What should I do if the fountain pen is always gambling, the fountain pen is always blocked, what sh

After using the blue one, it was not cleaned, and the black pen was not very smooth, what should I do? 》？I focused on the problem that the pen did not come out of the water. The ink is not good, and the pen is often blocked. Solution: Buy good ink.

Perhaps, if it is a big brand, you will mail it back to the manufacturer If you don't go into the water, it's not necessarily blocked, and there are many reasons why you don't go into the water Now the fountain pen manufacturers don't go into the water are free to repair The cheap ones are thrown away.

Try Hero's 202. There is also the need for normal use. Parking should not exceed 1 week.

It is easy to dry and plug in summer, usually there is ink deterioration caused by precipitation particle blockage, the use of different inks does not wash clean chemical reaction precipitation particle blockage, the tip of the water gap is too fine ink can not flow through or is not easy to flow through the blockage. Get the right medicine. 1.

Cap immediately after using a pen in summer; 2.Spoiled ink is only suitable for brushes, pens can not be used; 3.Before using different inks, the pen must be cleaned before the ink is filled; 4.

The nib slit can be inserted with a thin blade to cut out the blockage; 5.Wash and store the pen before not using it for a long time, and wash it before use;

There are two reasons why the fountain pen is blocked: one is the oxidation of the ink, and the other is that the pen is problematic (which is very unlikely).

Basically, the blockage of the pen is due to the ink carbon oxide condensation on the nib, causing the water to be poor.

I've had a lot of situations and wasted some pens, and it wasn't until recently that I bought a gold pen that I had to think about it. Check the Internet, popular explanation:

1. With carbon ink, it is easy to block.

2. I don't wash my pen often.

I strictly follow the above two rules, and I still don't go into the water sometimes. After thinking and experimenting. As follows:

First, rule out the following reasons:

1. Whether it is because it has not been used for a long time and has not been saved by washing the pen.

2. If you wash the pen clean, then use ordinary blue ink or blue-black ink, but the pen still sometimes does not go into the water.

But how can a brand-name pen with hundreds or even hundreds of dollars have quality problems? Quite simply, the internal quality of the fountain pen is good, and the ink is also smooth, the main reason is that the nib is easy to dry. But the reason why the nib is easy to dry is that the pen cap cannot be tightly covered, but not every pen has a 50% chance that the cap is not tightly covered.

It involves the sealing design of the fountain pen cap, as well as the quality of the production process.

Reason: The pen cap never closes, and even if it does, there is still a small amount of gap. As a result, the nib is easy to dry.

Solution: Put a lump of cotton (preferably a medical absorbent cotton) inside the cap, push it to the bottom, and then drip 1-2 drops of the same ink into the cap to moisturize the cotton. Insert the steel test so that the cotton just touches the nib. The next time you blot, remember to drop a drop of ink into the cap.

There was no more going into the water.

If it is a general fountain pen, you can disassemble and clean it yourself, and if the structure is complex, take it to the optical store and clean it with an ultrasonic cleaning machine.

The key is to change to a different ink later.

Any pure blue and blue-black ones won't clog the pen.

I cannot choose carbon for the black one. You can choose fuel-type ink, such as Dax does not block the pen, and really does not block the pen; Parker's ink is expensive, but it doesn't clog the pen and dries slowly. It is recommended to buy Parker blue and black, the color is very dark.

You can detach the nib of the pen and copy it into warm water

Do not boil water) soak du for half to an hour, and then wipe dry, after zhi is installed, it can generally be used normally. Generally, the water can be repeatedly absorbed and drained until the discharged water is clean, and it can be wiped dry. Because the pen is used for a long time, the components in the ink condense and block the ink guide groove of the fountain pen nib, so it will cause the water to flow smoothly.

1. Soak the pen head with warm water, and after the water cools down, the ink solidified in the pen head also melts away.

2. Wash with clean water first, then soak in water with laundry detergent and pump it back and forth, and then wash it with clean water, which will be very smooth.

3. If there is no physical damage to the pen nib, the dregs in the ink should block the tube, and it can be disassembled and rinsed.

4. Scratch the slit on the nib with a razor blade, and if you want to clean the nib thoroughly, you can use a nail clipper to gently grip the nib and pull it out – note: not every nib can be pulled out like this, but most of the ones I've tried can.

5. If you feel that the whole cleaning is very troublesome, you can only disassemble the first half of the pen, repeatedly absorb and release water, and then carefully see if there are any foreign objects on the front part, and then use an absorbent paper towel to absorb the water after washing, and then carefully wipe the groove part, and the tip of the pen must also be cleaned, wiped dry, and finally assembled and tightened.

I recommend two.

BAI method bar (

Du My good fountain pen has also been trapped by this question for a long time) dao, once tried inside.

I was taught a trick by others.

Pull out the hair, finger + index finger between the ends of the hair, so that the middle of the hair through the slit of the pen tip - this trick is used to save the emergency, in the long term it still can't work, because it can only clear the blockage of the pen head, and our pen is not only blocked in many cases.

I came up with a method this morning: drain the ink from the pen first, then inhale a small amount of vinegar, that is, edible vinegar, and fill the cap with vinegar, and finally insert the pen into the tip of the vinegar; Allow the pen to remain upright for a while.

It can be a morning or a day, but don't be too long!

Because I once accidentally dropped a sewing needle into the vinegar, I was too lazy to take it out, so I let it sink to the bottom of the bottle, more than half a month later, the bottle of vinegar actually began to turn yellow, I poured out the bottle of vinegar and wanted to take out the needle, and finally found that the needle was actually corroded to only a little rust!

Now you can see why I recommend using vinegar to unclog clogged pens - even the needles can corrode away, so what are the blockages in the pen?

That's because the ink solidifies after drying. It is necessary to pay attention to frequent washing, frequent calculation, and multi-use.

Then the nib seal should be good.

It is also possible that your ink is of poor quality, you can buy a better ink to try.

The ink solidifies after drying, and the ink quality is poor

Don't use carbon ink, there is granular glue in carbon ink, and it is very easy to block the pen when writing. You can use any kind of blue-black, pure blue or red ink to practice calligraphy, and you can use high-quality black ink such as Hero 9003 to write works. The choice of ink and paper will have different feel and effects on the use of the pen.

Generally, black ink will be viscous and easy to block the pen after a long time, so it is much better to add a little boiled water to the ink bottle. After the pen has been used for a long time, there will be residue in the gap between the ink supply of the pen tongue, soak the tip tongue part of the pen in warm water for half an hour and then squeeze out the ink sac a few more times! Clean the pen frequently and cover the cap in time after writing.

I can't write all the time, and I don't know why I've washed it with a blister, please help.

This one should be disassembled, the tip of the pen should be immersed in warm water, and after a few hours, it should be washed and dried several times before it can be used. If that doesn't work, you can extend the soaking time. If this is not possible, you need to remove the metal piece of the nib, and then use a small brush to clean the ink guide groove on the back of the tongue and the small seams on the plastic part of the nib.

1. Disassemble all the fountain pens, use running water, squeeze out all the sediment in the pen barrel while cleaning, until the squeezed out becomes clear water, and then shake off the water in the fountain pen, and re-pump the new fountain pen water to use.

Second, the pen has not been used for a long time, it is necessary to pour out the ink inside, wash it with water, and cover the pen cover for preservation when it is dry.

1.The pen is a commonly used writing instrument and was invented in the early 19th century. The nib is made of metal, which makes it sleek and elastic to write, and is quite smooth.

At the mouth of the pen sleeve or on the surface of the nib, there are obvious trademark grades and models. It is also divided into dipping fountain pens, tap fountain pens, and ink sac fountain pens.

2.Fountain pen is a pen writing instrument that mainly uses metal as the pen body, through the hollow barrel to contain ink (mostly black or blue), through gravity and capillary action, and then through the duckbill pen tip writing, writing light and heavy when writing, can be said to be a Western calligraphy writing instrument.

3.According to the usual writing habits, Westerners mostly use the M nib for fountain pens, and the B nib for signing. Due to the complicated strokes in Chinese writing, f or a thinner ef nib can generally be used.

Dear, the pen is inked, if you haven't used it for a long time, you must clean it, and the next time you use it, you can use the ink again, if you use it for a long time, there is ink, you don't use it, forget it, it will solidify, you can't write, you can't write.

Question: My fountain pen has been useless for more than a year, and there is no ink in the pen when I take it out to use. When I just used it, I was able to write with some ink, how to deal with this.

My fountain pen has been useless for more than a year, and there was no ink in the pen when I took it out to use. When I just used it, I was able to write with some ink, how to deal with this.

Answer pro, it is recommended to clean the pen with water several times, if you wash it thoroughly, if you put ink again, use it so well, the ink is temporary, and it is written, but if you continue to write, you can't write.

My fountain pen is generally useless for a long time, and I can't write, but I can write it with some ink, but I use water to change and wash him and then re-ink it, and it can be used normally.

Or you can remove all the pens, soak the removed parts of the pens in the water for a while, and use the running water to squeeze out all the sediment in the barrel until the water turns white.

Then use a small needle to pick out the blockage in the gap between the nibs, and then shake it, and you can write when you are full of ink.

Hello, because seeing that you did not rate my answer last time, I am very concerned about your experience. If you are satisfied with my service, I hope you can give a thumbs up! If you are not satisfied with my service, you can also click on my avatar and tell me in a private message, and I will definitely give you a satisfactory experience in the next service!

The upstairs method is a little violent. If the landlord's pen is celluloid or wood, soak it in vinegar.,I'll take it.。。 It's simple.

Soak it in warm water for a day is almost the same. If it's stubborn, gently dismantle the pen (entry-level fountain pens only.) Dragons and birds, please send them to the store).

And then the same way is good. When the pen runs out, if it is not used for a long time, it should be washed and put away. It's okay not to wash, don't use carbon ink.

That thing, you look black. It specializes in black pens. It's sauce purple.。。

Put it in boiling water, add vinegar, and soak for half a day.

1. Soaking in water for a day is the easiest way.

2. Find an ultrasonic cleaner, which is the one that washes glasses in the optical store.

3. From now on, there will be damage to the fountain pen, take the alcohol bubble, the solubility of alcohol to the ink is higher, but there will be potential damage to the skin.

4. Use a very fine blade or a hard piece of paper to open the gap of the pen tip, the gap is large, the water is natural and smooth, this operation is irreversible, and it will not come back if it is thick.

5. Disassemble and clean the capillary, that is, the parts inside the pen holding part, which is the core component of the pen, the high-grade pen is not easy to disassemble, the resistance pen is glued, and it will leak after dismantling and restoration.

The cause of this problem in fountain pens is the sediment in the pen water. If the pen is used for a long time, the sediment in the fountain pen water will block the channel of the ink, thus causing the problem of poor water flow of the fountain pen.

Generally speaking, the problem is more serious for pens that use carbon ink and red fountain pen water.

So, how to solve this problem, how to make our beloved pen write smoothly again.

The method is very simple, the main thing is to clean the ink channel.

When it comes to the cleaning of fountain pens, it is necessary to understand the structure of fountain pens first.

The general fountain pen is composed of four parts: the cap, the nib, the refill, and the barrel, and the barrel can be divided into two parts, which are connected by the screw mouth, and the suction pipe can be seen after the upper and lower parts of the barrel are separated. The lower part of the barrel (the part connected to the nib) inside is the refill of the fountain pen, and there are two kinds of fountain pen refills, one is the core of the small tip pen, which is screwed into the fountain pen barrel with a screw mouth, and the other is the large tip.

The refill of the fountain pen, which is inserted from the tip of the pen into the barrel.

After understanding the structure of the fountain pen, it is more convenient to wash the fountain pen. Cleaning of fountain pens.

It is generally carried out in three steps:

The first step is to soak the pen. Remove the cap and the upper part of the barrel, soak the remaining part in water, it is best to add some hot water when soaking, the soaking time should not be too short, it is best to soak for half a day to a day.

The second step is to clean the pen. Take the soaked fountain pen out of the water and dry it with a dry cloth.

After separating the nib, barrel and refill, it should be noted that when separating, it should be determined which type of structure of the pen is first, and separate it in different ways. After separating the fountain pen, clean the nib and refill with water and a cleaning solution made with detergent, and then use a small toothbrush to clean the ink channel of the refill. After cleaning, rinse the pen with running water, and be sure to rinse the detergent.

The third step is drying and installation. Place the cleaned pen parts in a dry place and allow them to dry naturally.

Once the parts are dry, reassemble them and the pen is cleaned.

The cleaned fountain pen can be used to absorb water, and then you will find that the phenomenon of poor water output of the fountain pen is gone, and your fountain pen is handy again!

During the use of the fountain pen, attention should also be paid to the maintenance of the fountain pen. For example, it is best not to mix the two types of fountain pen water, and if you want to change the fountain pen water, you should clean the fountain pen before changing the water, so that your beloved fountain pen can accompany you for a longer time and even become your lifelong partner.