Instructions for the use of the incubator and how to use the incubator

The introduction of the waterbed incubator and how to use it Artifact for breeding enthusiasts.

Summary. 1. Ensure the safety of the power supply before use; Choose normal eggs; The total weight of eggs held by the incubator cannot be regulated; Put the machine in the room, keep the temperature at 14 30, and the room should not have chemicals, vibrating objects.

2. About 16 24 hours before preparing for incubation, the incubator should be connected to the power supply, and the water tank in the incubator should not be filled with water.

How to use the incubator?

Hello, I hope to help you with the hail I hope to help you, first, the use of method 1, to ensure the safety of the power supply before the use of the bending sail; Choose normal eggs; The total weight of eggs held by the incubator cannot be regulated; Put the machine in the room, keep the temperature at 14 30, and the room should not have chemicals or vibrating objects. 2. About 16 24 hours before preparing for incubation, the incubator should be connected to the power supply, and the water tank in the incubator should not be filled with water.

Cover the incubator, close the bottom, and power on to test whether the machine is normal.

Three days to start every morning and evening or every 12 hours to turn the eggs, to ensure that at least two times a day to turn the eggs, the angle of turning the eggs 180 degrees, the other potato dust stool of the egg up, in the Miteto to turn the eggs, the eggs in the machine, the middle of the edge, the edge of the middle, so as to improve the hatching rate, the egg turning at the same time to check the water in the sink.

The incubator is fully automatic, how to use the switch, how to press the switch.

Please wait patiently for a few minutes, we are sorting it out, and we will answer you immediately, and please do not end the consultation.

Hello personally for you to inquire hope to help, boot: switch opening order is: main switch (voltage regulator), power switch, fan open and off, heating switch, humidification switch. The light switch can be turned on and off as needed;

1. What is an incubation travel machine Incubator is a closed machine that can control temperature, humidity and oxygen concentration, which can be used to incubate small animals, such as eggs, duck eggs, goose eggs, etc. 2. What are the functions of the incubator The incubator can control the temperature, humidity and oxygen concentration, so that the environment is suitable for small animal incubation, and can also view the temperature and humidity in real time, control heating and cooling in real time, adjust humidity, lighting and other functions. 3. What kind of animal incubator can hatch eggs, duck eggs, goose eggs, fish eggs, lizard eggs, butterfly eggs, etc.

4. What are the correct steps for the use of the incubator (1) Put the incubator in a quiet, well-lit place so that it will not be disturbed by the outside comma; (2) Choose the correct incubation mode according to the type of egg; (3) Prepare eggs according to the operation requirements; (4) Put the eggs into the incubator; (5) Regularly inspect the process of incubation burying bench; (6) Adjust the temperature and humidity according to the prompts; (7) Wash and ventilate the eggs regularly; (8) After the hatching is completed, take out the eggs and do a good job of follow-up care.

Here's how to make a homemade incubator:

First of all, to make an incubator, you need to prepare materials and tools, including wooden strips, steel plates, insulation, hot water pipes, light bulbs, thermometers, etc.

To make a box, make a box that resembles a cuboid out of wooden strips, and leave a small opening at the bottom of the box for the hot water pipes. The perimeter of the box can be filled with thermal insulation.

Make a circuit that needs to contain a temperature controller, heater, light bulb, and thermometer. They can be connected using wires. Install thermal insulation and stick insulation to the inside of the incubator to ensure that the incubator can be effectively insulated.

Install the heater and light bulb and secure the heater inside the box, close to the hot water pipes, so that heat can be generated. Light bulbs are used for lighting, and the temperature can be adjusted by switching between different bulbs.

Thermometers and hygrometers are installed, which can be used to monitor the environmental parameters in the incubator for adjustment. Inspect the circuits and tests, accept all circuits and test them to ensure that all devices are working properly and that the temperature and humidity can reach the correct preset levels.

The hatching box for the parrot is glued together with plywood and wooden strips. Parrot incubators are generally divided into two types: horizontal nests and vertical nests, but most of them choose vertical nests, and the selection of materials is generally made of plywood and wooden strips, which can be glued and nailed. The size of the parrot breeding box can be designed according to the size of the parrot cage.

The correct way to raise parrots

Daily feeding of all parrots, a certain treasure of mixed grain with vegetables, fruits can be. Some large parrots, in order to make nutrition more balanced, are often equipped with Hasen nourishing pills, and small and medium-sized parrots do not need it. Cuttlefish bones are given during breeding.

Most players will take out the hand-raised and feed the milk powder after the bird hatches for more than 20 days, so that the bird will be more affectionate when it grows up.

Daily interaction parrots need their owners to have enough time to play with it, interaction, especially large parrots, if left unattended for a long time, or suddenly change owners, they will get depression and plucking. If you train well, you can learn a variety of skills. Parroting requires the owner to repeat it for a week or more, so you have to be patient.

Hygienic care. To raise parrots, it is necessary to clean up the feces in the cage in time and disinfect them to prevent bacterial infection. Parrots especially like to bathe, give him enough water regularly, it will wash itself, be sure to control the water temperature in winter, and dry it with a hair dryer in time.