-
As shown in Figure 1, the first distance of the front right side. The position of the crosshead headlights in the right front corner of the edge of the lowest barrier, if you move to the right front corner of the taxi, continue to turn the steering wheel, the steering wheel has **, and then do reverse.
2. Parking lot in front. There are no obstacles in your crosshair and the ground contact part is about 50 cm - 80 cm away from obstacles.
3. Reverse parking. When parking around other vehicles, the length of your vehicle, next to the front door handling about alignment is no problem, otherwise, refer to the more suitable parking space. There is no comparison with other vehicles, the first to use the interior mirror, the rearview mirror inside the trunk line than with the ground obstacles?
Contact the position of your car about 1 meter from the distance from the obstacle - meters. Then adjust the distance appropriately.
-
Normally, the outside of the door is almost the outer edge of the tire, and when the driver's left foot is in the normal position, the outside of the left foot is the inside of the left front wheel. As for judging the position of the right front wheel, it depends on experience, it is recommended that if you have the opportunity, run the trench in the repair shop (it is best to have someone to direct it for the first time), and run the trench a few more times to have a clearer sense of position.
As for the position of the front of the car, at the beginning, please find a vertical wall when the light is a little dim, turn on the headlights, and slowly move forward against the wall, when the reflection of the headlights is almost the brightest, it is the limit of progress, observe the distance of the wall in the car, remember him, and you will have a good idea of the position of the front of the car.
As for the position of the rear of the car, you need to look at the side mirrors to gradually gain experience, or simply install a radar.
In fact, it is easy to be damaged by the four corners of the car, especially the right front corner, which is mostly caused by scratching the right front corner when looking backwards when reversing.
When driving, stick to one principle, never go backwards if you can move forward. Because after all, there are no eyes in the back of the head.
-
Judging by the position in the middle of the front case cover. The middle position of the car to determine the position of the right tire.
1. You can see the right wiper node, and the place where the ground extends forward is the tire position.
2. Make a mark in the middle of the front chassis cover, so that you can also judge the position of the right tire of the car. It is good to determine the position of the vehicle on the right.
3. Adjust the rearview mirror on the right side to see the position of the door handle on the right side, and you can look at the door handle on the right side through the rearview mirror to determine the position of the right wheel. The doorknob on the right side is just pressed against the white marking, so don't open it to the right, it's just right.
-
How do you determine the position of the left and right wheels of a car? Old driver: After reading it, it will.
-
When the car is on a slope, the position of the right front wheel in the driver's line of sight will move closer to the driver's direction from the original position. The reason is that the driver's line of sight rises when going uphill, and the dotted line of vision becomes longer.
In case of uphill narrow road and turns, it is best to get out of the car and look at the position of the wheels before walking. That's how old drivers deal with it.
-
<> "We have all studied in driving school, and we know that reversing into the garage, side parking and the curve can not be pressed to the line, however, many people still can't grasp the position of the wheels when driving, and occasionally hesitate because of the spacing, and even scratching. That's a good situation just because of it, but if you hit someone because of it, it's very serious. So what's the best way to accurately determine the position of the left and right comma wheels?
Many car owners use the wiper nodes to see the wheel position. The coach also taught us this method, but it was not a particularly correct method. Because of the different seat heights, each person's height and body shape are also different, so what we see is also different.
First, let's look at the left front wheel. Since all vehicles in our country are left-hand drive, the left front wheel will be closer to the owner, so its judgment method will be different from the right front wheel. Here's how:
The owner sits in the driver's seat with his left arm on the far left side of the steering wheel, while the arm extends parallel to the direction of driving. After that, if you find that the arm coincides with the road markings on the road, it means that the left front wheel is in line and needs to be quickly adjusted to the right. Next, look at the right front wheel.
The method is basically the same, the owner's right arm is placed 15-20 cm away from the rightmost side of the steering wheel, and then it is the same as judging the left front wheel, if the owner finds that the right arm overlaps with the road markings, it means that the right wheel has been pressed and needs to immediately adjust the direction to the left.
So how do we tell where the right wheel is? At this point, we will look at the far right side of the steering wheel and then use our hands to draw a 10 cm length. At this point, we straighten our arms again to see if the extension line coincides with the ground mark, and if so, the line is pressed.
Summary: That is, if we want to make sure that the right wheel does not crimp the line, we must use the extension cord of the hand. When 15 cm to 20 cm from the right side of the steering wheel, it still does not overlap with the ground marker.
Many people think that just looking at the wipers will do. After the reaction of many netizens, if the models are different, it is not accurate to look at the wipers alone!
-
The method of judging the position of the left and right wheels is as follows: 1. When judging the position of the left wheel of the car, through the position of the wiper node and the ground centerline, when the driver sees that the wiper node and the ground centerline coincide, it means that the left tire will be pressed at this time, and the flexible judgment of the running track of the left tire can avoid the potholes and stones on the road. 2. When judging the position of the right tire, when the driver's line of sight intersects with the target from the node of the right wiper, it means that the tire will press over the target line.
3. To judge whether the width can pass, first of all, there should be a rough judgment on the width of the road surface, and the speed should be slowed down when the road surface is narrow. Since the driver is located on the left side of the vehicle, the distance between the left side is definitely more relaxed than the right side, and the vehicle can be appropriately attached to the left. When the vehicle is close to the wrong point, observe the obstacles on both sides to determine whether the left and right wheels can pass.
Of course, unlike the comparison lane marking, the width of the rearview mirrors on both sides should also be taken into account, and some errors in judgment should also be reserved.
-
Position of the left and right wheels:
1. When the driver sees that the wiper node and the ground centerline coincide, it means that the left tire will be pressed at this time, and the flexible judgment of the running track of the left tire can avoid the potholes and stones on the road;
2. When judging the position of the right tire, when the driver's line of sight intersects with the target from the node of the right wiper, it means that the tire will press over the target line.
3. When the driver's line of sight is combined with the center line of the road crack through the intersection of the cotton board and the A-pillar, it means that the body is exactly 60 cm away from the center line at this moment.
-
Judgment method: When going straight, feel that the position of the left thumb is the center of the left front wheel; Feel that the right thumb position is the center of the right front wheel.
When the line of sight coincides with the object on the ground through the node of the protrusion of the left wiper, our left wheel will press over the object when it is moving.
Determine the position of the right wheel, and when the line of sight intersects with the target through the right wiper, the tire will press over the target.
This requires more experience in daily driving, usually read more and remember more questions, in fact, driving is a skilled kung fu.
Look at the wipers. Or under the windshield is the front bumper. >>>More
The right brain has functions such as painting, spatial geometry, imagination, and synthesis. The right brain is called the genius brain, and it has a strong memory, imagination, and innovation skills, as well as inspiration and intuition. These abilities come from the right brain, and the right brain has 1 million times the memory power of the left brain! >>>More
The following points should be considered when placing the left and right positions of the parents' portraits: >>>More
The first step is to put on roller skating equipment, and it is best for novices to prepare a carpet (novices are not easy to fall when practicing on the carpet, and shoes are not easy to slide back and forth due to the resistance of the blanket). >>>More