Computer router problems, problems with computers accessing the Internet through routes

To use the router to automatically dial in the browser type, the password (usually admin) enters the setup wizard, and follows the prompts step by step.

Router? Or is it a switch? Be sure!!

The router is connected like this:

**Line - connected to the telecom cat - out of the broadband line - connected to the router - and then split out 2 broadband lines - you can pick one by one!

Router mediation! Set it on any computer! Turn on IE!

Type enter! Then enter the username: admin; Password:

admin！Once inside, select the Setup Wizard or Network Parameter WAN Settings! Choose PPPoE!

Enter the dial-up account number and password of the Telecom Cat! Are you sure! Just restart your router!

In this case, the router and the cat will be left on all the time!

Use the router to turn off his computer without shutting down with you without a rack.

As long as the router doesn't lose power.

Maybe your neighbor is not a monthly subscription, only if he turns on the computer, you can access the Internet, if it is a monthly subscription, as long as the router is set up, even if his computer is turned off, as long as the router is on, you can also access the Internet, and there is no host distinction, you let him find out the manual of the router, or go to the Internet to check the IP login address and username and password of your neighbor's router, and enter the username and password used when surfing the Internet in the login interface after logging in. Select automatic login to save the settings, so that you can go online in the future, if you still have any questions, you can directly find me, because our downstairs neighbor also uses my online network, I also use the router,

Use routing to automatically dial up the Internet, and then set both phones to automatically obtain the IP.

Preparation: cats, switches, network cables.

Connect the cat to the router, and then connect the router to the two computers respectively (the route needs more than 3 ports), turn on the power, and then open the web page, enter this in the address bar, there are also differences, see the manual), enter the login account, password (generally admin).

1: Find the manual network connection option, click manual configuration, there is a my connection, select pppoe, and then enter the Internet, password, save the settings OK, everything else is default.

2: Click Configuration Wizard, Network Connection Wizard, Next, Next (set a new, password depends on your choice), select the time zone, select the option of Username Password Connection (PPPoE), enter the Internet access, password, Next, Next, OK

Open the properties of the wireless network --

Double-click IPv4 again

Subnet Mask: Default Gateway: (It must be the same as the one set in the route, and some of the defaults are in this case, the IP should be changed.)

DNS can be written as much as it sees locally.

Fill in the back dot OK!! Try it!!

DNS View Method:

or"Start key (win key) + r pops up the command prompt window and type ipconfig all enter.

The DNS server is your local DNS!!