How to get a new fish tank? How to deal with the newly made fish tank after buying it before you can

Put a tank of water (you can use tap water), you don't need to add anything, turn on the water pump for a week, and you can use it normally. Generally, it is commonly used to have "yellow powder" that can cure bacterial infections, "iodine tincture" and "blue potion" are smeared on wounds, such as: rotten meat, "oxytetracycline", ** enteritis!

All of the above are available in pharmacies or aquarium fish!

Put a jar of water, don't add anything, soak for about a week, and then you can use it normally.

The method of opening the fish tank and the use of filter material.

1. Equipment to be prepared for the new cylinder (self-made cylinder. The finished cylinder can be referred to).

1. Circulating pump (I personally feel that the innovative pump is good, and the sound is small).

Meters of cylinders, 25w is enough, meters of cylinders, 40w is enough.

2. Thermometer (glass is recommended, the error is small).

3. Filter cotton.

The lower part of the ecological cotton and the top of the filter surface (when cleaning, only the upper filter surface is cleaned, and the ecological cotton is the survival of digestive bacteria.

Space) 4. Coral sand.

In the filtration system, it is not recommended to lay the bottom sand.

5. Volcanic stone.

A few pieces will do 6. Digestive bacteria.

You don't need to put it often, and you don't need to put it too much. Digestive bacteria can survive and multiply on their own. When cleaning the filter cotton, just rinse it with water.

7. If it is a dragon tank, you can add a surf pump.

2. Standing medicine at home 1, salt; 2. Oxytetracycline; 3. yellow powder; 4. Penicillin; 5. Buddha sour; 6. Enteritis Kang; 7. Cotton swabs.

3. Open the new cylinder.

1. After the new cylinder is bought, the cylinder must be placed horizontally to prevent the cylinder from cracking;

2. Clean coral sand, filter cotton and other equipment;

3. Use diluted potassium permanganate water, soak the cylinder for 12 24 hours, be careful not to cover the lid, so as to emit the smell of glass glue and bubble.

The pump can also be started and circulated when the cylinder is used (this step is for sterilization);

4. After the soaking tank is over, drain all the water;

5. Add new water and circulate. (This step is to completely replace potassium permanganate water);

6. Put away all the new water;

7. Add new water, open the warming rod, and start the pump for 24 hours to circulate and raise water;

8. OK, release the fish. (It is recommended to put cheap fish into the tank first) Hopefully!

I bought a new fish tank, and I must clean it thoroughly before I can raise fish.

1. Scavenger: The fish tank will have yellow things generated after a long time, which is the scavenger's favorite food, and the fish mouth will be attached to the glass and moved to eat some dirt in the corners and dead corners.

2. Fish tank brush: The fish tank brush can avoid pouring out the water, and the fish tank brush is shown in the picture below. Half of it is inside the fish tank and half is outside the fish tank, and it is attracted by a magnet, so it is convenient to move the brush inside as long as you move it when you clean it.

3. Potassium permanganate treatment method: This cleaning method is relatively thorough, and it is generally used in the fish tank that has been filled with dead and diseased fish, that is, potassium permanganate.

The whole tank is disinfected with potassium permanganate first, and then the water is raised.

Soak potassium permanganate for 2 days, the water pump is turned on 24 hours a day, to ensure that the water in the tank is circulated and detoxified, the cylinder is rinsed and filled with water, the oxygen is violated, the water pump is opened, the filter material is washed and then put, it is best to boil it with water to ensure good perhydroscopy.

After raising water for a week, add a few Kodi nitrifying bacteria and enter the tank. Generally, 10-15 days can be used to enter new fish, and new fish can be added to the tank and then added Cody nitrifying bacteria.

Keep the water clean, wash the filter frequently, extract fish feces in time, and change the water regularly every week.

The first thing to note is that the newly bought fish can not be directly poured out of the water in the fish bag, you need to put the bag directly on the water surface of the fish tank, open a mouth, let the fish swim in by itself, and pour the water in the bag at the same time, so that the fish just bought back will successfully enter the tank.

Things to pay attention to when you just bought the fish:

1. The water needs to be disinfected, when the new fish arrives, the water quality will change somewhat, and some disinfectants and fungicides will be put in.

2. Pay attention to control the water temperature in the fish tank, and do not let the temperature of the fish tank change too much, so as to avoid the temperature difference causing the fish to get sick.

3. After entering the fish, pay attention to the stress response, jump the tank, jump the pool, and also do the necessary protective measures, pay attention not to feed within 24 hours, observe the state of the fish after 24 hours, and have the desire to feed a small amount, during which the submersible pump and aeration pump are often turned on for 24 hours. After a week, it's almost ready to be fed.

4. When breeding fish, it is necessary to pay attention to daily management, and at the same time maintain the water quality of the fish.

Fish tank water should be prepared to filter for 1 to 2 days, put some coarse salt in the water, put some medicine to prevent fish disease or reduce inflammation drugs, the water temperature should be adjusted before you can buy fish, just bought back fish with bags first put in the tank water to soak for 30 minutes, and so to adapt to the water temperature difference, and then untie the plastic bag and pour out part of the water, add some water from the tank to the bag to let the fish adapt to the water quality, 1 to 2 minutes later put the fish into the fish tank, so that the fish adapt to the environment and adapt to the water quality is quite good.

Do you throw the newly bought fish directly into the tank? No wonder your fish are not well raised, telling you how to cross the water.

If you know that it is a newly purchased fish tank, you first need to soak it in salt water with a high concentration to sterilize. Pour the water away again. After changing the water, dry it for a few days, then sprinkle a little coarse salt into the tank and add sand and aquatic weeds, and you can start raising fish.

It is best to disinfect the tank first, you can add thicker salt water to the tank, and let the fish tank soak for a day.

Then pour out the water in the Yuxiang Zheng elimination tank and fill it with new water, and now most people use tap water to raise fish, so after loading the new water, it is best to put the fish tank in a sunny place to dry for a few days to remove the chlorine in the water.

Then sprinkle a little coarse salt into the fish tank, put some sand at the bottom of the tank, and breed some aquatic plants, then the fish tank can officially raise fish.

If you just buy a fish tank, it is best to put a higher concentration of salt water in it and soak it for a day, then pour out the water in the tank, replace it with new water, and dry it for a few days to remove the chlorine, and then sprinkle a little coarse salt into the tank, put in sand and aquatic plants, and you can raise fish normally.

When raising fish, the newly bought fish tank is not suitable for raising fish immediately, so what to do with the fish tank you just bought. It is best to disinfect the tank first, you can add a thicker salt water to the tank, and let the fish tank soak for a day.

Then pour out the water in the fish tank and fill it with new water, and most people now use tap water to raise fish, so after loading the new water, it is best to put the fish tank in a sunny place to dry for a few days to remove the chlorine in the water.

After that, sprinkle a little coarse salt into the fish tank, put some sand at the bottom of the tank, and breed some aquatic plants, and you can put the fish into the fish tank to raise normally. And in this process, it is best to observe the condition of the fish regularly, so that the fish can make a trustworthy treatment when they are unwell.

Do you throw the newly bought fish directly into the tank? No wonder your fish are not well raised, telling you how to cross the water.

Wash the water and let it sit for a few days after it has been treated. The water temperature is the same as that of the fish. You can put it.

Wash with clean or lukewarm water.

Hello dear, it's a pleasure to serve you!

For you to find out the concentrated salt water soaked for a day, after rinsing with clean water, add tap water and connect all filtration and auxiliary equipment, power on full power operation, at the same time add potassium permanganate to the water, add until the water turns purple.

Run with potassium permanganate for about 5 hours, wait for the color of the water to turn dark red, at this moment the medicinal properties of potassium permanganate have been completely degraded, and then replace the water and add ordinary tap water.

Turn on the filter, turn on the air pump, and after pumping the air for 12 hours, you can raise water.

When the water is crystal clear, it's time to release the fish.

Steps of water farming in fish tanks:

We all know that the tap water released from the faucet is not suitable for direct fish farming, and it must be chlorinated and oxygenated first, and the hardness and pH of the water must be adjusted if the requirements are high.

If you buy a new fish tank, you need to clean the fish tank and all the utensils, then put a few packets of coarse salt in the water, leave it for a week, and then pour out the water. After that, fresh water is poured in, and it is left to dry in the sun for a few days to remove the chlorine gas, and then the relevant equipment can be installed and the fish can be put into the tank to raise.

Many friends who keep fish should want to know how to deal with the newly bought fish tank before they can release the fish. The first thing to do in the newly bought fish tank is to raise the tank, you need to clear the fish tank and filter material several times, and then put a few packets of coarse salt in the water to remove the germs in the tank and one piece, and leave it for a week.

After that, all the water in the tank is pumped out, and new water is put in, and placed in a sunny place to dry for a few days, because most people now use tap water to raise fish, and tap water contains a lot of chlorine, which needs to be dried to remove the chlorine in the water.

At this time, you can install an aerator and a filtration device, and after installation, you can put the fish into the fish tank to raise, but it is best to regularly observe whether the water quality is transparent, whether the fish is active, and whether the food is normal, so as to make corresponding treatments.