Why do solar street lights stay on for a short time?

Solar street lightsThe light time is short, which is caused by the following reasons. The battery is not aging well, it is better to replace the battery. It could also be caused by not having enough power stored today.

Solar street lamp is powered by crystalline silicon solar cells, maintenance-free valve-regulated sealed batteries (gel batteries) to store electric energy, ultra-bright LED lamps as light sources, and controlled by intelligent charge and discharge controllers, which are used to replace traditional public electric lighting.

Precautions

If the user installs the lamp on the ground by himself, the precautions are as follows:

1. Solar street lamps radiate from the sun.

For energy, whether the sunlight shining on the photocell module is abundant directly affects the lighting effect of the lamp, so when choosing the installation location of the lamp, the solar cell module can shine sunlight at any time period without obstruction such as leaves.

2. When threading, be sure to pay attention to the wire not to be clamped at the connection of the light pole. The connection of the wire should be firmly connected and wound with PVC tape.

3. When using, in order to ensure the beauty and the battery components can better receive solar radiation, please clean the battery every six months.

Dust on components, but never rinse from the bottom up with water.

There are several main reasons why solar street lights are on for a short time:

1.Limited solar energy storage capacity: Solar street lights convert solar energy into electricity through solar panels and store it in batteries.

However, solar panels have a limited area and are limited in the amount of solar energy they can convert, so the amount of electricity they can store is limited. When solar panels can't get enough solar energy, the battery stores less electricity, resulting in shorter periods of time for solar street lights to be on.

2.Low efficiency of solar panels: The efficiency of solar panels refers to their ability to convert solar energy into electricity.

However, the efficiency of solar panels is relatively low at present, generally between 15% and 20%. This means that only a small percentage of solar energy can be converted into electricity, and the rest is wasted. Therefore, the low efficiency of solar panels is also one of the reasons for the short time that solar street lights are on.

3.High energy consumption at night: Night is the time when solar street lights come into play, but the energy consumption at night is relatively large.

Solar street lights need to provide enough light intensity to illuminate the road, which requires more electricity. Since the solar panels store limited electrical energy, they cannot meet the energy demand at night, resulting in a shorter period of time for solar street lights to be on.

4.Weather conditions: Solar panels need to receive enough sunlight to convert into electricity.

However, weather conditions such as cloudy days, rainy days, etc., will affect the reception effect of solar panels, resulting in a decrease in solar energy conversion efficiency. In poor weather conditions, solar panels are unable to capture enough solar energy, resulting in shorter periods of time for solar street lights.

In summary, the short time of solar street lights is mainly due to the combined effect of factors such as limited solar energy storage capacity, low efficiency of solar panels, high energy consumption at night, and the influence of weather conditions. With the continuous development and improvement of solar energy technology, it is believed that the lighting time of solar street lights will gradually be extended.

The main reason is focused on the short lighting time, low lighting brightness, short life of individual components and other problems, the reason for these problems, mainly the ability of solar street lamp business is uneven, solar street lamp business is mainly some system integrators, they do not produce any products, their best solar street lamp parts manufacturers are also very different, the strength is not the same. LED street lamp manufacturers to invest in development, with the development of skills and the decline of the world, today's niche, is likely to become tomorrow's mainstream, will also help skills.

Due to the low cost performance of solar smart street lights, more and more solar smart street lights are installed today. Today's smart street lamp manufacturers come to tell us about the knowledge of solar smart street lamp controllers.

And now these street lights lighting time is getting shorter and shorter, when it comes to sunny days, it will be a little more often, if it is a rainy day, it is often just a moment of light and then extinguished, so it is obvious that the role of street lights is not played, it is purely a green agreement to take photovoltaic as a pillar, and its ambition needs to be transformed into an industry of solar energy. In order for a revitalizing PV chain, the association and member countries must support conditions that make it easier to become globally competitive and enable the appropriate economic framework to function successfully.

If the previous street lights were mainly for lighting, today's solar street lights are no longer satisfied. Illuminated at night, it is also a beautiful scenery during the day. In other words, solar LED street lights can not only illuminate, but also be pleasing to the eye.

In order to enrich the new technology, process and system design of solar street lamps, the upgrading of manufacturing technology and process is organically integrated into the R&D, production and application of solar street lamps and street lamps.

If it is a rainy day in a row, the solar street lamp can not store much electricity, so the use time is relatively short, if it is a sunny day every day, it means that the battery is aging, and you need to replace the battery and try again.

The time and power of solar street lights are determined by the controller. Solar street lights have batteries to store the electrical energy converted by the panels, as long as there is electricity in them, they will naturally light up when it is dark, and they are generally set up at the factory. Now there are three kinds of light control, time control and human body sensing on the market, which can be selected according to your needs.

At the same time, the lighting time of the solar street lamp can also be set according to the user's requirements. For the same location, the lighting duration is directly related to the selection of solar modules and batteries. Under the premise that the power of the light source is determined, the larger the power of the solar module and the capacity of the battery, the longer the illumination time can be guaranteed, and the shorter the vice versa.

A standard system configuration should generally guarantee 5 to 10 hours of lighting per day.

Because the solar street light is lit by solar energy, but the solar energy of a day is limited after all, so the energy it provides can only be maintained for a period of time.

In this case, the solar street lights are on for a short time, mainly because the accumulated energy is relatively small, which is generated by the sun.

It means that the capacity of the battery for storing electric energy is small, or the battery is aging, and I am really looking forward to it

I think it's because the battery is not very good, and the battery has less power storage. If you want the street lights to be on for a long time, you need to replace the battery, or repair the battery.

Because it is solar-powered, the perceived energy absorbed is limited.

Solar street lights, because there are regulations on the time of light, so they are on for such a short time.

It doesn't work even if you change the battery to a new one, and the lighting will be on in about half an hour.

If the street light is on during the day, check the controller first, the controller is red to indicate charging, and the red light is flashing to indicate that the battery is fully charged, and the controller is charging at a pulsed low current. Solar panel.

If the connection is not very strong, it will cause normal charging, and the usual performance is that there is a voltage and a normal open circuit voltage.

In the above; But there is no current. This phenomenon is that the wires of the battery board are not connected well, and the troubleshooting method can be directly after the black electrical cover behind the battery board is opened, and the voltage and ammeter can be directly used.

Detection data. 1: Object occlusion if solar panels.

Being covered will also cause the solar street lights to not be able to use normally, be covered with heavy snow, and be covered with dust. When these mulches cover the solar panels, the output voltage of the solar panels will drop below a certain value, and the solar street lights will be ignited.

2: The photoresistor is particularly sensitive to light, in light intensity.

When it is weak, the resistance is large, and as the light becomes stronger, the resistance value decreases. Slip rheostat on or off.

An equilibrium can be found where the photoresistor value is small when the light is stronger. The use of photoresistors has certain drawbacks. The photoresistor is relatively high for the installation of jujubes, and it is in rainy and cloudy days.

and other situations are easy to miscontrol the paulownia.

3: Solar panels convert sunlight energy into electricity, the stronger the light, the weaker the light, the lower the output light. The output voltage of the battery board can be used as a basis to turn on the street lights when the voltage is lower than a certain level, and turn off the street lights when the voltage is higher than a certain level.

4: The solar street light controller shows the under-voltage state, and the light does not turn on after dark, but the battery voltage has exceeded the under-voltage value, indicating that the battery is electrified. After the battery drops to this voltage point, the controller turns off the power supply and stops discharging, mainly to protect the battery from being over-discharged and affecting the subsequent use of the whole equipment.

The charging voltage will only continue to discharge when it is charged to 24V (the default value of the controller), and the main purpose of this setting is to avoid damage to the battery due to deep discharge during the period. In the case of under-voltage of the battery, if the solar street light controller is not restarted, it is under voltage between volts and 24 volts, and it will continue to discharge only when the voltage of the solar street lamp battery is charged to more than 24 volts.

Solar street lights appear always on Ha is only the situation that the day is bright, generally always on behalf of the sun group Huai Neng Cave slab is not working, it may be that the wiring is wrong here, or the solar panel is damaged, and the general high-power solar panel has a two-section tube on it, which can be cut off and can work normally. Ha has a daytime brightness may be the manufacturer set up the morning light function, the specific situation analysis is based on the actual local situation.

The reason why the solar street lamp is wide and bright in the day is because it absorbs the light of the sun to charge the empty space, so it is said to be bright, and we do not need to generate electricity to make it bright, because it has a solar panel on it, as long as there is light, it can shine.

The reason why the street lamp that is too stuffy and attacks the yang energy is bright during the day is that he feels the energy of the sun in the macro section, and the brother will only light up with this kind of lamp, and it is generally used for emergency lights, so its effect is still very good.

The reason why the solar panels do not charge the electric sock pool during the day is through the bench controller. The controller detects that the controller is on a red light to indicate that it is charging, and a flashing red light indicates that the battery is full and the controller is charging at a pulsed low current.

If it's bright during the day, it means that there is something wrong with its control system. Generally, designers want it to be lit at night, unless it's a traffic light, so that it can be lit during the day. If it is bright for 24 hours, there may be insufficient charging in the hand brigade, the sun is not there every day, and it is not possible to generate electricity on cloudy or rainy days, and when encountering solar lights that are also bright during the day, it is necessary to check its control system to save its power.

The solar street light is also bright during the day, because the sky is darker during the day, it is inductive, and when it reaches a certain degree of darkness, it will be bright.

If the street light is on during the day, first check the Tansen vertical controller, the controller is red to indicate charging, and the red light is flashing to indicate that the battery is full, so that the big controller is charging at a pulsed low current. If the connection of the solar panel is not very strong, it will cause it to not be charged normally, and the usual performance is that there is a voltage, and the normal open circuit power is pressed above; But there is no current. This phenomenon is that the wires of the battery board are not connected well, and the troubleshooting method can directly use the voltage and ammeter to detect the data directly after the black electrical cover behind the battery board is opened.

The solar street light is lit in the daytime, first of all, check the bridge controller, because the red light of the controller is on, the leakage shows that the solar street light is charging, and the red light flashes the cavity, indicating that the battery has been filled with control gas, and Xiao Liu has been pulsed to charge, therefore, it will cause the solar light to light up.

Solar street light in the daytime energy is it absorbed, solar energy in the daytime when the solar energy is sufficient, so it will be on.

If the solar street light is on during the day, this should be that there is no place to store the power after the battery is fully charged, and it will be twice a day.

Because its light is particularly dazzling during the day, when its light intensity is very high.

Why do solar street lights shine during the day? Blockade hidden.

The reason for this is that the light sensor on the solar panel is blocked, so it will be bright during the day.

This is because solar street lights can convert solar energy into electricity, so that they can supply light bulbs to emit light, which is more economical and environmentally friendly.

Why are solar street lights on during the day? Because it will be bright when it is irradiated by solar energy, it will not be bright if it is black shoes at night, and it will not be bright without solar irradiation.

This phenomenon is that the wire of the battery board is not connected well, and the method of checking and blocking can be directly after the black electrical cover behind the battery board is opened, and the voltage and ammeter are directly used to detect the data.

The reason why solar street lights do not light up during the day is because the function of not lighting up when the light is sufficient has been set, so they are not lit during the day.

This one is mostly a matter of setting. He can set a time for the stove to be lit up. Or the big witherer is that he has a switch that manually turns on the light, and after manually turning it on, it will return to the amount during the day.