-
Anonymous users2024-02-081. Power supply problem: check whether the power connection is normal. Open the door and observe whether the light in the box is lit, or test it with an electric pen.
2. Compressor problem: If the power connection is normal, listen to whether the compressor is working. The compressor will emit a slight vibration motor sound when working normally (if you feel the vibration of the compressor with your hands, you should be careful not to burn, because the compressor temperature is 40-50 in winter and 80-90 in summer).
-
Anonymous users2024-02-07If the door lock of your Royalstar drum washing machine keeps ringing and you can't open it, it could be caused by several reasons:
The washing machine is running: The washing machine door lock is usually locked while the washing machine is running to ensure that the water inside the washing machine does not overflow or the outside cannot interfere with the washing process. If the washing machine is running, you will need to wait for the laundry program to complete before unlocking the door.
Faulty door lock: If the door lock of the washing machine is faulty, it may cause the lock to not be released properly. This can be caused by damage to the door lock itself, loose connection wires, or a malfunctioning electronic control board.
Workaround: First, you can try disconnecting the power of the washing machine, wait a few minutes and then reconnect the power supply to see if you can reset the door lock system. If the problem persists, it is recommended to contact the after-sales service center of the Royalstar washing machine for further troubleshooting and repair.
-
Anonymous users2024-02-06Summary. Hello, the unlocking method of the door lock of the Royalstar washing machine is as follows: 1. The middle display of the two buttons on the Royalstar washing machine is a child safety lock; 2. Press and hold the two buttons at the same time for 3 seconds to directly unlock the child safety lock; 3. Child safety lock, when the washing machine is working, press these two buttons at the same time, the washing machine will be locked, if the child presses the button randomly, it will not work.
Only by pressing and holding the same button at the same time to unlock it, the other buttons of the washing machine can be restored.
Hello, the unlocking method of the door lock of the Royalstar washing machine is as follows: 1. The middle display of the two buttons on the Royalstar washing machine is a child safety lock; 2. Press and hold the two buttons at the same time for 3 seconds to directly unlock the child safety lock; 3. Child safety lock, when the washing machine is working, press these two buttons at the same time, the washing machine will be locked, if the child presses the button randomly, it will not work. Only by pressing and holding the same button at the same time to unlock it, the other buttons of the washing machine can be used to resume the use of filial piety.
Extended information: The correct maintenance method before the completion of the washing machine can make the washing machine last longer (1) The washing machine has been out of use for a long time, so it is necessary to remove stagnant water and keep it clean and tidy. (2) It should be placed in a dry, non-corrosive gas, no strong acid and strong alkali erosion, so as to avoid rust of metal parts and reduce the insulation performance of electrical components.
3) If it is a washing machine, if there is no oil filling hole for the wheel shaft, the washing machine should be filled with oil once to prevent rust. (4) The washing machine that has been stored for a long time should be covered with plastic cloth or cloth cover to avoid dust erosion and keep the washing machine bright and tidy. (5) The machine should be turned on every other month to prevent the parts from rusting and the motor winding from being damaged by moisture.
Energizing is also a means of drying the windings, which avoids failures caused by prolonged downtime. (6) The washing machine should not be exposed to direct sunlight for a long time, especially for plastic devices, so as not to fade and age.
-
Anonymous users2024-02-05What is the problem of Royalstar automatic washing machine not washing?
1. Bearing damage or lack of lubricating oil Due to the long-term use of the washing machine, the motor bearing and the inner shank spindle bearing lack lubricating oil, or the shaft bearing is broken. Strong noises and unusual noises are emitted during washing, especially during high-speed dewatering. >>>More
Or: Enter in the ledger.
echo off >>>More
First, change the card reader to see, and second, if you are using an extension cable, please do not use the socket on the back of the motherboard, if not, format it first, and then use finfmyphotos to recover your deleted photos.
The washing machine wheel slipped for two reasons:
1. The pulley has been used for a long time, the wear is large, the friction is reduced, and if it is used frequently, the perimeter of the pulley tension will increase, and it is necessary to replace the new pulley. >>>More
Friend, this is simple, make a wooden base, do it according to the base of the washing machine, and when it is done, the washing machine will not be displaced when you put it on this base.