BMW 320i2, how to zero 0t maintenance

Go to 4S or a large repair shop, plug in the detection interface at the bottom left of the steering wheel to eliminate the fault** on the line, and it will be free in 5 minutes.

Generally, you can go to the SSSS store to eliminate it.

It can only be recovered and zeroed using a detection computer.

Use the operation key on the instrument cluster to reset the Mintan.

The operation method is shown in the following figure:

1. When the ignition switch is off, press and hold the "Reset" button.

2. Turn on the ignition.

3. Release the "Reset" button and press the "Clock Adjustment" button once.

4. The maintenance cycle is shown early, and it is in the state of resetting Lu Nachang mode, and the normal view will be restored after a few seconds.

5. After the reset is completed, you can check the interval mileage from the next maintenance, the method is: press the "clock adjustment" button 4 times, and the multi-function display will display the interval mileage from the next maintenance.

Reset with the operation key on the instrument cluster.

The operation method is shown in the following figure:

1. When the ignition switch is off, press and hold the "Reset" button.

2. Turn on the ignition.

3. Release the "Reset" button and press the "Clock Adjustment" button once.

4. The maintenance cycle display is in reset mode, and the normal view will be restored after a few seconds.

5. After the reset is completed, you can check the interval mileage from the next maintenance, the method is: press the "clock adjustment" button 4 times, and the multi-function display will display the interval mileage from the next maintenance.

Rich people, what does the boss do.

Eliminate it with an external control computer program.

The operation method is shown in the following figure:

1. When the car reaches the maintenance cycle, the oil change indicator light on the car dashboard will light up, which needs to be manually eliminated.

2. Use an external laptop to connect to the driving computer.

3. Connect the external control computer of the car to the on-board computer, and select the engine option.

4. After that, select the matching function and enter the function module.

5. After that, it will prompt that the control module accepts the request and will update the read data.

6. After that, the pop-up interface selects the maximum time value for maintenance. Modify the stored data to new data so that the service interval is not further prompted.

7. After clicking OK to modify the new data, there will be no maintenance prompt.