How does Peugeot Citroen check engine oil?

Before the cold start or after waiting for 30 minutes for the hot car (cold start means stopping for more than 4 hours), the vehicle is parked on a flat road, the engine compartment cover is opened, the oil dipstick is pulled out, first wiped clean with a paper towel, then put it in and pull it out again, and observe the oil level at an oblique downward position of 45° (both sides need to be observed); The liquid level should be located between the upper and lower lines (the middle line position is optimal).

Open the hood, find the dipstick, pull out, 1 2 cm above the bottom hole is optimal.

This is a technical problem, the ruler is fine, but it is not so clear when looking at the oil level. The landlord wiped the oil dipstick clean before the test, and then went to the test.

Hello, wipe the oil dipstick first, just plug in the engine to measure, there is no better trick.

Hello, if you just pick it up and can't see clearly, it is recommended to find a clean cloth to wipe the scale on the oil dipstick.

Hello, park your vehicle on flat ground. Open the front cover of the engine and pull out the dipstick. The specific amount of oil between the upper and lower engraved lines of the oil dipstick shall prevail.

This dipstick is all scaled, in the lower part of the dipstick, there are two lines, the upper is the upper scale, the lower is the lower scale.

Hello, you can wipe it several times with gasoline, so that the clarity is higher, and the engine is stopped for half an hour and then measured the most accurately.

Hello, the dipstick that just took out must be unclear, use a cloth or just wipe it.

Under normal circumstances, the engine oil tank of the vehicle has an oil ruler, and the oil flow rate can be checked by looking at the oil level of the oil ruler.

Citroen DS3 screen display please check the oil level, it is possible that the oil consumption of the car is relatively large, resulting in the oil level is too low, it is recommended to check the oil scale of the car.

Turn off the key, press and hold the button on the meter, there are three zeros, open the key, and the meter will appear. A numeric value from ten to zero. When there is no value, release the button.

Re-close the key at on. See if there is any change, if there is no change, just change it again. [If you have a problem with the car, ask the car master.]

4S shop professional technician, 10 minutes to solve. 】

Hello, as long as the night sensor and line are fine, the car will not be alarmed if you park it for a day. It has a memory function. Hope it helps. Thank you [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

See if there is a signal from the pressure sensor plug! There is a signal that the level sensor is broken [There is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Then check whether the amount of oil is missing, and if it is missing, you can add it. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Determine if the oil is missing, if not, check the probability, oil pressure sensor [If there is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Check if there is a lack of oil [There is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Hello, Press and hold the key on the right side of the dashboard (don't screw the key to power on first) Press and hold the right button to power on, display the countdown, to = 0, turn off the power, release the right button, turn on the power, there is no more, I hope to get your support, I wish you a happy life. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Peugeot 3008 displacement, engine model EP6CDT, model 12 10-present, suitable for Hu711 51X oil filter, please carefully check whether the information of your car matches, German MAN brand filter HU711

Peugeot 3008 displacement, engine model EP6CDT, suitable for Hu711 51X oil filter, first of all, please carefully check whether the information of your car matches, and then press and hold the maintenance button. Insert the key until the light is on, and let go of the maintenance button when you hear the sound. Don't move the key, just press and hold the minute button next to the meter.

Check if the oil is enough, if it is. Just go to the repair point and use the decoder to make it clear.

Park your car on a level road and check the oil level 10 minutes after the engine has been turned off.

The liquid level can be within the range of the dipstick line.