Sucked with a plastic cup and then the mouth was printed with a circle of red fine marks how to get

Updated on healthy 2024-06-20
23 answers
  1. Anonymous users2024-02-12

    Hello, you are obviously blood congestion (congestion) in that can only wait or exercise to speed up blood flow maybe you can use a method to speed up blood flow maybe.

  2. Anonymous users2024-02-11

    Turning purple is blood stasis. You can use a simple method such as boiling an egg and peeling it and gently rubbing the affected area, or massaging it with a hot towel. If it does not work for a long time, you can use a clean fine needle to gently prick the affected area and gently massage it to squeeze out some of the blood stasis.

  3. Anonymous users2024-02-10

    Don't worry, it won't be there in ten minutes. Because the blood in this circle is not smooth when you suck it.

  4. Anonymous users2024-02-09

    This is caused by poor blood flow, generally speaking, it will be good by itself, but if it doesn't work, you can rub it on the imprint yourself to help blood circulation.

  5. Anonymous users2024-02-08

    It'll be fine in one night, I've had it before, but it's usually fine after a while, maybe you're more serious, but I think you should just get some sleep!

  6. Anonymous users2024-02-07

    It's been half an hour, and it's slightly purple! This may be a bit serious, the landlord sleeps, and if he is not well tomorrow, he will go to the hospital immediately. I used to sleep by myself, but I didn't pay attention to whether it became purple. May the landlord be fine tomorrow. Hope.

  7. Anonymous users2024-02-06

    That's just the blood stuck in that area, just use hot water to compress it!

  8. Anonymous users2024-02-05

    This is bruising, which is bleeding from the subcutaneous capillaries, and it could be that you are pushing too hard. If you don't mess with him, you can retreat after a while.

  9. Anonymous users2024-02-04

    Generally, the allergy caused by the plastic cup material will be fine after a few days, and the human body has its own detoxification function

  10. Anonymous users2024-02-03

    No, when you suck it, there's a vacuum in it, and the pressure is all around your mouth, and it's fine in two or three days

  11. Anonymous users2024-02-02

    The chewing gum traces are treated as follows:

    1. Spread the clothes flat on the table, and use a toothbrush dipped in egg whites to apply to the chewing gum on the clothes.

    2. Wait for one minute after applying to allow the egg whites to penetrate into the garment thoroughly. After a minute, the gum is peeled off the garment, and although most of it is peeled, a small amount of gum remains on the garment.

    3. Use a toothbrush dipped in egg whites and brush the gum remaining on the clothes with a little force.

    4. Wash with water, after washing the eggs, there is no trace of chewing gum on the clothes, and it is very clean.

  12. Anonymous users2024-02-01

    Have egg whites and a small toothbrush ready.

    In the first step, spread the garment flat on the table and use a toothbrush dipped in egg whites to apply to the area where the gum sticks to the garment.

    Step 2: Wait one minute for the egg whites to penetrate the garment. After a minute, peel the gum off the garment.

    In the third step, use a toothbrush dipped in egg white and brush the gum left on the garment with a little force.

    Finally, after washing the eggs with water, there is no trace of chewing gum on the clothes, and it is very clean.

  13. Anonymous users2024-01-31

    Don't take it with your hands, take off your clothes, freeze them in the refrigerator for a while, and you can remove them.

  14. Anonymous users2024-01-30

    Chewing gum sticks to clothes and won't wash off? Just use a plastic bag, and you won't leave a trace.

  15. Anonymous users2024-01-29

    Organic compounds can be easily diluted or extracted in organic solvents, you can try solutions such as alcohol and kerosene. In addition, you don't have to use wind oil essence to remove the label on the plastic cup, you can float the labeled part of the cup in warm water, and then slowly tear it off after a while.

  16. Anonymous users2024-01-28

    Wind oil essence is very effective! I tried an eraser, alcohol, and wind oil, the first two were useless, and finally I used the wind oily essence to drip all over the viscose, and after a few minutes, I wiped it with a non-woven fabric (other cloths should work) and there was nothing, and the viscose was completely dissolved.

  17. Anonymous users2024-01-27

    Wind oil essence mainly contains fat-soluble volatile oil components, and the polarity is small.

    Solvents such as ethanol may be added to dilute and dissolve plastics, both of which are fat-soluble substances.

    According to the principle of similar dissolution, fat-soluble substances can be dissolved in a solution with small polarity, so according to the chemical properties of plastic oil absorption, the chemicals in wind oil essence are mostly alcohols, ketones, and alkenes, and most of them contain unsaturated double bonds.

    The plastic is easily reactive between the polymers of styrene and other substances, and the unsaturated double bonds, so the plastic bottle can be regarded as corroded.

    Therefore, the offset printing on the plastic should not be removed with fat-soluble ones such as wind oil essence, and it is best to use a hair dryer.

  18. Anonymous users2024-01-26

    It's easy to get rid of with nail polish remover, I've tried it, and it's very good.

  19. Anonymous users2024-01-25

    Continue to rub you can go to the paint store to buy thinner very effective.

  20. Anonymous users2024-01-24

    I didn't hear of this miraculous effect, so try it yourself.

  21. Anonymous users2024-01-23

    Caution! Wind oil essence to remove label glue: never use it on plastic products, such as plastic cups.

    Just "successfully" removed the label glue stuck to the plastic cup with wind oil essence, but the plastic cup was corroded everywhere the wind oil essence went, white, and the plastic surface was rough, and the taste of wind oil essence could be drunk after pouring water into it

    Apparently the cup has been corroded (personally I don't think it can be used anymore!! The cup of Lock pp7 cost me 102 oceans in the New World Mall, and it was going to go into the trash in just 2 hours. . .

    So here is the final struggle to ask if this cup is still safe to use? Is there anyone else who can tell you how to save this "new" cup?

    Finally, to those of you who like to put labels on your products, do you know how many people waste so much effort and how much water they waste to get rid of that damn glue? I even accidentally ruined the cup like I did... Many goods have hanging tags, and I bought this one too, so please stick it on the tag next time, thank you very much

  22. Anonymous users2024-01-22

    Put it in boiling water and boil it, and you can remove the marks of wind oil essence.

  23. Anonymous users2024-01-21

    You can try using toothpaste to get adopted.

Related questions
5 answers2024-06-20

1. Use waste tea leaves to remove taste. If there is a fishy smell in the cup, scrub it with waste tea leaves first, and then rinse it with clean water to remove the fishy smell. >>>More

9 answers2024-06-20

1. Salt water deodorization method.

Wash the inside of the cup with detergent first, then pour the diluted salt water into the cup, shake it evenly, let it stand for two hours, and finally clean the inside of the cup. >>>More

36 answers2024-06-20

When I was cleaning the public restroom, I saw a plastic cup, if it was placed on the windowsill, I think you could just put it there, or move it to another place, maybe someone else forgot about it, and then come back to get it later.

6 answers2024-06-20

Plastic is unhygienic and contains toxins that are not suitable for the body.

4 answers2024-06-20

As long as you don't pour too hot water, you'll be fine