Reversing into the garage to correct the direction of the car, if the rear of the car deviates to th

The principle of correcting the direction: take the rear of the car as the standard, the rear of the car wants to lean to the right, and hit the steering wheel to the right; The rear of the car is to the left, to the left, and then to the opposite direction.

Here's how:

1. The car is formed, indicating that the rear of the car is tilted to the right, and the direction is to the left, and when the body is positive, it will return to the positive direction.

2. When the car is formed, it means that the car is inclined to the left, and it will hit the direction to the right, and when the body is positive, return to the positive direction.

3. The car is completedshape, but the left side is wide, the right side is narrow, to the left direction, adjust to the rear track line, the ideal range, and then to the left direction, back to the positive direction.

Correct the direction when reversing, and grasp the principle of vehicle driving: "where to hit the direction and where to swing the rear of the vehicle". First determine which side the body is offset, then think about which side the rear of the car should be taken towards, and finally turn in the corresponding direction, and the body is about to return to the right direction and move on to the next operation.

Reversing into storage. When you get on the seat, adjust the mirror well, and try to slow down the speed as much as possible.

The tire was killed on the right out of the garage, and the car line was parallel to the right.

The mirror line coincides with the right and kills, and one-third turns around.

Thirty centimeters is the most critical, and it makes sense to hit far and near.

Tall, short, fat and thin are not the same, depending on the situation.

Look at the position and get ready, and the leather strip stops on two fingers.

Side parking. The parking position should be accurate, and the direction and timing should be steady.

Prepare to reverse and look at the right mirror, and the direction should be fast and quiet.

At the time of pressing the line, you should hit the left, and hit the left a few times and return a few times.

Hand hanging a gear to lift the clutch, the speed is neither fast nor slow.

Make a left turn before you start, and the time limit is just 90 seconds.

Small mistakes and small differences are in a hurry, and it is perfect to return to the right easily.

1. When the body is biased to the right, the position relationship of "left wide and right narrow" is presented in the rearview mirror, and the steering wheel is 1 4 turns to the left, and the body can return to the right direction.

2. When the body is on the left, the rearview mirror presents the position relationship of "right wide and left narrow", at this time, the steering wheel hits 1 4 times to the right, and the body can return to the right direction.

3. The body is parallel to the garage, but the car as a whole is on the left, if not adjusted, it is easy to press to the left front corner of the garage when the left is out of the garage, so you can first hit the right 1 4 circles of the direction, observe the front wheel do not easily press the line, when the distance on the right side is about the same, and then play 1 4 circles to the left, the body is parallel to the garage again, back to the right direction.

Take the rear of the car as the standard, the rear of the car wants to lean to the right and hit the steering wheel to the right; The rear of the car is to the left, to the left, and then to the opposite direction.

When the body is parallel to the sidelines on both sides of the road or the garage line, and from the rearview mirror, it can be observed that the body on both sides is "far narrow and near wide" relationship, at this time the body is already positive, so there is no need to correct the direction.

However, once it is found from the rearview mirror that the relationship between the body and the edge line of the library is not as shown in the figure above, it means that in the process of continuing to reverse, the wheel will have the risk of crimping, and it will be corrected at this time.

Hello! If the rear wheel deviates to the right, your steering wheel will be hit to the left! When reversing, the direction is in the opposite direction! I hope mine can help you and I wish you a great life