After changing the router, some computers can access the Internet, and some cannot

To manually set up their computer's IP and DNS, refer to:

192 168 1 10 (or , no more than 254 is sufficient) DNS is.

There is also to turn off your computer first, and replace the IP with the IP of your computer.

If that doesn't work, check with your landlord to see if you have MAC address filtering or other restrictions.

You enter the route to see if the landlord has banned it for you, and the general routing IP is.

You can set the IP address of your computer to "automatically acquire".

What you said above is very specific, the IP points on the network, fixed IPs and automatically obtained IPs. Personally, I think it's the landlord who has set up the router, so you'd better go to the landlord and ask for clarification. Ask the landlord to bind the MAC address to the IP address, and after the binding, you write down the IP address, command:

ipconfig all, remember your own IP. If you don't modify it, it's no problem, the so-called problem should be found in the right place, and the landlord is equivalent to the network management here.

If it doesn't work, you go for antivirus and see if there is a virus. Or go install a new system.

Best and good luck.

It depends on your computer, it may be that the function of the wireless network card is not turned on, it may be the installed anti-virus software, the firewall is set up, try it first.

After reading your speech, I found that you didn't say whether you could successfully enter the router from your Shushu's computer! That's the key!

Check if the route has an IP range.

Summary. 1. The new router needs to be reset Some users think that they only need to connect the new router to the network to use it normally, so they do not make any settings for the new router, resulting in the inability to access the Internet through the new router.

Why can't I use the Internet when I change my computer router?

1. The new router needs to be reset Some users think that they only need to connect the new router to the network to use it normally, so they do not make any settings for the new router, resulting in the inability to access the Internet through the new router.

Can you add, I don't quite understand it.

1. The new router needs to be reset Some users think that they only need to connect the new router to the network to use it normally, so they do not make any settings for the new router, resulting in the inability to access the Internet through the new router.