Door casing wood is always susceptible to water absorption and mildew, and there is no reason for th

After a period of time, the knife holder should be cleaned, the position is small, the hand is not reachable, then you can use the cloth dipped in an appropriate amount of wine or vinegar, wrap the knife, reach into it and rub back and forth on the two large surfaces, cleaning method: use a toothbrush dipped in concentrated salt water, clean up the moldy parts, after the mildew is removed, use absorbent paper to absorb the water, and then place the knife holder in a ventilated and dry place to dry, and dry before use. Usually when you get home, you should also put it in a ventilated and dry place.

The best way to prevent this from happening is to dry and ventilate, don't put the knife holder in a damp corner, and choose a ventilated place that is conducive to air circulation. The main reason is that the used knives are not cleaned, and they are put into the knife holder with water droplets, and the wooden knife holder is extremely absorbent, which causes mildew on the inside of the wooden knife holder, and then dry it thoroughly with a rag before putting it into the knife holder; 2.Regularly expose the knife holder to strong light, pay attention to the gap of the knife holder facing the sun, and expose it to the sun for no less than 4 hours each time; Structure——Wooden knife holders are basically the sameFully enclosedSome may have chopstick baskets, but the bottom of the chopstick basket will also be closed, so it is possibleBacteria breed and accumulate dust

Therefore, knife holders, cutting boards, chopsticks and other tableware must be checked frequently for mold, and if possible, try not to use wooden tableware to be safer.

Just rub vigorously with a damp paper towel or towel. After removing the mold, dry the furniture with a hair dryer or move it out to bask in the sun. Then use petroleum jelly as protection and wipe with a clean cloth.

It is more tricky to deal with, generally use organic solvents (turpentine, xylene) to remove the resin first, and after the surface is dry, brush the shellac varnish 112 times in this part to block the resin road. Finally, it is leveled with lacquer in the original tone. First of all, if the humidity of the wood itself is high, it is easier to mold, and the structure of the wood is easy to absorb water, but it is difficult to drain the water after absorbing it, so the humidity of the wood itself is an important cause of mold.

Generally speaking, there are two reasons, one is improper storage environment, too much moisture in the air, and the other is that the wood is initially dried improperly, resulting in mold, deformation, and cracking.

It may be because the waterproofing of the wood is not in place. It is normal for wood to absorb water, but the wood that is to be made into a door sleeve will be waterproofed, and it is easy to absorb water and become moldy, probably because the waterproofing is not in place.

Wood is always easy to mold, the material inside the wood is always very easy to absorb water, and the water can't dry, so it will always be moldy, and the water will be moldy!Especially back to Nantian.

In a relatively humid environment, the wood structure is easy to absorb water, and it is difficult for water to come out of the wood, so the wood material is easy to mold.