What should I do if the router is factory reset and there is no network

To restore the factory value, you need to reconfigure the parameters, and the correct configuration of the router is as follows:

After logging in, click on item 2 of the tree list on the left (depending on different routers) "Setup Wizard", select your Internet access method, if it is home broadband, select item 2 PPPOE (ADSL virtual dialing), and then fill in your broadband password point to save, and then the router prompts that you need to restart, wait for restart;

If you are using the Internet such as a switch, you need to select the last item of the setting wizard: static IP, fill in the corresponding IP address, subnet mask, gateway, DNS and other information and click Next to enter the wireless network setting interface.

Select the encryption method of WPA-PSK WPA2-PSK, then set the wireless password and click Next, and the router is set up.

Select item 1 "Running Status" in the tree on the left, drop down to see the running status, if you can see the IP address (the above two settings can be used to observe the network connection status in this way), subnet, gateway, DNS and other items have numbers instead of blanks, you can be sure that the network has been connected;

When the router is reset, the parameters of the router are cleared, and the router needs to be set to the parameters at this time, and the router settings are as follows:

2. Then open the browser and enter the management address and login password of the router.

<>3. After logging in to the background, click the setup wizard, and then fill in the corresponding parameters according to the wizard instructions.

<>6. After the wireless setting is completed, click Save, and then restart the Husunwu router to use it normally.

Hello at this moment.

You should move the router out of the way first.

Directly out of the cat out of the network cable link to the computer to see if the network is normal.

If normal. You just check the line.

after the correct login.

Router settings screen.

Factory reset.

There is no network for the router to factory reset, and it depends on how the maintenance master sets it up.

Of course, there will be no network after the factory reset, and you need to set it up according to your specific situation.

Well, depending on how your fiber signal is set up, you need to log in to the router settings.

Generally, the router should not be set to factory reset, unless it is a last resort, because it will not be set to do a factory reset, and there will be no network.

First, restoring the factory settings will delete the original mark address, that is, you can't access the Internet without an address.

Second, if you reply to the router exit setting, the network will be locked by the official website.

The third is that the router and the network are separated after the reply is set up, and there is no link to the device.

You can also set up your router on your computer, activate it and copy the mark address.