to pry the back cover open and not install it:

1. Cover the watch with a professional tool. Yes, many professional watchmakers usually use this tool. It's also easy to use. Put the watch into the machine's mold, close the back cover, and pull the handle firmly to press it down.

2. Close the back cover of the watch with a rolling pin. Find the roller needle, find an old book, or put a piece of paper about 1 cm under it to prevent the watch from scratching, and then press the roller needle left and right on the back cover of the hand, repeating, paying attention to the use of skill.

3. Press the back cover of the table with the corner of the table. In the same way, put something at the bottom first, then put the watch cover on the watch cover under the watch corner, and then press it hard, repeating many times, using Qiaoli, when you hear two clicks.

4. Press one end of the back cover of the watch with your hand, and the other end will slowly bite with your teeth. You can also hear a clicking sound, but it may hurt your teeth. This method should be used with caution.

5. This method of closing the back cover of the watch is the easiest and fastest. If there is a watchmaker nearby, the watchmaker can use professional tools to install the watch quickly and easily.

There are five ways to do this:

OneAttach the lid to the watch with the help of a professional tool。Yes, many professional watchmakers generally use this tool, and it is easy to use, put the watch in the mold of the machine, put the back cover, and pull the handle down after the watch is flat.

IIUse a rolling pin to close the back cover of the watch。Find the rolling pin, and then find an old book, or a paper of about 1cm underneath to prevent the watch mirror from scratching, and then use the rolling pin to press hard left and right on the back cover at hand, repeat many times, pay attention to the use of skill.

IIIUse the corner of the table to press down on the back cover of the watch。In the same way, put something on the bottom first, then put the watch on the lid and place it under the corner of the table, then press hard, try many times, use skillful force, when you hear two clicks.

Fourth, press and hold one end of the back cover of the watch with your hand, and use your teeth to bite slowly at the other end, and you can hear a clicking sound, but it may hurt your teeth, so use this method with caution.

Fifth, this method of closing the back cover of the watch is the simplest and quickest, if there is a craftsman nearby to repair the watch, give itThe master repairer uses professional toolsIt's quick and easy to put it on.

There is usually a small opening on the back cover, and it is necessary to align the axis of time adjustment when installing. Close the cover gently, put 4-5 layers of paper on the front and back of the table, put in the vise with the appropriate opening, slowly tighten the vise, and observe carefully when tightening, and the back cover is installed successfully with a light sound. This is how my watch cover is installed, this method is suitable for people who have some mechanical experience, if you have no mechanical experience, please send it to a watch repair shop to install it.

The book is padded underneath, pressed with a rolling pin, and the card is gone.

I'm not going to pry it open!

There is no doubt that the original single product movement of the watch is pure imported quality, prestige, the front SX in the 61 rear complex XS as long as it is a mechanical watch will have a certain error, since it is an imitation system, the quality is definitely not comparable to the ** watch, it depends on the quality of the movement, but the high-quality Swiss movement is relatively expensive.

The view of the fishing lion in India is sweet and sweet

Yuan Zai wows the crowd and is shocked x the shrimp is silted and the embryo wears a steep kudzu ridge and a cliff hanging.

1. First, take out the back cover of the Casio watch, rotate it to find the notch on the back cover of the Casio watch, and then align the notch with the hands when adjusting.

2. After aligning the notch on the back cover of the Casio watch with the hands that adjust the time, place the back cover on the watch, and press firmly along the edge of the back cover of the watch with your thumb.

3. Press the edge of the back cover tightly with your thumb, and then press the back cover of the entire watch tightly with the palm of your hand.

4. After pressing the back cover of the Casio watch tightly, take the watch to your hand, and then press the part with your fingernails that does not fit the edge to let the entire back cover fit the watch.

5. So that the back cover of the Casio watch is covered.

Summary. Dear, I'm honored to have your question The information that the teacher found for you here is: What should I do if the back cover of the Casio watch is opened and the lid is not opened; What to do if the back cover of the Casio watch is opened and the cover is to lock the back cover with the screws, which is relatively easy to handle, there are small screws on the back cover of the watch, we only need to align the screw mouth, and then lock it tightly, the screw back cover, you need to align the cover with each screw mouth behind the watch, and then try to press it down, which can help us close the cover of the back cover of the watch.

The pull-on back cover requires more pressure when installing, so it is recommended to put a soft cloth under the watch and break the glass when pressing hard.

Dear, I'm honored to have your question The information that the teacher found for you here is: What should I do if the back cover of the Casio watch is opened and the lid is not opened; What to do if the back cover of the Casio hand key watch is opened, and the back cover is screwed to lock the back cover, which is relatively easy to handle, there are small screws on the back cover of the watch, we only need to align the screw mouth, and then lock it tightly, the screw back cover, you need to align the cover with every screw on the back of the watch, and then try to press it down, which can help us close the cover of the back cover of the watch. The pull-type back cover requires more pressure when installing, so it is recommended that Qi Kuqiao put a soft cloth under the watch to break the glass when pressing hard.

Suggestion: Dear [Xian Hall File Flower] Now that the epidemic is repeated, you must pay attention to the <> of the slag when you go out and pretend to be chaotic

Wear a mask when you go out, wash your hands frequently! Have a great day, <>