How to remove the black marks on the tiles, the rag cannot be wiped off with water

Put some dish soap or some other detergent in the area of the black spot and scrub it with a handkerchief or brush.

That's it.

Ceramic tiles are commonly used to decontaminate the soil.

1. Daily cleaning of ceramic tiles can be cleaned with dish soap, soap, etc.

2. Use soap and a little ammonia and turpentine to clean the tiles to make the tiles more shiny.

3. The polished tile should be waxed regularly, and the time interval should be 2-3 months.

4. If there are scratches on the brick surface, you can apply toothpaste to the scratches, and wipe them with a dry cloth to repair them.

5. The gaps between bricks and bricks can be removed from time to time with detergent, and then a layer of waterproof agent can be brushed on the gaps to prevent the growth of mold.

6. Sodium hydroxide or potassium bicarbonate solution is used for pollutants such as tea, coffee, beer, ice cream, and oil.

7. Ink, cement and other pollutants use dilute solutions such as hydrochloric acid and nitric acid.

8. Use special cleaners for paints, coatings and other pollutants.

9. The marks left by the burning of match stems and paper can be dipped in a small amount of diluted oxalic acid solution with a waste toothbrush.

As an all-purpose cleaner.

There are a lot of stains that accumulate in the kitchen, such as grease stains on the walls, stains on the kitchen countertop, or dirty floors in the hall house, etc., is there one thing that can solve many of the hygiene problems imaginable? And cheaper?

Tools Raw materials.

Water, 500 ml water bottle, laundry detergent, vinegar, alcohol.

Method steps.

A water bottle of about 500 ml with three-quarters of the water.

Measure the cap of a water bottle and pour a cap of laundry detergent into the water.

Then measure two capfuls of food vinegar and pour it into the water.

Measure three more caps of alcohol into it.

Finally, shake well so that the all-purpose cleaner is ready.

Laundry detergent has a strong detergent ability and can clean most stains, while vinegar and alcohol are organic substances, which can easily clean oil stains according to the miscible characteristics of organic matter.

Keep homemade detergents out of reach of children to avoid ingestion.

If there are no production conditions, then use dish soap, soap, laundry detergent, vinegar, etc. + rags, and try it in turn.

The main components of rubber black marks are rubber, carbon black. Rubber marks are difficult to wipe off and can be removed by the following methods:

Soak in gasoline or diesel, wipe repeatedly (be safe), and then wash off the carbon black with detergent or dish soap.

You can use a higher concentration of alcohol to soak and wipe (pay attention to safety), and then wash off the carbon black with laundry detergent or dish soap.

If you don't have the above ingredients, you can roast them over fire and scrape them with a knife.

Drop some wind oil essence on the black mark, soak it for more than ten minutes, and then you can easily wipe it off with paper.

The black water-based pen print on the tile can be made with wind oil.

to easily remove it, the specific operation method is as follows:

1. First come to the tile that needs to remove the black water-based pen print, as shown in the figure below

2. Then prepare a clean glasses cloth, as shown in the figure below

3. Take out the prepared wind oil essence, as shown in the figure below

4. Then start to wipe with wind oil essence in the place where there was handwriting;

5. Finally, you can easily remove the black water-based pen mark with a clean paper towel.

1. If the black mark scratch is not particularly obvious, we can remove it with white vinegar. Wipe the surface clean first, and then spray white vinegar evenly. After it is dissolved, wipe it clean with a rag, because after soaking, it can effectively dissolve the stain, and then brush it with a toothbrush to remove it.

In addition, you can also dip some toothpaste into the brush to remove dirt and scratches.

2. If the area is relatively large, you can also use a special repair agent, which can repair scratches and stains. First, take some repair agent through a rag and trace the scratches. Repeat after half an hour, and repeat the same work after drying, until no scratches are visible.

Later, it can be sanded with transparent wax to fill in the scratches and remove the black stains.

Second, how to remedy the dimming of tiles.

1. The tiles on the ground have been trampled back and forth, and it is normal for the gloss to darken after a long time. We can restore its gloss and improve the overall aesthetics by repairing it.

2. Because of the usual friction on the floor for a long time, the nano protective molecules on the surface will be directly polished off, which will reduce the gloss. In this case, we can wax the floor every once in a while to improve its gloss with a polish.

3. In addition, you can also add conditioner to clean water when mopping the floor, mop the ground in the early stage, remove all the dirt, and then mop the floor by adding conditioner in the later stage, which can make the floor tile very bright, and can also prevent static electricity, avoid dust accumulation on the surface, prevent the surface from being too dirty, and also increase the gloss.

Tools: bucket, mop.

Auxiliary tools: salt, baking soda, dish soap, white vinegar, water operation method:

1. Now pour some salt into the bucket.

2. Pour a little more baking soda.

3. Pour some white vinegar again.

4. Add a little more dish soap.

5. Add half a basin of water.

6. Then put the mop in and soak for about 5 minutes.

7. Lift the mop up and shake off some water, and then start mopping the floor.

8. In the last step, look at the result, and the effect is obvious to see that the floor becomes clean and translucent.

To remove the watermark on the tile, you need to prepare the following items: a small bowl, water, a rag, white vinegar, and dish soap.

1. First of all, take out the prepared dish soap and a small bowl, and pour the dish soap into the small bowl. As shown in the figure below:

2. Then take out the prepared white vinegar and pour the white vinegar into the prepared small bowl. As shown in the figure below:

3. Next, you can pour the water into a small bowl, dilute and dissolve the white vinegar and dish soap inside. As shown in the figure below:

4. Use a rag to dip the cleaning agent prepared in a small bowl and wipe the watermark on the tile. As shown in the figure below: