Is underfloor heating or plumbing better?

1. There are roughly two types of floor heating, one is water floor heating, and the other is electric floor heating (carbon crystal is also counted).

2. If it is water floor heating, the advantage is that the comfort is very high, the heat dissipation is uniform, the heat lasts for a long time, and the disadvantages are slow heating, difficult maintenance, and the floor height will be increased.

3. The water heating you said should be a radiator (radiator), if you have a heat source such as a gas stove installed at home, then the heat sink is also good, the advantage is that it heats up quickly, closes simply, has low energy consumption, and the disadvantage is uneven heat dissipation, there will be obvious air convection, the heat sink may increase the difficulty of your interior decoration, and the heating process will drive the surrounding dust to flow and then accumulate on the wall above the heat sink, and it will also change the color of your wallpaper or wall after a long time.

4. From the perspective of the effect alone, the effect of floor heating will be far better than that of radiators (radiators).

5. You can reply to me about the specific points you can say, your purpose, and your consideration. Specific problems are analyzed on a case-by-case basis.

This should be compared, the floor heating is not easy to maintain, the radiator is easy to maintain, and now there are many decorative radiators, very beautiful. As for the comfort, it is more comfortable to have floor heating, after all, it is radiant heat dissipation, and it is hot from the bottom up! If it is a household, it is recommended to have underfloor heating.

Underfloor heating is better and requires a humidifier.

Wanjia Heating Intelligent Electric Floor Heating Cable Electric Floor Heating There are national design standards Comfortable and environmentally friendly You can go to the ** on the product Thank you.

Under normal circumstances, floor heating is better, but there are installation restrictions, requiring installation before laying the floor, and wall heating I think is a substitute product for insufficient floor heating, which cannot be said to be bad, but it will occupy some wall space. Here's a look at the benefits and advantages of underfloor heating:

1.Compared with air conditioning heating, air conditioning heating is a heating method for heating air, indoor dry heat, peculiar smell, water loss, dry mouth, indoor dust, dirty air convection and other phenomena, using graphene electric heating film heating, radiation far infrared direct heating, far infrared and sunlight waves in the same belt, medically become the "light of life", so use it to heat as warm as the sun.

2.Compared with pipes: Pipes can not only keep warm, but also provide domestic hot water, which is incomparable to other heating methods.

However, repairs are required every year after pipes are prone to water pipe rupture, resulting in high maintenance costs. It brings a lot of inconvenience to life. After installing the graphene electric heating film, there is no need to clean, add or replace materials, and it will not cause any damage for more than 30 years.

3.Electric floor heating also has the following advantages: the temperature is concentrated in the main area of human activity below the meter, and the energy saving is more than 30; The conversion rate of electric heating film is high (more than 80), and the electricity consumption time is 1 4 of the use time, which is 25 of the energy consumption of air conditioning; Silent the whole heating process, no light, no pollution, worthy of the name of healthy, energy-saving, comfortable green products; No occupations: This area is conducive to interior beauty and decoration, increasing the actual effective space of the room; The single rooms are controllable, and each room is equipped with an independent smart thermostat to meet the requirements of energy saving.

The power conversion rate of the far-infrared electric heating film heating system reaches more than 80, and the electric energy is basically completely converted into heat energy. Therefore, graphene electric heating film is more energy-efficient.

Difference 1: The heating method is different, and water heating is a heating method that provides heat to the room through the heat transfer of radiation and convection from the ground. The electric heating uses the heating cable as the heat source to heat the floor, and the thermostat controls the room temperature or floor temperature to realize the heating mode of ground radiant heating.

Difference 2: The composition is different, the plumbing composition includes boilers, water collectors, ground coils, ground auxiliary materials, thermostats and some elbows. The floor heating consists of heating cables, thermostats, and ground auxiliary materials.

1. What is the difference between plumbing and electric heating? 1. The structure is different The plumbing is mainly composed of boilers, water collectors, ground water pipes, radiators, thermostats and connecting accessories and auxiliary materials. Electric heating is mainly composed of three parts: heating main materials (including carbon fiber film, carbon crystal film, carbon fiber cable, heating cable, etc.), thermostat and auxiliary materials. 2. The installation cost and use of different plumbing ** are relatively fixed, in a general sense, the larger the heating area, the lower the single-sided construction cost; The smaller the heating area, the higher the cost of single-sided construction.

Electric heating is basically unified, and there are no above problems. Due to the different installation conditions, house types, house insulation structures, etc., the use cost varies greatly, which should be calculated in combination with the actual local situation. 3. Different heating methods Water floor heating is a heating method that uses hot water with a temperature of no more than 60 as the heat medium, circulates in the heating pipe buried in the filling layer below the ground, heats the whole floor, and heats the room through the heat transfer of radiation and convection.

Floor heating is a heating cable that buries the upper limit of the allowable working temperature of 65 on the outer surface in the floor, heats the floor with the heating cable as the heat source, and controls the room temperature or floor temperature with a thermostat to achieve radiant heating on the ground. 2. Which is better for plumbing and electric heating 1. Upfront cost If a small area such as 60 square meters or less is used for heating, it will not be cheap on the average per square meter. Recommendations:

The heating area is 60 square meters and the electric floor heating is used for 60 square meters, and the floor heating is any water heating or electric heating in 60 square meters, and it is recommended to do water heating in more than 90 square meters. 2. Usage fee If there is no half-price electricity at night, electricity is much more expensive than plumbing, and electricity is slightly more expensive than water in the case of half-price billing. The normal heating area is 100 square meters, about 800 1000 yuan per month.

If you run at a high temperature, the gas cost will be about 10 yuan more per day. 3. In terms of maintenance, the most electric floor heating is that the temperature control is broken. The most vulnerable areas of plumbing are the thermostats and drive valves.

4. Comfort Water floor heating is similar to electric floor heating, but in particularly cold weather, water floor heating will be better than electric floor heating, because the water temperature of the water heating boiler is normally set at 60 degrees, and the water temperature can be set higher when the weather is too cold, so that the radiator will be larger, and the temperature will be increased.

Floor heating or electric heating is better to choose according to the specific situation: if the home area is large and there are elderly and children, it will be more comfortable to install water and floor heating; If the permanent population of the home is small and the heating area is small, you can choose electric floor heating, and small households can also choose electric floor heating, and the overall cost will be less.

Advantages and disadvantages of plumbing and electric heating:

1. Advantages of floor heating: it heats up relatively smoothly, is more suitable for a small room where a family lives together, has a long service life, and can provide hot water for daily life.

Disadvantages: The early installation cost is relatively high, and the later maintenance is relatively troublesome, which requires regular cleaning and high power consumption.

2. Advantages of plumbing: plumbing is more suitable for villas and the like, that is, it is more suitable for large living rooms. The advantage is that it does not need to be cleaned regularly, nor does it need regular maintenance, and the follow-up maintenance cost does not need to be too high, and the cost will be much lower than that of electric heating.

The disadvantage is that it cannot provide users with domestic hot water, and the requirements for the circuit equipment at home are relatively high, which is not suitable for laying a large area, and there will be a certain amount of radiation.

Precautions for underfloor heating construction

1. Floor heating installation needs to find a professional, formal and experienced construction team for installation. Floor heating installation is a concealed project, and the professional construction team usually carries out construction acceptance in accordance with the relevant specifications, which can effectively avoid various problems such as uneven room heating due to non-standard floor heating installation, and also reduce the probability of floor heating maintenance in the later stage.

2. Pay attention to the details when installing floor heating, for example, the ground must be dry when paving floor heating. During or after the installation of underfloor heating, it is not possible to punch holes and nails in the ground. The laying shape and spacing of floor heating pipes should be calculated to avoid the situation that the local heating is not hot.

Before the floor heating backfill, check the air tightness of the heating pipe, backfill can use fine stone concrete backfill, one-time pouring concrete area should not be too large, should use artificial vibration, artificial paving way to lay concrete backfill layer and so on.