How to solve the noise caused by the water on the mobile phone speaker?

After the cell phone gets into the waterSpeakersThere will be a little backlog of water in it, so you can first turn the speaker down, hold the phone and shake it a few times, wipe the speaker hole with a paper towel, and turn it on with a hair dryerHot airBlow into the speaker, don't blow for too long, just a minute or so.

The mobile phone stereo is flooded, and the reason for the noise is the eardrum.

The frequency of the vibration decreases, causing the dust that was previously attached to the horn to stick tightly to the eardrum, resulting in noise. It can be solved by cleaning the speaker and replacing the speaker.

Precautions for phone speaker cleaning

Care needs to be taken to make a gentle circular motion on the speaker hole while applying a little force. Keep wiping until all the dirt is cleared out. If the speaker hole is large enough, press a cotton swab into the hole.

But don't press too tightly, just enough to insert the cotton at the tip of the swab into the slot. Once inserted, turn the swab back and forth while applying a little pressure.

Use a medium-hard toothbrush to clean the speaker. Tilt the bristles towards the top or bottom of the phone, parallel to the top of the phone, and move them up and down. Then clean the toothbrush vertically (parallel to the side of the phone) and move it from side to side.

After the phone horn gets into the water, you can remove the phone card, turn off the phone, and dry it with a hair dryer.

Steps: <>

<> precautions after the mobile phone gets into water:

1. Don't turn it on. As mentioned above, electronic components can cause short circuits when they come into contact with water while operating.

2. Do not connect the power supply, the reason is the same as above.

3. Don't press any buttons, as this will push the water further into the fuselage.

4. Don't shake your phone or use a hair dryer, as this will allow water to penetrate further into the body. Here are some reasons not to use a hair dryer.

5. Don't apply any heat to your phone. Keep in mind that too much heat can also damage your phone. At this time, you should avoid causing any additional damage to your phone.

6. Don't move your phone casually.

The above content reference: Minnan Net-What should I do after the mobile phone enters the water? Correct response and handling workarounds.

If you are using a Huawei phone, we recommend that you do the following:

1. Please try to place your phone in a dry and ventilated place and use a paper towel to blot the water stains on the surface of your phone.

2. If the phone is turned on, press the power button to turn it off; If your phone is turned off, don't try to turn it on.

3. Please take out the SIM card and microSD card.

4. Take your phone to a Huawei customer service center as soon as possible to avoid unnecessary losses.

Precautions: 1. Do not move or shake the mobile phone frequently after entering the water, so as to avoid the spread of moisture inside the mobile phone.

2. Do not use a hair dryer to blow or bake at high temperature (including microwave heating) after entering the water, so as to avoid the liquid being blown into the inside of the mobile phone and damaging the mobile phone at high temperature.

3. The mobile phone is composed of precision electronic components, and there is a potential risk after water ingress, so please keep the mobile phone turned off.

4. If you don't have a backup data, there may be a risk of data loss during repair.

After the mobile phone is flooded, there will be a little water backlog in the speaker, so you can first turn the speaker down, hold the mobile phone and shake it a few times. Then wipe the speaker hole with a paper towel. Use a hair dryer to turn on the hot air and blow it on the speaker, don't blow it for too long, just about a minute.

If it is caused by water, it is recommended that users use a paper towel to wipe the speaker of the mobile phone, pay attention not to use force, and after making sure that there is no water, put the mobile phone in a cool and ventilated place to dry, and pay attention not to use the mobile phone during the period.

If this situation occurs after it has been dealt with, it means that it is a hardware failure, and it is recommended that the user directly contact the after-sales service for relevant testing, or find a mobile phone repair shop to clean up the speaker or replace the speaker.

Here's how to fix it:

1. After the mobile phone enters the water, there will be a little water in the speaker, you can first turn the speaker down, hold the mobile phone and shake it a few times.

2. Then wipe the speaker hole with a paper towel.

3. Use a hair dryer to turn on the hot air and blow it on the speaker, don't blow it for too long, just about a minute.

The speaker of the mobile phone is flooded, and there are many ways that it will not work, and it can make a sizzling sound.

If your phone speaker gets water, there is noise or other problems, you can try the following methods to solve it:1Vacuuming out the water:

With the phone's bell mouth facing down, use a vacuum cleaner to suck out the moisture at the horn, which can reduce the impact of moisture on the phone's horn. 2.With desiccant:

Put the phone in an airtight bag, add some desiccant, such as dried rice or silicone, and let the phone recover slowly in a dry environment. 3.Dry with a hair dryer:

Turn the hair dryer to a cold windshield, keep an appropriate distance, and dry the phone at the bell mouth, being careful not to blow too close or too long, so as not to damage the phone. 4.Go to a professional repair shop:

If none of the above methods can solve the problem, or you are not sure how to deal with it, it is recommended to go to a mobile phone repair shop that specializes in digging and transporting Qingye for repair. In short, if your mobile phone speaker is flooded, there is a noise or other problems, you need to take measures to deal with it in time to avoid judging the service life of the mobile phone before it rings. <>

Hello dear, happy to answer your <>

When the speaker of the mobile phone gets into the water, there will be a murmur. Here's how to solve this situation:1

Cut off the power immediately: When you find water on your phone's speaker, cut off the power of your phone immediately and do not try to press the button or charge it, as this will cause further water penetration into the phone. 2.

Disassemble your phone as soon as possible: Place your phone under a fan or hair dryer and wait for moisture to evaporate or dissipate heat. Or take the phone apart, remove the battery, and dry it with a hair dryer with strong wind.

3.Wait for the speaker to dry: Because after the phone speakers get water, the moisture will seep into the inside of the speaker.

At this time, you need to wait for the inside of the phone to dry completely and wait for a period of time before turning it on. 4.Spray with a special spray cleaner for mobile phones

If the mobile phone speaker is stuck by dust or foreign objects and cannot be opened, you can use the mobile phone special spray cleaner to spray and clean the speaker according to the operation method provided by the manufacturer, and then clean off the residue. 5.Factory Maintenance:

If the problem cannot be solved by the circular method, you can seek after-sales maintenance services from the manufacturer. It should be noted that if you are not a professional and are not familiar with the internal structure of your phone, do not try to disassemble your phone yourself to avoid causing more damage. <>

If you are using a vivo mobile phone, it may be caused by liquid ingress into the internal parts of the mobile phone, it is recommended to bring the mobile phone to the service center for testing and processing (customer service center address: enter vivo official website vivo**app--my--service outlets after-sales outlets--select provinces and cities to inquire about the address of the customer service center) It is recommended to call the customer service center in advance to confirm relevant matters and understand the working hours, so as not to delay valuable time.

If you are using a vivo mobile phone, it may be caused by liquid ingress into the internal parts of the mobile phone, it is recommended to bring the mobile phone to the service center for testing and processing (customer service center address: enter vivo official website vivo**app--my--service outlets after-sales outlets--select provinces and cities to inquire about the address of the customer service center) It is recommended to call the customer service center in advance to confirm relevant matters and understand the working hours, so as not to delay valuable time.