Can you use kessy for 11 Magotan 1 8

The model of the landlord has not yet been determined, after all, the model with the KESSY system must be started without a key, if it is determined that there is a keyless start, it must be usable.

Hope the following information can help you:

Volkswagen's KESSY Entry & Start Permission Device (commonly known as One-Button Start + Keyless Entry).

VW push-button start and keyless entry are integrated called KESSY KESSY is a keyless system that utilizes it to unlock or lock the car without operating the key fob.

One-button start is very simple, that is, the rotation of the lock cylinder becomes a one-button press, and the back lines of the anti-theft coil and the like are the same.

There is an additional KESSY controller J518: J518 and J527 steering column control unit through comfort CAN communication to the steering column control unit to find the information of the legal key to loosen the electronic lock ELV of the steering column (the original mechanical lock cylinder has a mechanical mechanism to lock the steering column, KESSY does not have a mechanical lock cylinder, Added ELV steering column electronic lock) J527 steering column control unit, and then communicate with the gateway through power CAN (this is the same way as mechanical lock cylinder).

The keyless entry section includes 6 antennas, 2 contact sensors:

1: G415 Left Front Door Handle Contact Sensor (Inside the handle, unlock the sensor area, and the small dot button on the outside is a locking sensor area).

2: G416 Left Front Door Handle Contact Sensor (Same as above).

4: R135 Right Front Door Handle Antenna (Same as above).

6: R137 Trunk Upper Antenna (Ibid.).

7: R138 gear front antenna (same as above).

8: Antenna under the back cushion (same as above).

The KESSY system pulses send out radio waves to search for whether there is a legal key nearby (the power is very low, that is to say, it is very close, not too far), and the anti-theft code in the anti-theft code in the induction legal key ** device (that is, the small glass tube in the past Now the glass tube of the integrated remote control is dry and dies on the remote control circuit board), rest assured, your key is not electric during the induction process, after sensing the legal key: 1: keyless unlocking:

Unlock the car via the front door handle inside the sensing area or the electric switch on the trunk lid.

2: Keyless start: Start the engine and drive. For this purpose, it is necessary to have a valid key fob in the car.

3: Keyless locking: lock the car through the sensor button on the outside of the front door handle.

After starting, for safety, the kessy stops working, that is, you leave the car with the key in your pocket after starting, the car does not turn off, and the door lock does not lock automatically.

After manually turning off the kessy into working condition, close the driver's side door. Touch the outside of the door handle to lock the car sensing area All door locks are locked.

The status of the door lock can be checked by the turn signal prompt:

1: Flash 1 down, lock.

2: Flash 2 times to unlock.

3: Flash 4 times, the key is forgotten in the car, it does not lock within 30 seconds, does not open the door after 30 seconds, and then automatically locks.

It can be modified, but I personally don't think it's necessary.

Changing it out is also to get a fake key to insert it in**. It's not a one-button start in gear**.

If you have money and a tyrant, then do it in one step and change it to b7,. But there's a lot to change.

Auto parts city specializing in Magotan can be engaged.

It can be loaded, but I don't think it's necessary, I bought a new Passat and I didn't have it.

This is for models that do not have a one-button start but have a keyless entry function, and the ignition key is inserted into the keyhole for a long time.

Hello. Yours belongs to the second generation engine. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello, the second generation . Have a great trip. If I can help you, please set it to, thank you!

The 11 Magotan engine EA888 does not use a timing belt, it is a timing chain, and the Volkswagen EA888 engine has never used a belt, it is a timing chain, including the EA888 engine model of He.

1. First of all, mobile phones and on-board Bluetooth devices should establish a pairing code. Turn on the Bluetooth function of the mobile phone and the Bluetooth device in the car, and set the Bluetooth settings of the mobile phone to "visible to everyone";

Turn on your phone's Bluetooth first. Remember to turn it on in visible mode, which is not the same as the in-vehicle system to search for it. Then press and hold the five-pointed star sign. After a prompt tone, the mobile phone will have a prompt that the reed is right. Once connected, you can use the **button to answer**.

If you can't screw it. You may not be in the P gear. Solution: Hang in the hidden plum P file first and then start it.

There is no Sakurajin anymore. I'm all myself. It's been a long time since I've driven a Volkswagen car.