Why can t I connect to the Internet with my wireless router?

If your gateway settings are then ping. If the feedback is normal. Then it's a problem with the wireless part of the route.

The IP settings of your wireless network card are changed to the same as those of the wired network card. Temporarily disable the wired network card. Try...

If it doesn't work yet. It's a matter of setting up unlimited routing. Or the wireless part of the wireless router is broken.

Then change it. Or not wireless. Let's start with that.

Let's talk about it step by step.

Then reset the route. Press and hold down which reset hole with a sharp object for 10 seconds... Then reconfigure it. If it doesn't work yet. Let's reflash the routing software. Just upgrade.

Log in to the router to see if there is something wrong.

Problems with the wireless router settings.

It is recommended that you directly make the wireless router the main router!

I've had several cases where I'm using a router and still using my computer's broadband dialer to dial numbers, so of course I can't connect.

When we have a route, we need to find the WAN port parameter setting page in the routing management page, select the connection mode as PPPoE, and then fill in your payment and password below it. In the future, the original broadband dial-up will be replaced by routing, and the computer can only use the local connection.

Do not turn on the automatic broadband dial-up in the computer (turn off the automatic dial-up in the settings interface of the dialer program), and then set the local connection in the network connection as the default, and you should be able to access the Internet directly by opening the browser.

IP and so on are automatically obtained by default, and it is not moved to be. ）

The router can be connected, but it can't access the Internet normally, which is related to the following reasons:

1. If the router is faulty, if the broadband information is filled in correctly, the router can be restarted, and it may be restored.

Precautions. If the optical signal indicator flashes red, and there is no arrears when you call customer service, then it may be caused by an external network failure, the most common being that the optical fiber is cut off, hung up, and encountering extreme weather, etc., resulting in temporary paralysis of the external network network.

In addition to the above three common situations, there are also some situations that may cause the router to be connected to the Internet, but unable to access the Internet, such as optical modem damage, router damage, network cable interface damage, network cable damage, etc., but under normal circumstances, these devices and lines will not have problems, and can only be checked and eliminated one by one according to the actual situation on site.

It's usually a setup issue. Including username, password, DNS, find the carrier when they are correct.

It may be that you have set up some security measures such as passwords to surf the Internet.

1. The computer at the beginning can be connected to the Internet, which means that your routing configuration is fine.

2. I didn't use the router for a while, so I unplugged it, and if I didn't touch the data inside, the data configuration should be fine.

3. The wireless signal can be received on the mobile phone, which means that the router is good, no problem.

4. If you unplug it and then connect it, you can't automatically dial the number, and you can't get on the network, which means that the problem is likely to be that you plugged the wrong wire.

Solution. 1. First of all, make sure that the network cable out of your cat is directly connected to the computer and can dial up the Internet.

2. After determining that the main line can access the Internet, connect the cat's network cable to the WAN port of the router, determine that it is the WAN port, and the computer is connected to the LAN port, that is, the port marked with the number, 3. If the above two points do not work, please ask someone from the computer company to help configure the router, or directly search for the configuration method of the same model of router.

It is recommended that you set up your wireless router again! It may be that the configuration information inside is missing!! You can go into the wireless router to see if the play and port are connected! Is there data to show it!

Your account password is incorrect