A few questions about the results of the ping command? Forget all the masters to give advice!

1. The sensor is damaged, the contact is poor, or the signal is interrupted; 2. Poor engine maintenance; 3. The quality of fuel and oil is not good; 4. The combustion of the mixture is insufficient; 5. a spark plug.

malfunction, ignition coil failure; 6. The fuel pump is faulty and the oil circuit is blocked; 7. The air conditioner filter is blocked.

1. Sensor problems; The sensors mentioned here include water temperature and crankshaft.

Position, air flow, intake air temperature, oxygen sensors, etc., when these sensors are damaged, poor contact or signal interruption, the ECU of the car cannot accurately obtain engine data, and the engine failure light will be on. 2. Maintenance problems; Poor engine maintenance is the most common cause of engine failure to light up. We know that the vehicle has a certain maintenance cycle, if the owner does not maintain on time, coupled with bad driving habits, then it will increase the burden of engine operation, and finally can only remind you through the fault light to care about your car 3, oil quality problems; The oil quality here includes fuel and engine oil, we know that the fuel filled by the car is generally marked, and the engine oil is also semi-synthetic and fully synthetic, the manufacturer will generally recommend the owner to use which grade of fuel, which type of engine oil, if the owner does not add as required, it will cause wear and tear of the engine in the long run, and the fault light is not to blame.

Poor combustion of the mixture; The failure of the spark plug, ignition coil, fuel pump, and oil circuit blockage of the engine will cause poor combustion of the engine mixture. Poor combustion of the mixture is caused by the problem of engine carbon deposition or knocking, and these will eventually be detected by the engine's oxygen sensor and reported to the ECU, which will naturally turn on the fault light to warn of the intake air intake problem; When the engine burns, it needs to take in the air, and in the process the air cleaner is required.

It is very important, if the air filter of the car is not clean, it will affect the air intake of the car if it is not cleaned regularly, and it will be blocked in the long run, and in serious cases, it will cause the engine failure light to turn on. pressurization issues; Intake booster lines, turbochargers.

It will also cause the engine failure light to illuminate. The most common of these is turbocharger damage, while the vehicle can also experience symptoms such as oil leakage, high oil consumption, loss of power, metal noise, and blue or black smoke from the exhaust pipe. 7. Exhaust problems; Rear oxygen sensor, three-way catalytic converter.

Exhaust camshafts and bearings.

The most common of these is a failure of the three-way catalytic converter that causes the engine failure light to illuminate. The use of leaded gasoline, the use of leaded or silicone lubricant additives, the bump of the three-way catalytic converter, and the failure of the engine oil supply system are some of the factors that can easily cause the failure of the three-way catalytic converter. anti-theft system; If the car's electronic immobilizer fails, or if the immobilizer does not match the engine electronic controller, the immobilizer system will also cause the engine to not work properly and the engine fault light will be lit at the same time.