-
Take the size and tell the master who played the cabinet, and leave a good place to put it in directly. Note: 1. Since the built-in oven should be closely fitted with the kitchen when installed, and the oven itself will heat up during use, it is necessary to pay attention to the installation distance when installing the built-in oven, especially to pay attention to heat dissipation.
2. All ovens are suitable for the installation of standard cabinets, because the temperature of the oven is very high during use, the cabinet with the electric oven must be made of special high-temperature resistant materials for electrical appliances to ensure safety. The oven can only be one side against the wall or one side has a cabinet panel to exceed the oven panel, do not design and install the refrigerator on the side of the oven, otherwise the refrigerator will consume more energy to achieve the cooling effect, and it is possible to destroy the insulation layer of the refrigerator, if it must be installed, you need to add a heat insulation board. In order to prevent the adjacent cabinet door panels from being damaged by high temperatures, it is required that there is a certain gap between the front panel of the oven and the cabinet body for air circulation.
All ventilation holes or vents must not be covered, otherwise the performance of the machine will be affected. 3. When the table is installed, no other kitchen appliances can be placed on the upper part of the oven. When installing a base cabinet, it is recommended not to install it under the stove, otherwise the heat generated during the operation of the oven will affect the operation of the gas stove.
At the same time, the height of the cabinet should be increased accordingly to increase the heat dissipation effect.
-
Personally, I think it is best to install it in a multi-layer cabinet, with a height of about meters, mainly to facilitate daily operation.
-
My home set, Depelec Depp oven and steamer, you don't need to install it, you take the size and tell the master of the cabinet, leave a good place for you to put it in directly. Note that if the plug is installed at the back, leave a position of 3 cm. As for who goes up and who goes down, it depends on your habits!
Mine is put in the steamer below.
-
Convenient location for access, countertop height.
-
The built-in steamer can be installed in the kitchen at that location, as long as it is convenient for your daily use, the best position is generally installed in a multi-layer cabinet, and the position should not be exceeded.
One is to install two fans of the computer behind the cabinet. The second is to use stainless steel to make a guide tube. This is also a lesson, the cabinet industry currently reaches the built-in home appliance cabinet only Zhide brand.
Zhide stainless steel cabinets are made of food-grade stainless steel, fireproof, flame retardant, high temperature resistant, baking, non-cracking, and unshaped. It can be guaranteed for 100 years. Solid wood cabinets, brand cabinets are sawdust, wood chips, particles, decorative board materials, and all crack and open glue for about half a year and a year.
Food-grade stainless steel adopts high temperature 2000 degrees high temperature baking and transfer technology.
-
If your home has not been renovated, it is recommended to install it in the multi-layer cabinet in the kitchen. My house has been renovated, and Fotile sent me an independent cabinet, which I put in the living room near the kitchen, which is very convenient.
-
It's okay, if it's a low cabinet, next to the kitchen stove, or if it's a high cabinet, put it in the middle, and you don't have to bend down when operating.
-
I bought it is embedded, and now the embedded one also has a large area, and the area of the Martian's X3 steam oven is also quite large, and the steamed vegetables can be steamed several at a time.
-
Built-in oven The steamer is installed under the operating table, and the middle of the high cabinet is too high to operate.
1. Advantages of installing under the operating table:It takes up little space and can be placed on top of the stove.
Disadvantages: It is easy to burn if you do not install a heat shield, and you have to squat down when you take things.
Second, the advantages of installing in the middle of the high cabinet:Save space, avoid children touching it, and avoid burns.
Disadvantages: It takes up a lot of space and needs independent space.
On the whole, it is more suitable to install it in the middle of the tall cabinet. The height is generally on the left and right, making it easy to pick up things.
Built-in oven The steamer is installed under the counter:
If the built-in oven is placed under the counter, then it is necessary to consider the safety of use. Keep a distance of more than 10 cm between the oven and the bottom of the worktop, and ensure ventilation around it, and the bottom of the cooktop and the oven should be separated by imitation heat shields. Prevent people from getting burned while working in the oven.
Built-in oven Steamer installed in the middle of the tall cabinet:
When installing the built-in steamer to the tall cabinet, it is important to note that the reserved position of the steamer is not too high. The installation height of the built-in steamer should be determined according to the height of the user, and the comfort during work should be the standard. (Generally, the installation height of the upper edge of the built-in steamer should not exceed 150mm).
-
General built-in kitchen decoration steps: select an overall style of cabinets, then select built-in kitchen appliances, reserve cabinet positions, and finally install. Therefore, the built-in steamer should be reserved for installation according to the type of cabinet.
The cabinets in the general kitchen are mostly a combination of wall cabinets + base cabinets, or they are simple base cabinet combinations. It is not recommended to install it on the wall cabinet, because the position of the wall cabinet is relatively high, and the load bearing is limited, it is not practical to install the embedded steamer (it is inconvenient to operate), and the embedded steamer can only be installed in the base cabinet or on the multi-layer cabinet.
-
Now the steam oven as a healthy cooking method is more and more accepted by the Chinese people, especially office workers, it is very convenient and fast to steam things or bake things with a steam oven, like me can't cook, so I chose the Yingxue built-in steam oven, look at the recipe with good ingredients, and then put it in and steam it, it's great, and I became a chef in a blink of an eye.
-
There must be, I'm one of them, I think it's worth buying, but depending on your needs, I think it's a lot more convenient to buy the built-in steam oven of Yingxue Appliances, which can save time cooking.
-
Now the steam oven as a healthy cooking method is more and more accepted by the Chinese people, especially office workers, it is very convenient and fast to steam things or bake things with a steam oven, like me can't cook, so I chose the Yingxue built-in steam oven, look at the recipe with good ingredients, and then put it in and steam it, it's great, and I became a chef in a blink of an eye.
-
It's not difficult, it's very simple, you can figure it out yourself, and if you still can't, you can read the manual.
-
Kitchen high cabinets come in height 70 cm.
Since 85 cm is the most suitable, after the installation of the steamer and oven, the sight line is just right to see the situation inside the oven, and the hand can easily press the button to pull the oven door.
-
Generally, the kitchen puts an oven and a steamer, taking into account the area of the kitchen, but also considering the aesthetics, Casarte version.
The appearance of the oven and the steamer are the same size, the right are 450 high, 595 wide, so that a cabinet in accordance with the words.
The order from top to bottom is: steamer, oven, make a cabinet drawer below, put some baking tools and molds, very practical, and beautiful
The concept of embedded is inherently vague, and to understand these two words. >>>More
1. Check whether the heat insulation and heat dissipation system of the oven is up to standard. >>>More
If you want to develop in the direction of embedded software, the most common direction is the direction of embedded Linuxarm, and I think there are about 3 stages in this direction: >>>More
Generally, embedded is to learn arm9 + linux
Linux at least has no problem with use, not with a mouse, but with a keyboard, open files, copy files, unzip, package, **source software, are very simple. Knowledge of Linux architecture. I don't say anything about the degree, the more familiar the better, especially the Linux composition. >>>More
Relying on perfect standardized management, Peking University Jade Bird has realized the large-scale development of the system through the two business models of college cooperation and authorized cooperation, which has been widely recognized by all sectors of society; With uncompromising educational quality, we are committed to making our students become respected professionals, and become a global professional vocational education product provider and service provider; With ingenuity and the spirit of exploration, we will cultivate and deliver a large number of high-quality technical and skilled talents for the society, and make due contributions to improving the structural contradictions in the supply of talents in the employment field. >>>More