How do I set up two different brands of routers to use one of them as a switch? 5

I'll do this. Two routers . where route 2 is the switch.

Connect the network cable to the LAN port of 2, then 2 is a switch. The WAN port of 2 is not connected, and the rest of the LAN ports can be used as network ports. You can connect from the LAN port of 2 to the WAN port of 1, then 1 is a router, which can be used for multiple computers to access the Internet.

The problem of setting: set the LAN of 2 to OK, and set the LAN of 1 to OK. Groping for yourself, hehe.

a. The first router.

b. The second router.

A. The WAN port is connected to ADSL

A Settings: LAN Settings:

Subnet Mask:

DHCP Settings:

Enabled: From to.

Gateway: B Settings: LAN Settings:

Subnet Mask:

DHCP Settings:

Enabled: From to.

Gateway: Connection method: LAN port A is connected to LAN port B.

Turn all the power on after plugging it in.

2. Find the name of your router, the name is the default of the router when it leaves the factory, your router is not set, there is no password, the signal is the strongest, you can connect to it.

3. After the laptop is connected to the router, open the browser and enter it in the address bar.

4. The first login will prompt you to set the router login password, that is, the administrator password.

5. After setting the administrator password, click Next, the set password interface appears, click "Auto Detect" Internet access, wait for a while, and then enter the broadband and password.

6. After entering the password, click Next, the WiFi name and WiFi password setting interface will appear, and click Next after setting.

7. The basic settings are completed here, and after clicking, disconnect the wifi connection. Since the wifi name has been changed, the next step is to reconnect the wifi name after the setting, enter the wifi password, and click the combo to access the Internet.

There are two ways to connect a switch to a router and set up a router

The first method: dynamic IP mode.

1. Plug in the router, don't connect the switch first, reset the router (restore the factory);

2. Connect the computer to any LAN port of the router and enter the setting page;

3. Set according to the dynamic IP;

4. Then set the SSID, encryption method and password;

5. Save and restart;

6. After setting, connect the network cable from the switch to the WAN port of the router.

The second method: wireless AP mode.

1. Connect the computer to the LAN port of the router and change the IP address of the router. For example, most router addresses are, we just need to change the router IP address;

2. Turn off the DHCP function of the router in the settings;

3. Finally, connect the network cable from the switch to the LAN port of the router (any one is fine), note that it cannot be the WAN port.

There should be a primary router connected to the Internet, which can be used for dial-up Internet access or fixed IP (Internet segment) Internet access.

Connect a network cable from the LAN port of the main router to any port of the switch, and then connect the network cable from the other ports of the switch to the WAN port of the sub-router.

The sub-router should be set up on the same network segment as the main router, and the sub-router should be set to dynamically obtain the IP address, you can do it, if you have any questions, please say, if it helps you, don't forget to click to adopt, thank you.