How can I wear a seatbelt correctly?

Please take care of your body.

How to fasten your seat belt correctly: 1. Adjust your sitting posture: stretch out your hands and wrists on the steering wheel, which is the most suitable distance.

The legs are bent at about 90 degrees, so that if the legs are braked urgently, it is easier for the legs to react flexibly. In the event of a crash, it also ensures that the legs are cushioned enough to avoid injuries to the straddle and upper body. Position of both hands on the steering wheel:

Placing your hands at the approximate level of 9 and 3 o'clock will help you to maneuver the vehicle effectively in an emergency. 2. Adjust the seat belt: Hold the buckle lock and deadbolt and slowly pull out the seat belt.

Make sure the shoulder harness runs over the shoulder, fits snugly around the neck and fits snugly and snugly over the body. Make sure the lap belt is below the abdomen and as low as possible, again for a good fit. The seat belt buckle is inserted into the buckle lock until a click is heard.

1. Sit on the saddle, pull out the seat belt with one hand, hold the buckle with the other hand, and clamp the buckle plate and the buckle to ensure that the seat belt is firmly tied to the body.

2. Adjust the position of the belt. Three-point lap harnesses should be fastened as low as possible at the hips, not at the waist.

3. Adjust the position of the shoulder straps. The shoulder straps should be worn comfortably cross-body over the collarbone, not around the neck, against the face, or under the arms.

4. Check your seat belt. Check whether the seat belt is firm before driving and make sure that the seat belt is performing properly before driving.

5. Unfasten the seat belt. Hold the tab in one hand and press the "Release" button with the other hand to return the seat belt to the retractor and place the tab in the storage position.

1. Check the seat belt and hold the D-ring buckle on the back of the seat belt to ensure that the webbing is not entangled.

2. Start wearing the seat belt and slide the seat belt through your arms to your shoulders. Ensure that all webbing is free of tangles and hangs freely. The shoulder straps must be kept vertical, not near the center of the body.

3. Grab the leg webbing and connect them with the buckles on the webbing on both sides of the buttocks. Thread the excess length of webbing into the adjustment ring.

4. The chest webbing connects the chest strap together through a slip-on buckle. The chest strap must be 15 cm below the shoulder, and the excess length of the webbing is threaded into the adjustment ring.

5. Adjust the seat belt. Shoulders: Adjust the webbing from the shoulders so that the height of the leg webbing is just below the hips and the D-ring on the back is between the shoulder blades.

Legs: Then adjust the leg webbing, try to do a single leg extension and a half squat, adjusting the length of the leg webbing on both sides. Chest:

The chest webbing should be crossed in the middle of the chest and about 3 hands wide away from the bottom of the chest.

Nowadays, many drivers wear seatbelts in a way that is simply unsightly. So what's the right way to do it? Today we will take a look at the correct way to fasten seat belts.

1.Adjust the seat and sit upright. Grab the deadbolt of the seat belt at the head of the seat, pull the seatbelt down with your body, don't let the belt kink, and then buckle the deadbolt into the buckle.

At this point, remember to pull the deadbolt again to confirm that the harness is fully locked. Do not tilt the back of the chair too much, otherwise the harness will not stretch and roll up properly. 2.

The fastening method of the seat belt in different positions. It is common to take a mountain harness over the shoulder, which should be worn over the shoulder, through the chest, and not under the arm. The belt should be fastened as low as possible, close to the lower part of the hip bone, not around the waist.

The advantage of this system is that in the event of a collision, the force of the collision will act on the bones of the pelvis, which can ensure the stability of the human body to the greatest extent. Once the belt is fastened, it is best to pull down the belt at the buckle end and pull the mid-rise shoulder strap at the same time. 3.

Don't let the seat belt press against hard or fragile objects, and don't put items such as glasses, keys, cell phones, etc., in your breast pockets.

Pull over the shoulders at least 2 fingers away from the shoulders;

The margin should not be too large, and it should fit the body.