What should I do if the connection is always disconnected, and how can I break it often

2 questions. One is that there is no money to be old. One is the wrong password.

Summary. The reasons for frequent disconnection are: 1. The most common is that the network card is set to the energy-saving mode, when the device is idle, it will be powered off, resulting in networking failure, and the system restarts the network card device, resulting in repeated occurrence of this state, at this time you can try to remove the power-saving mode.

2. Start the Control Panel network connection. 3. Right-click the Local Connection property. 4. General configuration of local connection attributes.

5. Power management Remove the check check OK before allowing the computer to turn off this device to save power. 6. In addition, sharing a broadband network cable, a user in **, ****, often will also lead to another user's network stagnation (sometimes good and sometimes bad). 7. Finally, if there is a problem with the network, you may wish to use the disconnected first aid kit tool to detect the location of the fault, and then prescribe the right medicine to eliminate the fault.

The reasons for frequent disconnection are: 1. The most common is that the network card is set to the energy-saving mode, when the device is idle, it will be powered off, resulting in networking failure, and the system restarts the network card device, resulting in repeated occurrence of this state, at this time you can try to remove the power-saving mode. 2. Start the Control Panel network connection.

3. Right-click the Local Connection property. 4. General configuration of local connection attributes. 5. Power management Remove the check check OK before allowing the computer to turn off this device to save power.

6. In addition, sharing a broadband network cable, a user in **, ****, often will also cause another user's network to stop and stagnate (sometimes good and sometimes bad). 7. Finally, if there is a problem with the network, you may wish to use the disconnected first aid kit to detect the location of the fault, and then prescribe the right medicine to eliminate the fault.

Can you tell us more about that?

If it's a problem with the router, if it can be used originally, it can't be used temporarily, my own practice is to disconnect the power supply of the router in the source booklet, and I'll see. In there is a factory reset settings,You can use it in strict accordance with the manual settings from the grip search,I don't understand,It's not recommended to set it at will (this is under the premise of the correct physical connection,Sometimes it's caused by the slow or failed to find the IP address of the router,It's not that the router is broken)Hail macro。

What software do you use to dial up? Or use a router? It's probably a software problem, which is the software that you're talking about that reads scripts.