What to pay attention to when washing nylon How to wash nylon clothes to be clean

EligibTM EB-Purge purging compound is a high-performance thermoplastic cleaning compound that is a non-abrasive, non-chemical thermoplastic cleaning compound. She will lead a new revolution in screw cleaning! The organic synthesis of plastic and polymer makes it easy to clean the screw barrel of the plastic machine, the color change is simple and easy, the cleaning cost is more in line with the economic principle, the effect is extremely significant, as long as 20 minutes can clean the screw, and does not hurt the screw, to ensure that you will be satisfied!

Uses: For pigment replacement, resin replacement, preventive machine maintenance; EB-Purge is formulated to meet the specific requirements of injection molding, extrusion and blow molding machines.

Economical: Only a small amount of cleaning agent is required for fast and effective cleaning. The cleaner cleans the first clean of carbon build-ups, spots, rust and stains that cause "dark spots", minimizing machine downtime and maximizing your productivity.

Plus, there's less debris, so you don't waste usable, expensive resin. Due to the heat stability of EB-Purge cleaners, they have an indefinite shelf life.

Safety & Environment:

EB-Purge purging compounds are safe for both the operator and the cleaning equipment.

EB-Purge cleaners are non-chemical, non-abrasive products. There will be no wear and tear on the machine. The cleaner is safe for the machine and operator, and it is also safe to dispose of. The cleaned plastic can be added to black color injection molding, which can be reused and in line with the principle of environmental protection.

Usage: Please determine the temperature of the plastic machine between 240 degrees and 260 degrees, and clean the hopper with screw cleaning agent --- EB-88 water agent, so as to avoid each dead corner of the hopper that is difficult to clean, so as to avoid the residual toner from polluting the new material again. The appropriate proportion of screw cleaning material is completely into the feeding barrel, and then the heated and dissolved plastic is soaked in the barrel for ten minutes, and then the cleaning material is completely shot, new material is added, and normal injection molding is carried out.

Package: 25kg box

Usage and Dosage:

Ounce plastic machine: 200 grams.

6 oz plastic machine: 300g.

15 oz plastic machine: 350 grams.

20 oz plastic machine: 400g.

30 oz plastic machine: 600g.

60 oz. Plastic Machine: 800 grams.

Shanghai moderately able fine chemical industry.

shanghai stoner fine chemical co., ltd.

address：502，no. 14，80alley, tanjiaqiao road, zhabei area, shanghai china

**(tel): 021-56098807

Fax: 021-56098806

1: 1. Use general detergent, and the water temperature should not be too high.

2. If you wash by hand, don't wring it out too hard.

3. Use low-temperature steam when ironing.

2. Personal experience: 1

The water temperature should be controlled when washing clothes. 2.Don't pull too hard when washing by hand.

3. Don't let the gravity be too large when drying clothes (don't dry clothes directly on the hanger, nylon has good elasticity, and the gravity is too high when the clothes have water, which will pull the length.) It is recommended to hang the clothes on the hanger from the midline from top to bottom).3.

Don't expose your clothes to the sun, and keep the temperature under control when ironing.

Suitable for general lotion, because nylon clothes are easier to dry, so they should be dried in a cool and ventilated place, not exposed to the sun for a long time, so as not to make the clothes yellow. When drying, put a cloth on the pad for ironing, ironing temperature stroke between 120 and 130 is appropriate.