How to maintain the floor tiles during decoration?

Tile side shop and joint, on the newly laid tile, pile up sundries on the floor, just paved tile on the walking and trampling, ground tile, floor is not covered with finished protective film, etc., these will affect the paving effect of the tile, resulting in the construction quality of the tile. Suggestions: 1. Wall and floor tiles, in the case of paving is not dry, do not rush to hook the joints, so as not to artificially cause the tiles to loosen, uneven, and affect the construction effect.

2. Before the ground tiles are dry, do not walk around and pile up sundries on them, so as not to cause the tiles to be loose and uneven. 3. After the ground tile is paved, the finished protective adhesive is used to cover the brick surface, which can not only prevent the sand from grinding the ground during decoration, but also effectively prevent the colored liquid such as paint and coating from dripping off the brick surface and causing ground pollution.

When decorating, it is necessary to lay a protective film on the floor tiles to protect the ground, and it can prevent dust and water, and it will not scratch the ground, and heavy objects falling to the ground can also play a certain protective role. During the process of carrying items during decoration, friction and bumps can also be avoided when entering the door. For daily management, take reasonable arrangements, such as the ladder can be tied with a cloth so that it will not scratch the ground, and the movement should not be pulled, but gently lifted.

If you don't want to buy a special protective film, try to cover the tiles with packing paper or cloth or even a mat to protect them.

1. Spread with carpet, glue the joints with adhesive tape, 2. Workers should pay attention to handling gently during construction to keep the site clean and tidy, 3. Ladders, high stools and other construction tools, wrap the legs with cloth, 4. Paste bricks after the top construction procedures are completed to reduce the possibility of injury.

After the decoration is completed, do a thorough cleaning in time, and the ordinary dust on the surface of the tiles can be cleaned with dish soap, soap, laundry detergent, etc. The wax layer of polished bricks at the factory can be removed with the decontamination king. Contaminants such as paints and coatings are dissolved and removed using chemical solvents, and also to make paint strippers available.

The fine pores on the surface of the polished tile are exposed, and it is easy to absorb dirt after a long time, making the polished tile difficult to clean, tarnishing and becoming old, and it should be waxed regularly.

First of all, you should choose a dish soap that does not harm the floor tiles, and secondly, you should wax regularly, and at the same time, the dirt in the cracks of the floor tiles should be removed in time, so that you can maintain it well.

Be sure to wax once every three months, and mop the floor at night, you can use dish soap to mop the floor, and when there are tea, coffee, ice cream, grease, and other objects on the ground, you must wipe them in time, if there is ink on the ground, we can dilute it with hydrochloric acid, and if there is paint, you must use a special detergent to clean, do not use a blade to scrape the floor.

Usually when cleaning the floor tiles, you should use a small amount of water to clean, and wipe with a wet rag, and you can not use a strong acidic detergent to clean the floor tiles, and add a small amount of cleaning agent when cleaning the floor tiles, so as to play a role in the maintenance and maintenance of the floor tiles.

Introduction: Floor tiles are an important part of home decoration, and the labor cost of floor tile decoration is relatively high, and the material cost is also high, so it is a pity if it is not well maintained after decoration, so how should floor tiles be maintained and maintained when home decoration?

Floor tiles are an important step in home renovation, so you should plan before you decorate. And after the floor tiles are pasted, the cement inside it has not driedIf you walk around it at will, the position of the floor tiles will be shifted。In particular, if the marble tiles are put with heavy objects, they will crumble, so after the tiles are pasted, you can wait a few days for the cotton work to be done again, so that they are completely fixed, and then let the decoration team enter the home to renovate other parts.

In fact, there is now a new type of protective film, which can protect the floor tiles, and the floor tile protective film will generally be combined with PVC protective film and needle cotton. Needle cotton is a kind of material, this material can absorb the cushioning force, so it can be laid on the ground to improve the cushioning, reduce people's damage to the floor tiles, and PVC protective film, will prevent the impact of scratches and other effects on the floor tiles in the home during the decoration process. The cost of this protective film is relatively low, and the use time is quite long, so it does not cost much money, and it can be quickly covered after it is laid.

In fact, after the floor tiles are laid, they must be sprinkled and cured, so that the floor tiles will not crack later. And if the stains in the floor tiles are special stains, they should be washed off with corresponding cleaning supplies, if there are scratches, they can be smeared with toothpaste, and then wiped repeatedly with a dry rag, and then wait for the tiles to dry and apply some floor wax, so that the floor tiles will be as bright as new. If there are serious cracks, you can ask the decorator to repair it again, or pry the floor tile off and replace it with a new one.

Don't move around at will at the beginning to prevent unevenness, you can also put some protective film, you can wipe it with a rag regularly, and you can also wax the floor.

After we have laid the floor tiles, we must clean the cement in the gaps, and then we can do beautiful seams, and after making perfect joints, we must lay a layer of gypsum board, so that we can avoid friction and scratch the floor tiles.

When we decorate, we must sew the ground after it is finished, and then wipe the ground and lay gypsum board on it, so that it can play a good protective role.

1. If the floor tiles are dirty, then you can use detergent, disinfectant or special electric cleaner to clean the tiles. If the floor is polished tile, then in order to prevent slipping, you can wipe the floor clean with a dry cloth after mopping.

2. In life, if there are stains on the tiles, then they need to be cleaned in time. Otherwise, tea dirt and other things are easy to penetrate into the tiles. Stubborn stains can be cleaned with appropriate cleaning products when necessary.

3. If your floor tiles are polished tiles, then you should need to wax regularly, preferably once every three months or half a year. If you find that the floor tiles in your home are scratched. Then you can use toothpaste to apply the scratches.

4. If there is a lot of dirt in the cracks of your tiles, and it is very stubborn. That let Huai Mo earlier split friends with decontamination cream, and then scrub it with a dry cloth. It's a good idea to apply a layer of water repellent to prevent mold growth.

5. It is necessary to do a good job of basic cleaning on a regular basis, and you can use wet wipes or rags for daily cleaning.

After a long period of use, the floor tiles at home will appear oil stains, and there may be rust. It is necessary to carry out daily maintenance of the floor tiles, so as to increase the life of the floor tiles. After a long time, the tiles near the perimeter of the faucet will appear rust and scale, which is particularly inconvenient to care for and difficult to remove, so you can use vitamin C to scrub them.

Tiles behind the water pipes can be removed with a special rust remover. <>

Ceramic tiles are very common The tiles in the kitchen are the most difficult to clean, because the kitchen often cooks, there is a lot of oil smoke, and there will be a lot of stains. Water and oil are incompatible, and it is difficult to remove stains with water alone. Many people use dishwashing detergent to wipe down kitchen tiles when cleaning them.

But I found that the effect of the dishwashing agent was not very obvious, and I was tired and sweaty, and the hygiene was still not cleaned. If the oil stain on the kitchen tile is very thick, you can use a shovel to shovel it first, and then sprinkle it with caustic soda to remove the oil stain. <>

How to maintain floor tiles on a daily basis? When removing oil stains from floor tiles, never wipe them with wire balls, as this may scratch the glaze. After scratching the glazed surface of the tile, it will not only affect the appearance, but also be particularly troublesome when doing hygiene in the future.

Sprinkle a little more water on the top of the tiles when cleaning and soak the tiles thoroughly. Then use a rag to wipe off the water, so that the tiles can be wiped clean quickly, and it is also more time-saving and labor-saving. If you buy more expensive tiles, you can polish the tiles and wax them regularly in two to three months.

Pay attention to maintenanceIn daily life, you should also pay attention to the maintenance of tiles, do not use sharp objects or hard objects to smash the tiles. Dirty oil has appeared on the tiles, and you can find a way to remove it. If the tile is damaged and scratched, then it is difficult to deal with it, so you should pay special attention when using it.

After cleaning the tiles, wipe the moisture on the ground with a dry rag in time, and do not leave water stains on the ground, which will affect the appearance.

1. The gap between the tiles and the tiles should be cleaned with detergent from time to time, and then a layer of waterproof agent should be brushed on the gap with a brush to prevent the growth of mold. 2. For daily cleaning of ceramic tiles, you can choose to clean the tiles with detergent, soap, and a little ammonia and turpentine, which can make the tiles cleaner and brighter. 3. If there is tea, coffee, beer, ice cream, grease, etc., sodium hydroxide or potassium bicarbonate solution can be scrubbed in time 4. If there are ink, cement and other pollutants, hydrochloric acid, nitric acid dilution solution can be used.

5. If there are contaminants such as paints and coatings, it is best to use special cleaners. 6. If there are slight scratches on the surface of the tile, you can apply toothpaste to the scratches and wipe them with a soft dry cloth to repair them.

In daily life, we must wear slippers to walk on the floor tiles, and then we can't use hard objects to rub the floor tiles, and when placing the table, we must be lifted by two people, not one person deadlifting, it will wear the floor, the most important thing is that the floor tiles should be cleaned every day to ensure that it is clean and hygienic, and can be cleaned with laundry detergent regularly.

If you like this kind of floor tile, you should usually soak it in less water, that is, don't get it too wet, otherwise, it will be easy to warp up after a long time, and it will be difficult to repair it when the time comes, try not to use a blunt object to smash it on the ground, otherwise it will be destroyed, it will be ugly, and it is not easy to get good.

It is necessary to reduce the impact of gravity as much as possible in normal times, and also to regularly polish, wax, and scrub the things that are used in the process of scrubbing, which can be maintained.

Be sure to pay attention to the cleaning work, and the crevices in the ground must be treated to avoid dirt and dirt. In the face of wear and tear of floor tiles, it is necessary to carry out maintenance in time.

When using floor tiles at home, you need to pay attention to empty slag maintenance to avoid scratches. How to maintain the tiles? PChouse will take you to find out.

1. Paste the corner of the tile with a corner protector.

In order to avoid potential safety hazards in the home caused by tile corners, it is recommended to protect the tile corners with corner protectors. The use of corner protectors not only protects the corners of the tiles, but also hides the defects of the tiles, so that the tiles have a better decorative effect. In order to prevent the deformation of the corner protector during construction, it is better to choose stainless steel corner protector than aluminum alloy corner protector.

2. Wax the tiles regularly.

The maintenance of stairs needs to be waxed regularly, and tiles need to be waxed regularly if they want to prolong their life. Waxing tiles can improve their water and stain resistance and make their surfaces more beautiful. Usually, waxing can be done every 2-3 months, that is, three or four times a year is fine.

3. Use tile caulk.

Between the gaps of the tiles, fill them with caulk to improve the stain resistance and mildew resistance of the tiles and reduce the water seepage rate.

4. Paste oil-proof stickers on the surface of the tile.

This maintenance skill is very important in kitchen tiles. As a heavy area of oil smoke, the tiles inside are not only easy to stain, but the stains are not easy to clean. Especially when the tile has been used for a long time, the tile will also fade and other phenomena.

1. The daily cleaning of floor tiles can be cleaned with water and soapy water, and the dust and dirt on the surface of the floor tiles should be cleaned in time.

2. The floor tile floor should be kept clean frequently, the dust and gravel should be removed in time to prevent abrasion on the brick surface, when there are slight scratches on the surface of the floor bricks, you can apply a little toothpaste on the scratches, wipe them repeatedly with a soft dry cloth, wipe off the scratches, and then apply floor wax, which can make the tiles as bright as new.

3. After the surface of the floor tile is polluted, it should be wiped with a soft cloth immediately and rinsed with water. Tea, coffee, beer, ice cream, grease and other pollutants attached to the surface of the tile should be scrubbed in time, if necessary, sodium hypochlorite dilution (bleach) should be used, soaked for 20-30 minutes and then wiped with a cloth. Some stains that have been infiltrating the brick for a long time can be soaked for several hours.

Ink, cement and other pollutants can use diluted solutions of hydrochloric acid and nitric acid, while paint, coatings and other pollutants are best to use special cleaners.

1. If the home is using a clear polished brick, then it must be waxed regularly, generally speaking, once every 3 months is the most suitable for the locust object. If it is a gap between the bricks, then you can clean it with a stain remover from time to time, and then brush a layer of waterproofing agent on the gap with a brush, which can prevent mold growth.

2. For daily cleaning of floor tiles, you can choose some dish soap, soap, or add a little ammonia and turpentine mixture to clean the floor tiles.