Will it be okay if the soot falls on the screen of the phone? 20

This kind of situation is taken into account:

1.The mobile phone screen is made of glass, and generally the soot falls on it, which will not cause damage to the mobile phone screen.

2.If the hydrogel film is pasted, it may cause damage to the film and need to replace the mobile phone film.

There may be something, it may be fine.

It's okay, and you also put a tempered film.

Open the slider and open the front cover from behind the top of the slider. Start from the gap above the sign, insert your nails into the gaps above (if you don't have long nails, wait for the nails to be longer and then dismantle it), and then pry along the gaps to both sides, the action should be slow, (it's okay to be fast, don't blame me if it's broken), this is the most critical process, it may be a little difficult, but how can you see a rainbow without experiencing wind and rain! Only by going through hardships can we become an opportunity within a machine!

After the front cover is removed, you can see our inner screen, remember to be extra cautious when wiping the screen, it is best to wipe it with the glasses cloth that wipes the glasses, and do not use paper supplies, because there are many burrs on the paper, which will wipe the screen.

The dust on the surface has been cleaned up, but what we want is to keep the screen completely away from dust, I believe you are here, you have seen that there is a sponge cushion inside the front shell, I believe this is used to prevent dust, but the effect is really not flattering. Let's perfect this feature for Arnold.

Tools: a roll of double-sided tape, a sharp knife (don't use a kitchen knife), a discarded CD, a ruler.

Tear a piece of double-sided tape and stick it to the disc, don't stick it too tightly, use a ruler and a knife to cut the double-sided tape into long strips with a width of 2mm, and then remove it from the disc, remember to remove the glue! (You may not be able to remove it), and then glue it around the sponge pad of the inner cover. You have to be very careful with this process, because if it sticks, it may stick to the mat and you will be hopeless (of course you can get a new one).

Each side of the surrounding should be glued, after actual testing, it is best to stick two layers of double-sided tape on each side, which will be tighter.

After the above process is done, it is relatively simple post-work, wipe the inner screen of the shell clean, and it's OK.

When installing the front cover, start from the bottom of the mobile phone, use the bottom of the front cover to jam the bottom of the slide cover, there are two small card slots under the shell, remember to see clearly, don't install it from above, install the bottom, press down the top of the shell, and you're done.

Go to the place of purchase, or the repair office and let it be organized. If it's a Nokia, you can disassemble it yourself.

Disassemble and clean up. It was left over when the phone was repaired.