What tools do you need for table tennis table installation 5

Commonly used tools such as levels, wrenches, and loose mouths.

Introduction: The standard size of the table tennis table is: Table tennis table table size: 2740 1525mm Table tennis table height: 760mm Table tennis table net width meter, table tennis table net height meter:

Table tennis court: 1 73 of the football field, 1 7 of the tennis court, with a 75cm high baffle surrounded by a rectangle of 14m long and 7m wide, and the light (brightness should reach 1000 lux) is 5m above the ground.

So the above is standard.

1. The table of the table tennis billiard table, also known as the playing surface, is rectangular, long and wide, and the horizontal height from the ground is usually 18 30mm.

2. The table tennis table should have a 2cm wide white line along each of the four sides of the table, and each court should be divided equally by a 3mm wide white center line parallel to the sideline, which should be regarded as the area of each right hemisphere.

3. There are usually three types of table tennis tables: non-rolling tables, that is, there are no wheels at the bottom of the bottom frame; rolling, single-fold table; Rolling, integral folding table.

4.What are the requirements for table tennis tables for international competitions? The table must be ITTF approved and can only be blue or green in color.

5: The following parameters of the table tennis table are the focus of ITTF detection:

1) Length: 2740mm Width: 1525mm Height: 760mm

2) Elasticity: Release the table tennis ball from 300mm away from the table, ** height at 230 260mm 3) Friction coefficient: <.

Nowadays, most of the table design has been very user-friendly, most of them can be successfully assembled without tools, if the requirements are high, just find a level.

1.Wrench. 2.Screwdriver.

3.Spirit level.

4.Pliers.

5.Hammer.

Levels, wrenches, and other common tools.

1. We must first prepare the grid frame (network cable gadget).

2. Then put the net on the net post, the net cover should be straightened, not rolled together, it is best to flatten it, showing clear lines;

3. At this time, the ridge can be stuck at both ends of the grid and stuck under the table tennis field highball to form a hook pattern;

4. Then adjust the net and fix the net rope;

5. Finally, the table tennis net is installed.

The press of the table tennis table net is as follows:

First of all, pull the two brackets of the table tennis table net apart and fix the net cable on the bracket.

Flatten the ping pong net, being careful not to twist the net cables.

Determine the position of the table tennis net, place the table tennis net on the table tennis table, make sure that the net cable is parallel to the edge of the table tennis table sail grinder, and leave a certain margin on the brackets at both ends.

Push the two brackets of the table tennis table net towards the middle until the brackets fit snugly against the edges of the table tennis table.

To confirm whether the table tennis net is installed correctly, you can pull the sedan ear on the net cable several times to check whether it is firm.

Finally, adjust the table tennis net to ensure that its tension is moderate, not too loose or too tight, so as to facilitate the normal movement of the ball.

Note: Be careful when pressing the table tennis table net and avoid getting your fingers stuck in the middle of the net cable to avoid unnecessary injury.