The water pipe is not smooth, how should it be dredged?

You can prepare a simple unclogging device at home. Insert the chain into the drain pipe and shake it with your hand. Pour the appropriate soda solvent into the slightly clogged pipe and wait for about 15 minutes for the blockage to break down on its own.

Then pour in enough water and use the skin to pump up and down to increase the suction and pressure until it is smooth. Find a leather pipe that fits into a small water pipe and connect the other end to the faucet. Then screw the faucet to the maximum and use the momentum of the tap water to hit the blockage.

Insert a log very close to the drain into the drain and fill the pool with a sufficient amount of water, then quickly pump the log up and down. Under the action of pressure and light, the dirt in the pipe may be washed away; Or use the pump dredging method, when the nearby small pipe is blocked, you can plug the hose of the pump into the sewer and seal the drain, and then put in enough water to quickly pump the pipe into the sewer to dredge.

Water drain dredging agents. For blockages caused by oil, hair, paper, etc., this method has a significant dredging effect. It is widely used in restaurants, hotels, homes, etc. for dredging vegetable sinks, basins, bathtubs, floor drains, and toilets.

Summary. Hello, you can dredge it with the following methods.

After the water pipe is blocked, it can be dredged by water pressure, chemical dredging method, tool dredging method, etc. Take the water pressure dredging method as an example, open the end of the pipe, increase the water pressure with a pressurized pump, and use the pressure to dredge it. Fill the pool with clean water, pour in an appropriate amount of white vinegar and stir, fully dilute, open the valve of the tap water, if it is still a little blocked, find a chopstick, take the facial tissue at home, take enough facial tissue paper to knead into a paper ball, place it in the water pipe, use chopsticks to reach into the water pipe, and wipe the inner wall of the water pipe with facial tissue.

Precautions for cleaning water pipes:

1. Close the main valve of the household water pipe, close the valve of wading electrical appliances, the toilet bowl, the water tower valve, and the water purifier valve.

2. Turn on a faucet at home that is lowest or closest to the water meter, use a bucket to connect the remaining water in the pipe, and then mix food-grade citric acid according to the remaining water connection.

3. Dissolve in 50-60 degrees of warm water according to the ratio of 1 kg of citric acid to 10 kg of water, try to dissolve citric acid in more warm water, and keep it for later use.

How to unblock a blocked water pipe.

Hello, you can use the following methods to dredge the water pipe blockage, you can use water pressure, chemical dredging, tool dredging and other methods to dredge. Take the water pressure dredging method as an example, open the end of the pipe, increase the water pressure with a pressurized pump, and use the pressure to dredge it. Fill the pool with clean water, pour in an appropriate amount of white vinegar and stir, fully dilute, open the valve of the tap water, if it is still a little blocked, find a chopstick, take the tissue paper in the house, take enough tissue paper to knead into a paper ball, place it in the water pipe, use chopsticks to reach into the water pipe, and wipe the orange noise on the inner wall of the water pipe against the facial tissue.

Precautions for cleaning water pipes: 1. Close the main valve of the household water pipe, and close the valve of wading electrical appliances, flush toilets, water tower valves, and water purifier valves. 2. Turn on a faucet at home that is lowest or closest to the water meter, use a bucket to take out the remaining water in the pipe, and then mix food-grade citric acid according to the remaining water leakage of Fuwu.

3. Dissolve in 50-60 degrees of warm water according to the ratio of 1 kg of citric acid to 10 kg of water, try to dissolve citric acid in more warm water, and keep it for later use.

Soak in citric acid for half an hour, start cycle pulse cleaning, when cleaning, you need to open the filter screen on the faucet, and you need to open the faucet one by one to shoot the blind sewage, and then open the next faucet after the cleaning is completed 5. All the water pipes are cleaned, and then the electrolytic tube can be cut off from the machine, and all the closed valves can be opened to restore the original state.

I hope mine can help, and if you can give me a thumbs up.

If there is a blockage in the water pipes at home, there are actually several ways to dredge it, and the easiest way is to go directly to the supermarket to buy pipe unclogging agent. Before going to bed at night, we can turn on the pipe dredging agent, and then soak it in warm water, soak it for about ten minutes, if it is only an external blockage, the easiest way is to scrub the drainage hole and cover with a brush, but if the pipe is already blocked inside, then you may wish to use dredging detergent to assist, this type of cleaning products for grease, hair, vegetable residue or toilet paper dredging, will have a good effect.

Start by pouring baking soda over the drain holes. Pour in the white vinegar and wait 10 minutes. Rinse with hot water after 10 minutes.

Sometimes I don't live at home and don't use water for a long time to create too much sediment and there is a blockage, I will move the air compressor I used for work, first close the water valve and open the faucet to drain the water, and use the air compressor to pump air into the water pipe from one faucet, blow out all the moss and dirt, and repeat this operation several times to basically clean the water pipe.

Personal simple dredging: disassemble a faucet filter and gush out of this faucet with all the water pressure, bringing out some precipitated impurities. After cleaning the strainer, reinstall the nozzle and repeat the next faucet.

The home is whether it is the running water of the building or the water of the rural bungalow, or the well, when the home is decorated. Be sure to install a Y-shaped filter on the main water pipe at home. In this way, you can regularly clean up the impurities in the water such as mud and fine sand on the filter cartridge inside, and you are not afraid of spending money and trouble.

Turn on the faucet farthest from the main valve and select the Drain Pulse function to dispense citric acid. After emptying, put the pumping pipe into the clean water bucket, first open the faucet closest to the pulse pipe inlet, select the pumping pulse function, after the discharged water is clear and transparent, open the next faucet, the water pipe is an important facility in the family, because the water pipes are embedded in the wall, and the pipeline is complex, the usual water pipe cleaning method can not effectively clean the inner wall of the pipeline, and the safety of drinking water is more important.

You can use a tool, and then go down the drain to poke or fish out some of the things inside.

You can use a stick to get it, and you can increase the horsepower of the water so that you can get the water pipes open under strong pressure.

with pipe dredging agent. Because when the water pipes in my house are blocked, I use pipe unclogging agent to dredge them, and the effect is very good.

Method 1: Put caustic soda into the drain mouth and pour in a pot of boiling water.

Method 2: Waterway dredging agent is an excellent product on the market, this product can effectively dredge the blockage caused by hair, oil, paper, etc., and is widely used in restaurants, hotels, families and other vegetable washing pools, wash basins and other bathtubs, dredging floor drains and toilets. How to use:

Remove stagnant water from washbasins or sanitary ware and pour 50-100g of this product down the drain. If there is no water in the drain, **half a cup of water. At this point, the pipes are boiling.

After about 20 minutes, rinse with plenty of water.

Method 3: Go to the market to buy a 2m long spring wire pipe dredging tool, bend it 10-20 degrees above its head at 10-20cm, dredge it back and forth at the sewer inlet and outlet, and rinse it with water.

Method 4: If an iron branch has been used and the worker is required to pass through, but it is not launched later, it is not suitable to use the iron branch again, so as not to corrode the pipe and be penetrated, you can use thick rattan instead. The rattan head can be nailed with ten eight inch-long iron nails, stretched in on one side, rotated and stirred on the other side to loosen the debris, and then poured in with a concentrated alkali solution, and then pushed out the rattan.

If it continues many times, it will be effective.

Method 5: Pour 1 cup of laundry detergent into the clogged drain and pour 3 cups of hot water. If this does not clear the drain, pour another glass of vinegar into it.

Method 6: If the sewer is made of new PVC material, you can use a vacuum pump to absorb the water, and then fill it with concentrated vinegar or caustic soda, industrial vinegar and industrial alkali, but do not mix, if you don't know or are not sure, use a or must be an old-fashioned iron pipe, only try with weak acid at the level of edible vinegar. After filling these things, never use the above method, it will be effective in about 3 hours.

If there is no response, you can only find a professional dredging team to carry out forced dredging.

Method 7: Go to the mall and buy professional pipe cleaning powder, such as Swallow King, etc.

We often encounter all kinds of problems in life, so these problems are not only the problems of firewood, rice, oil, salt, sauce, vinegar and tea. At the same time, there are also some decoration of household appliances and the sewing of some clothes, because these are what ordinary people need to do in life. Then I believe that everyone will encounter the same problem in life, that is, the sewer pipe is not working, which will bring great trouble to people.

And bring a lot of trouble to their neighbors, so today we want to say that the sewer pipe is not open, how do you need to dredge it?

First of all, if the sewer pipe is not clear, you can use the method of water pressure dredging, then next to the pipe dredging, take a plastic pipe with a diameter of 15 mm and a length of 10 meters. Then wrap one end of the faucet tightly, and then wrap the other end of the cotton around a rubber tube, and then you can stuff this into the drain of the sewer. And turn on the faucet and screw the faucet switch to the maximum, then the pressure of the tap water will flow quickly

And flush all these blockages away so that the sewer pipes can be unblocked.

The second is that you can also take some chemical dredging, then chemical dredging means that the pipe is blocked by some oil or some hair. In this case, you can use some chemicals to dredge some of the grease hair inside. Then for the dredging agent of the pipeline, there are mainly some hydroxides, as well as some foaming agents and some sodium carbonate.

Chemicals like these can dissolve these hairs and residues to unclog sewer pipes.

So we all know that there are actually many ways to dredge sewer pipes, and there are not only the two methods just mentioned. We need to continue to explore and search in our lives, so that we can find a more convenient and effective way to dredge this sewer pipe. Therefore, if you encounter such a problem in life, I hope you will not be too nervous, nor too anxious, but only need to be patient and find some ways to solve it well.

At this time, you can seek the help of professional workers, use professional instruments to dredge, and then you can also pour some baking soda or white vinegar into the sewer.

Remove the garbage from the drain first, then pour baking soda and rinse it with caustic soda.

1. How to dredge the blockage of water pipes?

1. If there is a pump at home, plug the hose of the pump into the drain pipe, so that we can seal the drain. Then we put enough clean water in the boiling water of the faucet, and quickly pump air to the waterway, and put pressure on the sewer pipe, which will help to unclog the pipe.

2. If there is baking soda at home, we pour an appropriate amount of baking soda at the drain of the water pipe, then take a bottle of high-concentration vinegar, pour some into it, let it soak in the water pipe for a period of time, and then go to observe whether the problem of the sewer pipe blockage has been solved.

3. We will wash the dishes and dishes in the kitchen. A lot of oil will be created on the plates, which can lead to clogged water pipes over time. Prepare a basin of boiling water, then add the appropriate vinegar to it, before pouring them into the drain mouth.

In this method, we use vinegar to remove contamination, and when boiling water, the oil melts, and the combination of the two can solve the blockage problem caused by too much oil in the water pipe.

2. How to prevent clogged water pipes?

1. After we finish eating every Li Mu and washing the dishes and plates, we must clean up the remaining leftovers and leftovers in time. Or regularly pour laundry detergent and boiling water into the sink, laundry detergent can melt the oil.

2. If there are girls in the family, a lot of hair will fall out in the bathtub, and we must also take paper to clean it out in time, and remember not to let it enter the sewer. Otherwise, they will act like fishing nets, blocking other impurities and causing clogging. Resistant draft.

3. We must check whether the leaky cover is covered in time, and we cannot let some hard objects, plastic bags, cotton balls, cotton swabs, etc. fall in.

3. What are the tips for unclogging the sewer?

1. Pipeline dredging agentThe pipeline dredging agent is mainly for oil pollution, and the effect is particularly good, and the saponification reaction occurs with oil pollution. Plastic pipes and aluminum pipes have a certain corrosive effect, so this type of sewer cannot be a pipe unclogging agent. Pour an appropriate amount of pipeline dredging agent, add too much pipeline dredging agent, the pipeline dredging agent can not completely undergo a chemical reaction, and the remaining pipeline dredging agent will solidify in the sewer, which will aggravate the sewer blockage.

2. The main ingredient of hot water and laundry detergent is sodium dodecylbenzene sulfonate, which has a very good detergent effect on protein dirt and oily dirt. Use a basin of hot water, mix it with laundry detergent and stir it evenly, pour it into the sewer, soak it for dozens of years, and then dredge the sewer.

3. The scientific name of hot water and caustic soda caustic soda is sodium hydroxide, which is a strong alkali with certain corrosiveness, and most of the washing products in daily life contain caustic soda. When caustic soda is dissolved in water, it also generates a large amount of heat, which is used to dissolve sewer blockages. Caustic soda is a very good way to unclog sewers, but like pipe unclogging agents, it is not suitable for plastic and aluminum pipes.