How to install the switch socket on the soft package, how to install the socket on the soft package,

1.The soft package is usually installed by the processing unit outside the soft package;

In fact, the installation is very simple, the inner side is stuck first, and then press it to see if it is overall shy;

1. Switch and socket installation process.

1. Clean up. Use pliers to gently remove the remaining ash in the box, and at the same time remove other debris from the outside of the box, and then wipe the dust in the box with a damp cloth. If there is dirt on the wire, it should also be cleaned together.

2. Wiring. A switch wiring provisions: the phase wire of electrical appliances and lamps should be controlled by switches. When the switch is wired, the wires in the box should be straightened out, and after the wires are connected in turn, the wires in the box should be coiled into a circle and placed in the switch box.

b Socket wiring regulations:

Single-phase two-pin sockets are available in horizontal and vertical installations. When installed horizontally, the right pole facing the socket is connected to the phase wire, and the left pole is connected to the zero wire; When installed vertically, the upper pole facing the socket is connected to the phase wire, and the lower pole is connected to the zero wire.

The grounding or neutral line of single-phase three-hole and three-phase four-hole should be above.

When AC, DC or sockets of different voltages are installed in the same place, there should be obvious differences, and their plugs and sockets cannot be substituted for each other.

C wiring requirements: first leave the wire thrown out of the box for maintenance length (15 20cm) to cut off the insulation layer, pay attention not to touch the core, such as the switch, socket for the binding post, the wire according to the clockwise direction on the switch, the socket corresponding to the binding post, and then tighten the indenter. If the switch and socket are plugged terminals, fold the wire core back and insert it into the round hole terminal (when the hole is allowed to press double wires), and then press it with a top wire, pay attention to the wire core shall not be exposed.

d Special attention should be paid to wiring: in order to ensure safety and use function, all kinds of wires in the distribution circuit should not be connected to other branches in the terminal of switches and sockets in the form of socket crimping.

<> install it with extension screws, but the bottom box must be installed in the wall first.

Use a wooden or plastic switch box to cut the soft bag according to the size, and connect the soft bag and the switch with a decorative strip.

1. Determine the position of the socket on the soft package background wall, and groove behind the soft package background wall to match the size of the socket;

2. Make a box with wooden materials around the slotted background wall of the soft package to fix the socket, the size of the box cannot exceed the size of the socket panel, and fix the box at the position of the socket on the soft package;

3. When the front soft bag is opened, the soft bag cloth should not be cut squarely, but the cloth should be cut according to the diagonal line of the box, and the shape after cutting is four triangles, and the cloth should be kept;

4. Turn the triangle-shaped upholstered cloth inward into the box and connect it with the box (fix). Finally, install the socket panel to the outside of the slot.

Same as normal installation, first pipe the offline box, fix the box, and then pack it up! The socket is fixed on the box, if the box is not off at that time! Use glass glue, and you can cut it off if it's broken!!